messages from 2012-09-21 18:35:41 to 2012-10-11 19:20:21 UTC [more...]
[PATCH] serial: clps711x: reworked driver version
2012-10-11 19:20 UTC (4+ messages)
[RFT/PATCH] serial: omap: prevent resume if device is not suspended
2012-10-11 18:28 UTC (23+ messages)
[RFC 00/24] OMAP serial driver flow control fixes, and preparation for DMA engine conversion
2012-10-11 14:05 UTC (38+ messages)
` [RFC 01/24] SERIAL: omap: fix set_mctrl() breakage
` [RFC 02/24] SERIAL: omap: fix bit masks for software flow control
` [RFC 03/24] SERIAL: omap: remove setting of EFR SCD bit
` [RFC 04/24] SERIAL: omap: fix MCR TCRTLR bit handling
` [RFC 05/24] SERIAL: omap: no need to re-read EFR
` [RFC 06/24] SERIAL: omap: allow hardware assisted rts/cts modes to be disabled
` [RFC 07/24] SERIAL: omap: allow hardware assisted IXANY mode "
` [RFC 08/24] SERIAL: core: use local variable uport in uart_set_termios()
` [RFC 09/24] SERIAL: core: add hardware assisted s/w flow control support
` [RFC 10/24] SERIAL: core: add hardware assisted h/w "
` [RFC 11/24] SERIAL: core: add throttle/unthrottle callbacks for hardware assisted flow control
` [RFC 12/24] SERIAL: omap: fix "
` [RFC 13/24] SERIAL: omap: configure xon/xoff before setting modem control lines
` [RFC 14/24] SERIAL: omap: serial_omap_configure_xonxoff() contents into set_termios
` [RFC 15/24] SERIAL: omap: don't read back LCR/MCR/EFR
` [RFC 16/24] SERIAL: omap: simplify
` [RFC 17/24] SERIAL: omap: always set TCR
` [RFC 18/24] SERIAL: omap: move xon/xoff setting earlier
` [RFC 19/24] SERIAL: omap: simplify (2)
` [RFC 20/24] SERIAL: core: add xmit buffer allocation callbacks
` [RFC 21/24] SERIAL: omap: use tx buffer allocation API
` [RFC 22/24] SERIAL: omap: typesafe conversion from uart_port to uart_omap_port
` [RFC 23/24] SERIAL: omap: move driver private definitions and structures to driver
` [RFC 24/24] SERIAL: omap: remove OMAP_UART_SYSC_RESET and OMAP_UART_FIFO_CLR
[RESEND PATCH v3] serial/arc-uart: Add new driver
2012-10-11 8:43 UTC (2+ messages)
[PATCH] RFC: sched: Prevent wakeup to enter critical section needlessly
2012-10-10 14:02 UTC (6+ messages)
` [REPOST] "
New serial card development
2012-10-09 18:43 UTC
[tty:tty-next 9/39] drivers/staging/dgrp/dgrp_tty.c:3177 dgrp_tty_init() error: potential null dereference 'nd->nd_serial_ttdriver'
2012-10-09 18:42 UTC (3+ messages)
` [tty:tty-next 9/39] drivers/staging/dgrp/dgrp_tty.c:3177
[PATCH] tty: Use raw spin lock to protect RX flip buffer
2012-10-09 17:43 UTC (3+ messages)
` [PATCH-v2] "
[PATCH v2] serial: vt8500: fix possible memory leak in vt8500_serial_probe()
2012-10-08 2:35 UTC
[PATCH] serial: vt8500: fix possible memory leak in vt8500_serial_probe()
2012-10-08 1:03 UTC (2+ messages)
PL2303 Driver Issue
2012-10-07 14:47 UTC (2+ messages)
[PATCH 3/6] tty: atmel_serial: switch pm ops
2012-10-07 7:27 UTC
[PATCH v2] Add of helper for linux,stdout-path
2012-10-05 16:43 UTC (5+ messages)
` [PATCH 1/3] serial_core: Add helper for matching against linux,stdout-path
` [PATCH 2/3] serial: i.MX: Make console support non optional
` [PATCH 3/3] serial: i.MX: evaluate linux,stdout-path property
[PATCH] serial: sccnxp: Allows the driver to be compiled as a module
2012-10-05 16:37 UTC (2+ messages)
[PATCH v3] serial/8250/8250_early: Prevent rounding error in uartclk
2012-10-05 16:20 UTC (4+ messages)
[PATCH 15/16] ARM: OMAP: Move plat/omap-serial.h to linux/platform_data/serial-omap.h
2012-10-04 22:05 UTC
[PATCH] serial: i.MX: evaluate linux,stdout-path property
2012-10-04 13:12 UTC (3+ messages)
[PATCH v3] serial/arc-uart: Add new driver
2012-10-04 7:35 UTC
[PATCH] tty/serial/8250: Make omap hardware workarounds local to 8250.h
2012-10-03 23:51 UTC (3+ messages)
[PATCH 09/17] serial/8250: Limit the omap workarounds to omap1
2012-10-03 22:26 UTC (5+ messages)
[PATCH 1/3] serial: omap: Make context_loss_cnt signed
2012-10-03 11:54 UTC (3+ messages)
` [PATCH 2/3] serial: omap: Remove the default setting of special character
