messages from 2014-09-10 19:06:28 to 2014-09-23 14:49:20 UTC [more...]
[PATCH] serial: of-serial: add PM suspend/resume support
2014-09-23 14:49 UTC (2+ messages)
[PATCH v3 0/4] omap-serial high-speed fixes/improvements
2014-09-23 8:24 UTC (11+ messages)
` [PATCH 1/4] tty: omap-serial: pull out calculation from baud_is_mode16
` [PATCH 2/4] tty: omap-serial: prevent division by zero
` [PATCH 3/4] tty: omap-serial: use threaded interrupt handler
` [PATCH 4/4] tty: omap-serial: support setting of hardware flow control in dts
[PATCH] tty/serial: fix config dependencies for samsung serial
2014-09-23 8:07 UTC (6+ messages)
[PATCH v3] serial: 8250: Add Quark X1000 to 8250_pci.c
2014-09-23 7:58 UTC (2+ messages)
RS485: RTS pin logical level before/after sending
2014-09-23 7:56 UTC
[PATCH tty-next v2] serial: asc: Conditionally use readl_relaxed (COMPILE_TEST)
2014-09-23 7:31 UTC
[PATCH tty-next] serial: asc: Conditionally use readl_relaxed (COMPILE_TEST)
2014-09-22 14:16 UTC
[PATCH 00/16 v9] omap 8250 based uart + DMA
2014-09-22 9:28 UTC (55+ messages)
` [PATCH 01/16] tty: serial: 8250_core: allow to set ->throttle / ->unthrottle callbacks
` [PATCH 02/16] tty: serial: 8250_core: add run time pm
` [PATCH 03/16] tty: serial: 8250_core: read only RX if there is something in the FIFO
` [PATCH 04/16] tty: serial: 8250_core: use the ->line argument as a hint in serial8250_find_match_or_unused()
` [PATCH 05/16] tty: serial: 8250_core: remove UART_IER_RDI in serial8250_stop_rx()
` [PATCH 06/16] tty: serial: Add 8250-core based omap driver
` [PATCH 07/16] tty: serial: 8250_dma: handle error on TX submit
` [PATCH 08/16] tty: serial: 8250_dma: enqueue RX dma again on completion
` [PATCH 09/16] tty: serial: 8250_dma: Add a TX trigger workaround for AM33xx
` [PATCH 10/16] tty: serial: 8250_dma: optimize the xmit path due to UART_BUG_DMA_TX
` [PATCH 11/16] tty: serial: 8250_dma: keep own book keeping about RX transfers
` [PATCH 12/16] tty: serial: 8250_dma: handle the UART RDI event while DMA remains idle
` [PATCH 13/16] tty: serial: 8250_dma: add pm runtime
` [PATCH 14/16] arm: dts: am33xx: add DMA properties for UART
` [PATCH 15/16] arm: dts: dra7: "
` [PATCH 16/16] tty: serial: 8250: omap: add dma support
[PATCHv2] serial: 8250: Add Quark X1000 to 8250 PCI driver
2014-09-22 7:12 UTC (11+ messages)
[PATCH] serial/core: Initialize the console pm state
2014-09-22 6:30 UTC
HOW ARE YOU?
