[PATCH 3/7] UART: OMAP: fix software flow control

Shubhrajyoti D
2012-04-16T15:06:57Z

From: Vikram Pandita <vikram.pandita@ti.com>

Software flow control register bits were not defined correctly.

Also clarify the IXON and IXOFF logic to reflect what userspace wants.

Cc: stable@vger.kernel.org
Cc: Govindraj.R <govindraj.raja@ti.com>
Signed-off-by: Vikram Pandita <vikram.pandita@ti.com>
Signed-off-by: Shubhrajyoti D <shubhrajyoti@ti.com>
---
arch/arm/plat-omap/include/plat/omap-serial.h | 4 ++--
drivers/tty/serial/omap-serial.c | 12 ++++++------
2 files changed, 8 insertions(+), 8 deletions(-)

diff --git a/arch/arm/plat-omap/include/plat/omap-serial.h b/arch/arm/plat-omap/include/plat/omap-serial.h
index b7fb6dc..6edc30a 100644
--- a/arch/arm/plat-omap/include/plat/omap-serial.h
+++ b/arch/arm/plat-omap/include/plat/omap-serial.h
@@ -42,10 +42,10 @@
#define OMAP_UART_WER_MOD_WKUP 0X7F

/* Enable XON/XOFF flow control on output */
-#define OMAP_UART_SW_TX 0x04
+#define OMAP_UART_SW_TX 0x8

/* Enable XON/XOFF flow control on input */
-#define OMAP_UART_SW_RX 0x04
+#define OMAP_UART_SW_RX 0x2

#define OMAP_UART_SYSC_RESET 0X07
#define OMAP_UART_TCR_TRIG 0X0F
diff --git a/drivers/tty/serial/omap-serial.c b/drivers/tty/serial/omap-serial.c
index 10e80bb..887d578 100644
--- a/drivers/tty/serial/omap-serial.c
+++ b/drivers/tty/serial/omap-serial.c
@@ -651,19 +651,19 @@ serial_omap_configure_xonxoff

/*
* IXON Flag:
- * Enable XON/XOFF flow control on output.
- * Transmit XON1, XOFF1
+ * Flow control for OMAP.TX
+ * OMAP.RX should listen for XON/XOFF
*/
if (termios->c_iflag & IXON)
- up->efr |= OMAP_UART_SW_TX;
+ up->efr |= OMAP_UART_SW_RX;

/*
* IXOFF Flag:
- * Enable XON/XOFF flow control on input.
- * Receiver compares XON1, XOFF1.
+ * Flow control for OMAP.RX
+ * OMAP.TX should send XON/XOFF
*/
if (termios->c_iflag & IXOFF)
- up->efr |= OMAP_UART_SW_RX;
+ up->efr |= OMAP_UART_SW_TX;

serial_out(up, UART_EFR, up->efr | UART_EFR_ECB);
serial_out(up, UART_LCR, UART_LCR_CONF_MODE_A);
--
1.7.4.1