linux-serial.vger.kernel.org archive mirror
 help / color / mirror / Atom feed
 messages from 2014-06-09 22:35:41 to 2014-07-01 22:14:44 UTC [more...]

[PATCH 0/3] s/FOOTBRIDGE/ARCH_FOOTBRIDGE/
 2014-07-01 22:14 UTC  (3+ messages)
` [PATCH 1/3] serial: DC21285: depend on ARCH_FOOTBRIDGE instead of FOOTBRIDGE

[PATCH] serial: 8250_dw: support high baudrates if possible
 2014-07-01 22:02 UTC  (4+ messages)

[PATCH v2] serial: 8250_dw: support high baudrates if possible
 2014-07-01 15:15 UTC 

[PATCH] tty: serial: fsl_lpuart: add 32-bit register interface support
 2014-07-01  8:43 UTC 

I just hope this e-mail acct. is still in use?
 2014-06-30 19:10 UTC 

Dear Partner,
 2014-06-29 17:52 UTC 

[PATCH 0/3] Deterministic UART numbering on Samsung SoCs
 2014-06-26 12:02 UTC  (6+ messages)
` [PATCH 1/3] Documentation: devicetree: Update samsung UART bindings
` [PATCH 2/3] serial: samsung: Consider DT alias when probing ports
` [PATCH 3/3] ARM: dts: SAMSUNG: Add aliases of UART nodes

[PATCH 0/2] serial: amba-pl01x: Clean up patches
 2014-06-26 10:05 UTC  (3+ messages)
` [PATCH V2 1/2] serial: amba-pl011: Remove redundant label
` [PATCH V2 2/2] serial: amba-pl010: Use devres APIs

[PATCH 0/2] serial: amba-pl01x: Clean up patches
 2014-06-26  9:37 UTC  (6+ messages)
` [PATCH 1/2] serial: amba-pl011: Remove redundant label
` [PATCH 2/2] serial: amba-pl010: Use devres APIs

[PATCH v2 00/20] ARM: sunxi: Introduce Allwinner A23 (sun8i) support
 2014-06-25 16:41 UTC  (45+ messages)
` [PATCH v2 13/20] clk: sunxi: Add A23 specific compatible to sun6i-a31-apb0-gates-clk
  ` [PATCH v2 01/20] serial: 8250_dw: Add optional reset control support
  ` [PATCH v2 02/20] clk: sunxi: register clock gates with clkdev
  ` [PATCH v2 03/20] clk: sunxi: move "ahb_sdram" to protected clock list
  ` [PATCH v2 04/20] clk: sunxi: Fix gate indexing for sun6i-a31-apb0-gates
  ` [PATCH v2 05/20] clk: sunxi: Support factor clocks with N multiplier factor starting from 1
  ` [PATCH v2 06/20] clk: sunxi: Fix rate_recalc for sun6i PLL1
  ` [PATCH v2 07/20] clk: sunxi: Fix PLL6 calculation on sun6i
  ` [PATCH v2 08/20] ARM: sun6i: DT: Rename PLL6 to PLL6x2 and add fixed-factor-clock for PLL6
  ` [PATCH v2 09/20] clk: sunxi: Add sun6i MBUS clock support
  ` [PATCH v2 10/20] clk: sunxi: Add support for table-based divider clocks
  ` [PATCH v2 11/20] clk: sunxi: Add A23 clocks support
  ` [PATCH v2 12/20] clk: sunxi: Add A23 APB0 support to sun6i-a31-apb0-clk
              `  "
  ` [PATCH v2 14/20] pinctrl: sunxi: Add A23 PIO controller support
  ` [PATCH v2 15/20] pinctrl: sunxi: Add A23 R_PIO "
  ` [PATCH v2 16/20] mfd: sun6i-prcm: Add support for Allwinner A23 PRCM
  ` [PATCH v2 17/20] ARM: sunxi: Introduce Allwinner A23 support
        `  "
            ` Fwd: "
  ` [PATCH v2 18/20] ARM: sunxi: Add earlyprintk support using R_UART (sun6i/sun8i)
  ` [PATCH v2 19/20] ARM: sunxi: Add Allwinner A23 dtsi
  ` [PATCH v2 20/20] ARM: sun8i: dt: Add Ippo-q8h v5 support