2014-09-22 1:13 UTC
[PATCH] tty: serial_mctrl_gpio: Fix COMPILE_TEST build for architectures with custom termios.h
2014-09-20 5:34 UTC
linux-next: Tree for Sep 19
2014-09-19 19:04 UTC
[PATCH 1/4] serial: mxs-auart: use mctrl_gpio helpers for handling modem signals (v2.2c)
2014-09-19 18:13 UTC (5+ messages)
` [PATCH 2/4] serial: mxs-auart: add interrupts for modem control lines
` [PATCH 3/4] serial: mxs-auart: enable PPS support
` [PATCH 4/4] serial: mxs-auart: add sysrq support
[PATCH 1/4] serial: mxs-auart: use mctrl_gpio helpers for handling modem signals (v2.2c)
2014-09-19 18:13 UTC (4+ messages)
` [PATCH 2/4] serial: mxs-auart: add interrupts for modem control lines
` [PATCH 3/4] serial: mxs-auart: enable PPS support
` [PATCH 4/4] serial: mxs-auart: add sysrq support
[PATCH 1/4] serial: mxs-auart: use mctrl_gpio helpers for handling modem signals (v2.2c)
2014-09-19 18:06 UTC (4+ messages)
` [PATCH 2/4] serial: mxs-auart: add interrupts for modem control lines
` [PATCH 3/4] serial: mxs-auart: enable PPS support
` [PATCH 4/4] serial: mxs-auart: add sysrq support
[RFC PATCH 00/10] drivers: PL011: add SBSA subset support
2014-09-19 12:40 UTC (12+ messages)
` [RFC PATCH 01/10] drivers: PL011: avoid potential unregister_driver call
` [RFC PATCH 02/10] drivers: PL011: refactor pl011_startup()
` [RFC PATCH 03/10] drivers: PL011: refactor pl011_shutdown()
` [RFC PATCH 04/10] drivers: PL011: refactor pl011_set_termios()
` [RFC PATCH 05/10] drivers: PL011: refactor pl011_probe()
` [RFC PATCH 06/10] drivers: PL011: replace UART_MIS reading with _RIS & _IMSC
` [RFC PATCH 07/10] drivers: PL011: move cts_event workaround into separate function
` [RFC PATCH 08/10] drivers: PL011: allow avoiding UART enabling/disabling
` [RFC PATCH 09/10] drivers: PL011: allow to supply fixed option string
` [RFC PATCH 10/10] drivers: PL011: add support for the ARM SBSA generic UART
[PATCH] serial: imx: fix throttle/unthrottle callbacks for hardware assisted flow control
2014-09-19 7:46 UTC (2+ messages)
[PATCH] serial: imx: terminate the RX DMA when the UART is suspending
2014-09-19 7:33 UTC
[PATCH] serial: imx: change the wait even to interruptiable
2014-09-19 7:42 UTC
[PATCH] serial: imx: fix throttle/unthrottle callbacks for hardware assisted flow control
2014-09-19 7:26 UTC
[PATCH v2] asm/uapi: Add definition of TIOC[SG]RS485
2014-09-19 7:18 UTC
[PATCH] asm/uapi: Add definition of TIOC[SG]RS485
2014-09-19 4:59 UTC (2+ messages)
[PATCH] Add-Quark-X1000-PCI-desc-clock-and-register-data
2014-09-19 2:47 UTC (2+ messages)
[PATCH] serial: cadence: Add generic earlycon support
2014-09-18 5:15 UTC (4+ messages)
[RFC 0/3] serial: sh-sci: SCIF FIFO exploitation
2014-09-17 16:49 UTC (5+ messages)
` [RFC 1/3] serial: sh-sci: consider DR (data ready) bit adequately
` [RFC 2/3] serial: sh-sci: exploit RX FIFOs better
` [RFC 3/3] serial: sh-sci: make RX FIFO trigger tunable via sysfs
[PATCH 1/1] Xilinx uartlite serial driver: Add lock in isr to avoid SMP race condition
2014-09-17 11:29 UTC (2+ messages)
[PATCH v3] tty: serial: men_z135_uart: Fix driver for changes in hardware
2014-09-17 10:54 UTC (2+ messages)
[PATCH 1/4] serial: mxs-auart: use mctrl_gpio helpers for handling modem signals (v2.2)
2014-09-17 9:50 UTC (5+ messages)
` [PATCH 2/4] serial: mxs-auart: add interrupts for modem control lines
