messages from 2016-02-18 20:21:54 to 2016-03-01 20:23:40 UTC [more...]
[PATCH v5] serial: support for 16550A serial ports on LP-8x4x
2016-03-01 20:23 UTC (17+ messages)
` [PATCH v6] "
` [PATCH v7] "
` [PATCH v8] "
` [PATCH v9] "
[PATCH] serial: flush ldisc after hangup
2016-03-01 19:04 UTC (5+ messages)
[PATCH v3 0/7] ACPI: parse the DBG2 table
2016-03-01 18:26 UTC (22+ messages)
` [PATCH v3 1/7] of/serial: move earlycon early_param handling to serial
` [PATCH v3 2/7] ACPI: add definitions of DBG2 subtypes
` [PATCH v3 3/7] ACPI: genaralize iterating over subtables in ACPI_PROBE_TABLE()
` [PATCH v3 4/7] ACPI: parse DBG2 table
` [PATCH v3 5/7] ACPI: serial: implement earlycon on ACPI DBG2 port
` [PATCH v3 6/7] ACPI: enable ACPI_DBG2_TABLE on ARM64
` [PATCH v3 7/7] serial: pl011: add ACPI DBG2 serial port
[PATCH v4 0/4] ACPI: parse the SPCR table
2016-03-01 17:35 UTC (11+ messages)
` [PATCH v4 1/4] ACPI: parse SPCR and enable matching console
` [PATCH v4 2/4] ACPI: enable ACPI_SPCR_TABLE on ARM64
` [PATCH v4 3/4] ACPI: add definitions of DBG2 subtypes
` [PATCH v4 4/4] serial: pl011: use ACPI SPCR to setup 32-bit access
[PATCH v3 0/5] ACPI: parse the SPCR table
2016-03-01 15:24 UTC (28+ messages)
` [PATCH v3 1/5] ACPI: change __init to __ref for early_acpi_os_unmap_memory()
` [PATCH v3 2/5] ACPI: parse SPCR and enable matching console
[PATCH] tty: msm_serial: remove static clk rate setting in probe
2016-03-01 11:22 UTC
[PATCH v2] serial: imx: support RS-485 Rx disable on Tx
2016-02-29 12:34 UTC
[PATCH] serial: imx: support RS-485 Rx disable on Tx
2016-02-29 8:51 UTC (4+ messages)
[PATCH v1] serial: mctrl_gpio: Add missing module license
2016-02-29 8:49 UTC (4+ messages)
[PATCH v2 RESEND] tty: serial: Use GFP_ATOMIC instead of GFP_KERNEL in serial8250_em485_init()
2016-02-27 13:00 UTC
sc16is7xx: a lot of time is spend in sc16is7xx_port_irq
2016-02-26 19:00 UTC (8+ messages)
` [PATCH] tty: serial: sc16is7xx: use threaded interrupts instead of homegrow
[PATCH] serial: ifx6x60: avoid uninitialized variable use
2016-02-26 13:54 UTC (3+ messages)
[PATCH v3] tty/serial: at91: restore dynamic driver binding
2016-02-26 10:15 UTC
[PATCH v2] tty/serial: at91: restore dynamic driver binding
2016-02-25 17:24 UTC (5+ messages)
[PATCH v2 0/8] ACPI: parse the DBG2 table
2016-02-25 15:53 UTC (14+ messages)
` [PATCH v2 1/8] arm64: move acpi/dt decision earlier in boot process
` [PATCH v2 2/8] of/serial: move earlycon early_param handling to serial
` [PATCH v2 3/8] ACPI: add definitions of DBG2 subtypes
` [PATCH v2 4/8] ACPI: genaralize iterating over subtables in ACPI_PROBE_TABLE()
` [PATCH v2 5/8] ACPI: parse DBG2 table
` [PATCH v2 6/8] ACPI: serial: implement earlycon on ACPI DBG2 port
` [PATCH v2 7/8] ACPI: enable ACPI_DBG2_TABLE on ARM64
` [PATCH v2 8/8] serial: pl011: add ACPI DBG2 serial port
[PATCH] serial: sa1100: make sa1100_register_uart_fns a function
2016-02-25 14:33 UTC
[PATCH v3] tty: serial: 8250: add MOXA Smartio MUE boards support
2016-02-25 13:25 UTC (2+ messages)
[PATCH v2] serial: xuartps: Enable OF earlycon support
2016-02-25 13:04 UTC (3+ messages)
[PATCH V4 0/4] Transform Fintek PCIE driver from 8250 to MFD
2016-02-25 9:59 UTC (7+ messages)