PLEASE VIEW WONGA LOAN DETAILS
 2014-06-25 15:53 UTC 

[PATCH v2 REBASED 00/10] Generic earlyconsole for ARC UART Driver
 2014-06-25  4:38 UTC  (14+ messages)
` [PATCH v2 REBASED 01/10] serial/arc: use uart_console_write() helper
` [PATCH v2 REBASED 02/10] serial/arc: Refactor by referencing to uart_port where possible
` [PATCH v2 REBASED 03/10] serial/arc: Remove the workaround for legacy ISS
` [PATCH v2 REBASED 04/10] serial/arc: Use generic earlycon infrastructure
` [PATCH v2 REBASED 05/10] serial/arc: remove earlyprintk support and switch to earlycon
` [PATCH v2 REBASED 06/10] serial/arc: remove last remanants of platform data
` [PATCH v2 REBASED 07/10] serial/arc: inline the probe helper
` [PATCH v2 REBASED 08/10] ARC: [arcfpga] RIP early uart platform device stuff
` [PATCH v2 REBASED 09/10] serial/arc: Enable DT based earlycon
` [PATCH v2 REBASED 10/10] ARC: [arcfpga] stdout-path now suffices for earlycon/console

You've won a Prize
 2014-06-23 14:33 UTC 

[PATCH] serial: samsung: Remove redundant label
 2014-06-23  6:12 UTC  (2+ messages)

[GIT PULL] TTY/Serial fixes for 3.16-rc2
 2014-06-20 19:57 UTC 

[RFC v2 00/10] kgdb: NMI/FIQ support for ARM
 2014-06-20  0:36 UTC  (28+ messages)
` [RFC v3 0/9] "
  ` [RFC v3 1/9] arm: fiq: arbitrary mappings from IRQ to FIQ virqs
  ` [PATCH v4 00/13] kgdb: NMI/FIQ support for ARM
    ` [PATCH v4 01/13] arm: fiq: Add callbacks to manage FIQ routings
    ` [PATCH v4 02/13] arm: fiq: Allow EOI to be communicated to the intc
    ` [PATCH v4 03/13] irqchip: gic: Provide support for interrupt grouping
    ` [PATCH v4 04/13] irqchip: gic: Add support for FIQ management
    ` [PATCH v4 05/13] irqchip: gic: Remove spin locks from eoi_irq
    ` [PATCH v4 06/13] irqchip: vic: Add support for FIQ management
    ` [PATCH v4 07/13] ARM: Move some macros from entry-armv to entry-header
    ` [PATCH v4 08/13] ARM: Add KGDB/KDB FIQ debugger generic code
    ` [PATCH v4 09/13] serial: amba-pl011: Pass FIQ information to KGDB
    ` [PATCH v4 10/13] serial: asc: Add support for KGDB's FIQ/NMI mode
    ` [PATCH v4 11/13] serial: asc: Adopt readl_/writel_relaxed()
    ` [PATCH v4 12/13] serial: imx: clean up imx_poll_get_char()
    ` [PATCH v4 13/13] serial: imx: Add support for KGDB's FIQ/NMI mode

[RESEND PATCH V8 0/2] serial/uart/8250: Introduce tunable RX trigger I/F
 2014-06-19  7:55 UTC  (3+ messages)
` [RESEND PATCH V8 1/2] serial/uart: Introduce device specific attribute group to uart_port structure
` [RESEND PATCH V8 2/2] serial/uart/8250: Add tunable RX interrupt trigger I/F of FIFO buffers

9-bit mode
 2014-06-18  8:51 UTC 

Broken serial port
 2014-06-17 21:05 UTC  (3+ messages)

[PATCH 00/21] ARM: sunxi: Introduce Allwinner A23 (sun8i) support
 2014-06-17 14:18 UTC  (5+ messages)
` [PATCH 15/22] pinctrl: sunxi: Add A23 PIO controller support