` [PATCH 3/3] serial: omap: Remove the hardcode serial_omap_console_ports array
[PATCH v2] serial/arc-uart: Add new driver
2012-10-03 7:10 UTC (3+ messages)
[PATCH] serial: samsung: use clk_prepare_enable and clk_disable_unprepare
2012-10-02 22:40 UTC
[PATCH] serial/arc-uart: Add new driver
2012-10-02 4:33 UTC (3+ messages)
[GIT PATCH] TTY patches for 3.7-rc1
2012-10-01 22:13 UTC (3+ messages)
[PATCH] tty/8250_early: Prevent rounding error in uartclk to baud ratio
2012-09-29 11:04 UTC (6+ messages)
[PATCH v2] serial/8250/8250_early: Prevent rounding error in uartclk to baud ratio
2012-09-28 15:00 UTC
[PATCH] tty/8250_early: Prevent rounding error in uartclk to baud ratio
2012-09-28 13:01 UTC (2+ messages)
[PATCH] tty: prevent unnecessary work queue lock checking on flip buffer copy
2012-09-27 16:53 UTC (11+ messages)
` [PATCH-v2] "
` [PATCH-v3] "
[tty:tty-next 36/40] kernel/debug/kdb/kdb_main.c:2839:4: warning: passing argument 2 of 'kdb_register_repeat' from incompatible pointer type
2012-09-27 2:59 UTC (10+ messages)
[PATCH v9 0/11] KGDB/KDB FIQ (NMI) debugger
2012-09-26 22:32 UTC (16+ messages)
` [PATCH 01/11] kernel/debug: Mask KGDB NMI upon entry
` [PATCH 02/11] kdb: Implement disable_nmi command
` [PATCH 03/11] kdb: Turn KGDB_KDB=n stubs into static inlines
` [PATCH 04/11] tty/serial/core: Introduce poll_init callback
` [PATCH 05/11] tty/serial/amba-pl011: Implement "
` [PATCH 06/11] tty/serial/amba-pl011: Quiesce interrupts in poll_get_char
` [PATCH 07/11] tty/serial: Add kgdb_nmi driver
` [PATCH 08/11] ARM: Move some macros from entry-armv to entry-header
` [PATCH 09/11] ARM: Add KGDB/KDB FIQ debugger generic code
` [PATCH 10/11] ARM: VIC: Add a couple of low-level FIQ management helpers
` [PATCH 11/11] ARM: versatile: Make able to use UART ports for KGDB FIQ debugger
[PATCH v3] serial: pl011: handle corruption at high clock speeds
2012-09-26 15:21 UTC
[PATCH 3/3] serial: pl011: allow very high baudrates
2012-09-26 10:04 UTC (12+ messages)
[PATCH v2] serial: pl011: handle corruption at high clock speeds
2012-09-26 8:50 UTC
[PATCH] RFC: serial: pl011: allow very high baudrates
2012-09-26 8:03 UTC (2+ messages)
[PATCH] tty: cleanup duplicate functions in tty_buffer
2012-09-25 11:28 UTC (6+ messages)
[PATCH v8 0/11] KGDB/KDB FIQ (NMI) debugger
2012-09-24 21:25 UTC (4+ messages)
[PATCH 1/2] serial: New serial driver SCCNXP
2012-09-24 17:26 UTC (4+ messages)
[PATCH 1/3] serial: sccnxp: Report actual baudrate back to core
2012-09-24 17:12 UTC (3+ messages)
` [PATCH 2/3] serial: sccnxp: Remove mask termios caps for SW flow control
` [PATCH 3/3] serial: sccnxp: Make 'default' choice in switch last
[tty:tty-next 10/16] fs/compat_ioctl.c:869:1: error: 'TIOCSRS485' undeclared here (not in a function)
2012-09-24 15:39 UTC (3+ messages)
` [PATCH] compat_ioctl: Avoid using undefined RS-485 IOCTLs
[PATCH] Powerpc 8xx CPM_UART setting MAXIDL register proportionaly to baud rate
2012-09-24 13:21 UTC (2+ messages)
[PATCH v3 0/2] winbond-cir: Fix initialization
2012-09-24 13:18 UTC (3+ messages)
[PATCH] Powerpc 8xx CPM_UART maxidl should not depend on fifo size
2012-09-24 6:20 UTC
[PATCH] Powerpc 8xx CPM_UART too many interrupts
2012-09-24 6:19 UTC
[PATCH v2] Powerpc 8xx CPM_UART desynchronisation
2012-09-24 6:17 UTC
[RFC 0/3] Move some ARM header files to more appropriate locations
2012-09-22 11:41 UTC (10+ messages)
` [RFC 1/3] ARM: move serial_sa1100.h header file to linux/platform_data
` [RFC 2/3] ARM: move udc_pxa2xx.h "
` [RFC 3/3] ARM/AVR32: get rid of serial_at91.h
[PATCH] serial: samsung: Add poll_get_char & poll_put_char
2012-09-22 6:22 UTC
[PATCH v2] serial: set correct baud_base for EXSYS EX-41092 Dual 16950
2012-09-22 0:04 UTC
Vizzini
2012-09-21 22:52 UTC (3+ messages)
[PATCH v2] serial: omap: fix the reciever line error case
2012-09-21 21:46 UTC (2+ messages)
page: next (older) | prev (newer) | latest
- recent:[subjects (threaded)|topics (new)|topics (active)]
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).