messages from 2010-12-17 15:36:23 to 2011-03-05 02:00:03 UTC [more...]
[PATCH 0/7] OMAP2+: UART: runtime conversion + cleanup
2011-03-05 1:59 UTC (19+ messages)
` [PATCH 1/7] OMAP2+ : hwmod_data: update uart hwmod data
` [PATCH 2/7] OMAP2+: mux: Enable wakeup for wakeup enable requested pads
` [PATCH 3/7] OMAP2+: UART: Remove certain uart calls from sram_idle
` [PATCH 4/7] OMAP2+: UART: Remove uart clock handling code serial.c
` [PATCH 5/7] Serial: OMAP: add runtime pm support for omap-serial driver
` [PATCH 6/7] OMAP: Serial: Allow UART parameters to be configured from board file
` [PATCH 7/7] Serial: OMAP2+: Make the RX_TIMEOUT for DMA configurable for each UART
[PATCH 2/7] OMAP2+: mux: Enable wakeup for wakeup enable requested pads
2011-03-05 1:57 UTC (4+ messages)
(unknown)
2011-03-03 5:39 UTC
(unknown),
2011-03-01 23:47 UTC
(unknown),
2011-03-01 23:48 UTC
[smatch stuff] altera_uart: inconsistent checks for null
2011-03-01 8:10 UTC (4+ messages)
[PATCH 0/4] *** SUBJECT HERE ***
2011-02-28 8:31 UTC (29+ messages)
` [PATCH 1/4] tty: serial: altera_uart: Handle pdev->id == -1 in altera_uart_remove
` [PATCH 0/4] tty: serial: Updates for altera_uart driver
` [PATCH 2/4] tty: serial: altera_uart: Use port->regshift to store bus shift
` [PATCH 3/4] tty: serial: altera_uart: Add devicetree support
` [PATHV v2] "
` [Nios2-dev] "
` [PATCH 3/4 v3] "
` [PATCH 4/4] MAINTAINERS: Add myself as a maintainer for altera_uart/altera_jtaguart
` [Nios2-dev] "
[PATCH 0/5] tty: serial: Updates for altera_jtaguart driver
2011-02-28 8:26 UTC (18+ messages)
` [PATCH 1/5] tty: serial: altera_jtaguart: Don't use plain integer as NULL pointer
` [PATCH 2/5] tty: serial: altera_jtaguart: Remove unused function early_altera_jtaguart_setup
` [PATCH 3/5] tty: serial: altera_jtaguart: Support getting mapbase and IRQ from resources
` [PATCH 4/5] tty: serial: altera_jtaguart: Fixup type usage of port flags
` [PATCH 5/5] tty: serial: altera_jtaguart: Add device tree support
` [PATCH 5/5 v2] "
` [PATCH 5/5 v3] "
` [Nios2-dev] [PATCH 0/5] tty: serial: Updates for altera_jtaguart driver
Please i wait to hear from you urgently, it very important
2011-02-24 19:14 UTC
SC16is752 I2c driver
2011-02-23 8:15 UTC (4+ messages)
LAVA PCIe serial card problem
2011-02-22 22:15 UTC (3+ messages)
[RFC PATCH 0/6] Rework tty helpers to avoid need for file pointers
2011-02-22 19:47 UTC (10+ messages)
` [PATCH 1/6] tiocmget: kill off the passing of the struct file
` [PATCH 2/6] tiocmset: kill the file pointer argument
` [PATCH 3/6] tty: remove filp from the USB tty ioctls
` [PATCH 4/6] tty: now phase out the ioctl file pointer for good
` [PATCH 5/6] tty: add a helper for setting termios data from kernel side
` [PATCH 6/6] hci_ath: Fix the mess in this driver
[PATCH 2/2] serial: mfd: add a module parameter for setting each port's working mode
2011-02-22 7:28 UTC
[PATCH 1/2] serial: mfd: remove the TX full-empty interrupts workaround
2011-02-22 7:28 UTC
Newbie question: setting baudrate / managing FIFO
2011-02-18 20:24 UTC (4+ messages)
MAX3107 driver faulty
2011-02-18 14:00 UTC (3+ messages)