[PATCH tty-next 00/22] tty/serial fixes for 3.17
 2014-06-17 11:58 UTC  (36+ messages)
` [PATCH tty-next 01/22] tty: Document locking for tty driver methods
` [PATCH tty-next 02/22] tty: Document locking for tty_port_close{,start,end}()
` [PATCH tty-next 03/22] tty: Document locking for tty_port_open()
` [PATCH tty-next 04/22] tty: Document locking for tty_port_block_til_ready()
` [PATCH tty-next 05/22] tty: Document locking for tty_port_hangup()
` [PATCH tty-next 06/22] tty: Move tty->closing from port lock critical section
` [PATCH tty-next 07/22] tty: ipwireless: Remove tty->closing abort from ipw_open()
` [PATCH tty-next 08/22] serial: Use UPF_* constants with struct uart_port flags
` [PATCH tty-next 09/22] tty: Remove tty_hung_up_p() tests from tty drivers' open()
` [PATCH tty-next 10/22] char: synclink: Remove WARN_ON for bad port count
` [PATCH tty-next 11/22] tty: Call hangup method in modern style
` [PATCH tty-next 12/22] tty: serial: Fix termios/port flags mismatch
` [PATCH tty-next 13/22] serial: blackfin: Fix CTS flow control
` [PATCH tty-next 14/22] tty: Remove tty_wait_until_sent_from_close()
` [PATCH tty-next 15/22] isdn: tty: Use private flag for ASYNC_CLOSING
` [PATCH tty-next 16/22] tty: mxser: Use tty->closing "
` [PATCH tty-next 17/22] tty: Remove ASYNC_CLOSING
` [PATCH tty-next 18/22] tty: Move tty hung up check from port->lock critical section
` [PATCH tty-next 19/22] serial: Style fix
` [PATCH tty-next 20/22] serial: Refactor uart_flush_buffer() from uart_close()
` [PATCH tty-next 21/22] serial: core: Remove superfluous ldisc flush "
` [PATCH tty-next 22/22] serial: Fix locking for uart driver set_termios() method

[PATCH] serial: samsung: Fix compile error with SERIAL_SAMSUNG_DEBUG
 2014-06-16 21:29 UTC  (5+ messages)

[PATCH] serial: 8250_dw: add ability to handle the peripheral clock
 2014-06-16 13:25 UTC 

[PATCH tty-next 1/2] serial: Fix IGNBRK handling
 2014-06-16 12:10 UTC  (2+ messages)
` [PATCH tty-next 2/2] tty: Correct INPCK handling

[PATCH RESEND] tty: serial: men_z135_uart: Wakeup UART after transmitting
 2014-06-16  5:33 UTC 

[PATCH] tty: serial: men_z135_uart: Wakeup UART after transmitting
 2014-06-13 18:27 UTC  (3+ messages)

[PATCH 0/9] Generic earlyconsole for ARC UART Driver
 2014-06-13 14:10 UTC  (12+ messages)
` [PATCH 1/9] serial/arc: use uart_console_write() helper
` [PATCH 2/9] serial/arc: Refactor by referencing to uart_port where possible
` [PATCH 5/9] serial/arc: remove earlyprintk support and switch to earlycon
` [PATCH 6/9] serial/arc: remove last remanants of platform data
` [PATCH 7/9] serial/arc: inline the probe helper
` [PATCH 8/9] ARC: [arcfpga] RIP early uart platform device stuff
  ` [PATCH 3/9] serial/arc: Remove the workaround for legacy ISS
  ` [PATCH 4/9] serial/arc: Use generic earlycon infrastructure
  ` [PATCH 9/9] serial/arc: Add DT based earlycon support

[PATCH] serial: 8250_dma: sync regions for device before transfer
 2014-06-13 13:05 UTC  (2+ messages)

[PATCH] tty/serial: fix 8250 early console option passing to regular console
 2014-06-12 17:52 UTC 

[PATCH v2 0/7] Generic serial earlycon
 2014-06-11 23:44 UTC  (15+ messages)
` [PATCH v2 3/7] tty/serial: convert 8250 to generic earlycon

[PATCH v2] serial: uart: add hw flow control support configuration
 2014-06-11 21:05 UTC  (4+ messages)

serial console does not wake from S3 suspend
 2014-06-10 12:30 UTC  (6+ messages)
` [PATCH 1/2] serial: core: Don't drop DTR if system console


This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).