` [PATCH 3/4] serial: mxs-auart: enable PPS support
` [PATCH 4/4] serial: mxs-auart: add sysrq support
[PATCH] tty: sc16is7xx: remove retval from gpiochip_remove()
2014-09-16 22:33 UTC (2+ messages)
[PATCH 3.4.x-stable] 8250_pci: fix warnings in backport of Broadcom TruManage support
2014-09-16 10:06 UTC (2+ messages)
[PATCH v2 0/9] ARM: meson: add preliminary support for MesonX/Meson6 SoCs
2014-09-16 9:06 UTC (17+ messages)
` [PATCH v2 1/9] ARM: meson: debug: add debug UART for earlyprintk support
` [PATCH v2 2/9] ARM: meson: documentation: add UART documentation
` [PATCH v2 3/9] ARM: meson: serial: add MesonX SoC on-chip uart driver
` [PATCH v2 7/9] ARM: meson: add basic support for MesonX SoCs
` [PATCH v2 4/9] ARM: meson: documentation: add timer documentation
` [PATCH v2 5/9] ARM: meson6: clocksource: add Meson6 timer support
` [PATCH v2 6/9] ARM: meson: documentation: add bindings documentation
` [PATCH v2 8/9] ARM: meson: dts: add basic Meson/Meson6/Meson6-atv1200 DTSI/DTS
` [PATCH v2 9/9] ARM: meson: update multi_v7_defconfig
[PATCH 1/2] serial: mxs-auart: use mctrl_gpio helpers for handling modem signals (v2.1)
2014-09-15 17:40 UTC (2+ messages)
[PATCH v2] tty: serial: men_z135_uart: Fix driver for changes in hardware
2014-09-15 6:47 UTC
[PATCH] m68k: AMIGA_BUILTIN_SERIAL should depend on TTY
2014-09-14 9:42 UTC
[GIT PULL] TTY/Serial patches for 3.17-rc5
2014-09-12 18:21 UTC
[PATCH] serial: mxs-auart: use mctrl_gpio helpers for handling modem signals (v2)
2014-09-12 18:16 UTC (3+ messages)
[PATCH] serial: mxs-auart: use mctrl_gpio helpers for handling modem signals
2014-09-12 15:36 UTC
[RFC] tty: Always allow tcflow(TCOON) to unwedge terminal
2014-09-11 15:50 UTC (10+ messages)
[RFC PATCH] serial: Emulate break using control characters
2014-09-11 13:37 UTC
[RFC PATCH] tty: serial: core: Only invoke ->start_tx() if there is data to send
2014-09-11 12:48 UTC (4+ messages)
[PATCH] serial: 8250_pci: remove rts_n override from Baytrail quirk
2014-09-11 12:26 UTC
[PATCH 3.17-rc3] serial: amba-pl011: Use container_of() to get uart_amba_port
2014-09-11 11:25 UTC (2+ messages)
[RFC] tty: Override and virtualize flow control for tty_send_xchar()
2014-09-10 21:10 UTC
[PATCH 00/26] tty/serial flow control fixes
2014-09-10 19:06 UTC (13+ messages)
` [PATCH v2 00/14] "
` [PATCH v2 01/14] serial: core: Document and assert lock requirements for irq helpers
` [PATCH v2 02/14] serial: core: Privatize modem status enable flags
` [PATCH v2 06/14] serial: bfin-uart: Fix auto CTS
` [PATCH v2 07/14] serial: core: Use spin_lock_irq() in uart_set_termios()
` [PATCH v2 08/14] tty: Convert tty_struct bitfield to ints
` [PATCH v2 09/14] tty: Serialize tty flow control changes with flow_lock
` [PATCH v2 10/14] tty: Move packet mode flow control notifications to pty driver
` [PATCH v2 11/14] tty: Serialize tcflow() with other tty flow control changes
` [PATCH v2 12/14] tty: Move and rename send_prio_char() as tty_send_xchar()
` [PATCH v2 13/14] tty: Hold termios_rwsem for tcflow(TCIxxx)
` [PATCH v2 14/14] tty: Workaround Alpha non-atomic byte storage in tty_struct
page: next (older) | prev (newer) | latest
- recent:[subjects (threaded)|topics (new)|topics (active)]
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).