Re:9
2011-02-18 5:41 UTC
uart ops tx_empty lock
2011-02-12 16:11 UTC (2+ messages)
Hnzacfa Bndhvhpx T%RAN_
2011-02-10 2:32 UTC
[PATCH] serial: also set the uartclk value in resume after goes to highspeed
2011-02-09 3:35 UTC (4+ messages)
` [PATCH resend 1/2] "
` [PATCH resend 2/2] serial: change the divisor latch only when prescalar actually changed
[PATCH] drivers: char: hvc: add Blackfin JTAG console support
2011-02-05 1:45 UTC (7+ messages)
` [uclinux-dist-devel] "
` [PATCH v2] "
[PATCH] serial: change the divisor latch only when prescalar actually changed
2011-02-03 22:15 UTC (2+ messages)
[PATCH] serial: bfin_5xx: split uart RX lock from uart port lock to avoid deadlock
2011-02-03 22:05 UTC (5+ messages)
` [uclinux-dist-devel] "
[PATCH 1/2 v1] davinci: support disabling modem status interrupts on SOC UARTS
2011-02-01 20:53 UTC (7+ messages)
` [PATCH 2/2 v1] davinci: mityomapl138 platform: disable MS interrupts on UART1
[PATCH resend 2] Add sc16is7x2 driver
2011-01-31 21:34 UTC (6+ messages)
[PATCH RFC] serial-core: reset the console speed on resume
2011-01-30 3:15 UTC (4+ messages)
` [PATCH Resend] "
[PATCH 1/2] tty: serial: altera_uart: remove early_altera_uart_setup
2011-01-26 18:18 UTC (4+ messages)
` [PATCH 2/2] tty: serial: altera_uart: add devicetree support
Mainpine IQ Express Rev3 problems beginning 2.6.36
2011-01-25 15:57 UTC (10+ messages)
Reading more than 255 bytes at once
2011-01-25 14:52 UTC
[PATCH] serial/mrst_max3110: make buffer larger
2011-01-25 14:15 UTC
Transaction notice
2011-01-24 8:32 UTC
[PATCH] input: trackpoint: return proper error value
2011-01-21 7:36 UTC (2+ messages)
Uartlite - ulite_transmit
2011-01-20 8:08 UTC (17+ messages)
NS16550A should be aware of the uart_console() when goto high speed?
2011-01-19 2:29 UTC
[PATCH] input: ct82710c: return proper error code for ct82c710_open
2011-01-17 12:43 UTC (3+ messages)
JSM module patch
2011-01-13 17:43 UTC (2+ messages)
JSM module patch
2011-01-13 8:26 UTC
SC16IS7x2 driver
2011-01-12 15:04 UTC
[PATCH] serial: mfd: remove the timeout workaround for A0
2011-01-12 7:03 UTC
[RESEND PATCH] serial: samsung: fix device name
2011-01-12 6:15 UTC (7+ messages)
[PATCH] RS485 on Cris: use global value of TIOCSRS485
2011-01-06 16:58 UTC (3+ messages)
[PATCH 1/2] serial: Provide capability to disable modem status interrupts in 8250 driver
2011-01-04 14:10 UTC (4+ messages)
` [PATCH 2/2] davinci: Disable modem status (CTS) interrupts on UART1
Need to disable MSR interrupts in 8250 driver. Request for guidance
2011-01-04 0:07 UTC (3+ messages)
16550 IIR LSR out-of-sync in handle_port
2011-01-03 10:39 UTC
for sc16is752 driver
2010-12-22 6:02 UTC
Need software UART implementation
2010-12-20 16:15 UTC (2+ messages)
Re: about sc16is7x2 drivier
2010-12-20 10:20 UTC
Fw: about sc16is7x2 drivier
2010-12-20 10:03 UTC (2+ messages)
` "
sc16is7x2 driver bug (fix)
2010-12-17 15:36 UTC (2+ messages)
page: next (older) | prev (newer) | latest
- recent:[subjects (threaded)|topics (new)|topics (active)]
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).