` [PATCH V4 1/4] mfd: f81504-core: Add Fintek F81504/508/512 PCIE-to-UART/GPIO core support
` [PATCH V4 2/4] gpio: gpio-f81504: Add Fintek F81504/508/512 PCIE-to-UART/GPIO GPIOLIB support
` [PATCH V4 3/4] 8250: 8250_f81504: Add Fintek F81504/508/512 PCIE-to-UART/GPIO UART support
` [PATCH V4 4/4] serial: 8250_pci: Remove Fintek F81504/508/512 UART driver
[PATCH v4 00/12] Add support for the Armada 3700 SoC an mvebu ARM64 based
2016-02-25 0:47 UTC (3+ messages)
` [PATCH v4 12/12] arm64: defconfig: enable Armada 3700 related config
[PATCH 0/8] ACPI: parse the DBG2 table
2016-02-24 16:09 UTC (14+ messages)
` [PATCH 1/8] arm64: move acpi/dt decision earlier in boot process
` [PATCH 2/8] of/serial: move earlycon early_param handling to serial
` [PATCH 3/8] ACPI: add definitions of DBG2 subtypes
` [PATCH 4/8] ACPI: genaralize iterating over subtables in ACPI_PROBE_TABLE()
` [PATCH 5/8] ACPI: parse DBG2 table
` [PATCH 6/8] ACPI: serial: implement earlycon on ACPI DBG2 port
` [PATCH 7/8] ACPI: enable ACPI_DBG2_TABLE on ARM64
` [PATCH 8/8] serial: pl011: add ACPI DBG2 serial port
[PATCH 0/4] serial: omap: robustify for high speed transfers
2016-02-24 15:46 UTC (14+ messages)
[PATCH] tty/serial: at91: restore dynamic driver binding
2016-02-24 15:32 UTC (5+ messages)
[PATCH] tty/serial: at91: fix bad offset for UART timeout register
2016-02-23 15:33 UTC (2+ messages)
[PATCH v4 00/10] Support for Cortex-M Prototyping System
2016-02-23 15:32 UTC (13+ messages)
` [PATCH v4 01/10] dt-bindings: document the MPS2 timer bindings
` [PATCH v4 02/10] clockevents/drivers: add MPS2 Timer driver
` [PATCH v4 03/10] dt-bindings: document the MPS2 UART bindings
` [PATCH v4 04/10] serial: mps2-uart: add MPS2 UART driver
` [PATCH v4 05/10] serial: mps2-uart: add support for early console
` [PATCH v4 06/10] ARM: vexpress/mps2: introduce MPS2 platform
` [PATCH v4 07/10] ARM: configs: add MPS2 defconfig
` [PATCH v4 08/10] ARM: dts: introduce MPS2 AN385/AN386
` [PATCH v4 09/10] ARM: dts: introduce MPS2 AN399/AN400
` [PATCH v4 10/10] MAINTAINERS: Update ARM Versatile Express platform entry
[PATCH 0/7] PM runtime regression fixes for omaps
2016-02-22 17:54 UTC (8+ messages)
` [PATCH 1/7] mmc: omap_hsmmc: Fix PM regression with deferred probe for pm_runtime_reinit
[PATCH v2] tty: serial: 8250: add MOXA Smartio MUE boards support
2016-02-22 9:15 UTC (2+ messages)
[PATCH v5] serial: rewrite pxa2xx-uart to use 8250_core
2016-02-22 7:17 UTC (5+ messages)
` [PATCH v6] "
[PATCHv2] serial: samsung: drop the spinlock around uart_write_wakeup
2016-02-22 3:31 UTC (7+ messages)
[PATCH] serial: samsung: fix the inconsistency in spinlock
2016-02-21 1:30 UTC (10+ messages)
[PATCH v3 00/10] Support for Cortex-M Prototyping System
2016-02-19 16:27 UTC (8+ messages)
` [PATCH v3 05/10] serial: mps2-uart: add support for early console
[PATCH v1] tty: serial: Use GFP_ATOMIC instead of GFP_KERNEL in serial8250_em485_init()
2016-02-19 11:53 UTC (6+ messages)
[PATCH v2] tty: serial: Use GFP_ATOMIC instead of GFP_KERNEL in serial8250_em485_init()
2016-02-19 5:29 UTC
page: next (older) | prev (newer) | latest
- recent:[subjects (threaded)|topics (new)|topics (active)]
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).