messages from 2017-05-13 07:29:00 to 2017-05-25 20:22:13 UTC [more...]
CPU_BIG_ENDIAN in generic code (was: Re: [PATCH v3 3/7] arch/sparc: Define config parameter CPU_BIG_ENDIAN)
2017-05-25 20:22 UTC (8+ messages)
[PATCH v6 net-next 00/17] net: qualcomm: add QCA7000 UART driver
2017-05-25 17:13 UTC (31+ messages)
` [PATCH v6 net-next 01/17] net: qualcomm: remove unnecessary includes
` [PATCH v6 net-next 02/17] net: qca_framing: use u16 for frame offset
` [PATCH v6 net-next 03/17] net: qca_7k: Use BIT macro
` [PATCH v6 net-next 04/17] net: qca_spi: Use SET_NETDEV_DEV()
` [PATCH v6 net-next 05/17] net: qualcomm: use net_device_ops instead of direct call
` [PATCH v6 net-next 06/17] net: qualcomm: Improve readability of length defines
` [PATCH v6 net-next 07/17] net: qca_spi: remove QCASPI_MTU
` [PATCH v6 net-next 08/17] net: qualcomm: move qcaspi_tx_cmd to qca_spi.c
` [PATCH v6 net-next 09/17] net: qca_spi: Clarify MODULE_DESCRIPTION
` [PATCH v6 net-next 10/17] net: qualcomm: rename qca_framing.c to qca_7k_common.c
` [PATCH v6 net-next 11/17] net: qualcomm: prepare frame decoding for UART driver
` [PATCH v6 net-next 12/17] net: qualcomm: make qca_7k_common a separate kernel module
` [PATCH v6 net-next 13/17] dt-bindings: qca7000-spi: Rework binding
` [PATCH v6 net-next 14/17] dt-bindings: qca7000: rename binding
` [PATCH v6 net-next 15/17] dt-bindings: slave-device: add current-speed property
` [PATCH v6 net-next 16/17] dt-bindings: qca7000: append UART interface to binding
` [PATCH v6 net-next 17/17] net: qualcomm: add QCA7000 UART driver
` [PATCH v7 "
` [PATCH RESEND "
` Aw: Re: [PATCH v6 "
[PATCH 1/1] xilinx ps uart: Adding a kernel parameter for the number of xilinx ps uarts
2017-05-25 15:33 UTC (13+ messages)
[BUG] tty/serial: stty hangs for 30 seconds after interrupted transfer
2017-05-25 13:43 UTC (2+ messages)
[PATCH V1] serial: imx: revert setup DCEDTE early and ensure DCD and RI irqs to be off
2017-05-24 16:08 UTC (15+ messages)
[PATCH] serial: 8250_of: Add reset support
2017-05-24 8:18 UTC (2+ messages)
gpio-exar: Why filtering out Commtech devices?
2017-05-23 21:16 UTC (8+ messages)
[PATCH 0/2] Add basic support for Mediatek MT2712 SoC
2017-05-23 15:01 UTC (5+ messages)
` [PATCH 1/2] Document: DT: Add bindings for Mediatek MT2712 SoC Platform
` [PATCH 2/2] arm64: dts: Add Mediatek SoC MT2712 and evaluation board dts and Makefile
[PATCH v3 0/4] tty/serial: meson_uart: add support for core clock handling
2017-05-23 8:37 UTC (2+ messages)
[PATCH V2 0/6] tty: serial: lpuart: add imx7ulp support
2017-05-23 5:24 UTC (31+ messages)
` [PATCH V2 1/6] tty: serial: lpuart: introduce lpuart_soc_data to represent SoC property
` [PATCH V2 2/6] tty: serial: lpuart: add little endian 32 bit register support
` [V2, "
` [PATCH V2 3/6] dt-bindings: serial: fsl-lpuart: add i.MX7ULP support
` [PATCH V2 4/6] tty: serial: lpuart: add imx7ulp support
` [PATCH V2 5/6] tty: serial: lpuart: add earlycon support for imx7ulp
` [PATCH V2 6/6] tty: serial: lpuart: add a more accurate baud rate calculation method
[PATCH v2 0/6] serial/gpio: exar: Fixes and support for IOT2000
2017-05-22 17:04 UTC (25+ messages)
` [PATCH v2 1/6] gpio: exar: Fix passing in of parent PCI device
` [PATCH v2 2/6] gpio: exar: Allocate resources on behalf of the platform device
` [PATCH v2 3/6] gpio: exar: Fix iomap request
` [PATCH v2 4/6] gpio: exar: Fix reading of directions and values
` [PATCH v2 5/6] gpio-exar/8250-exar: Make set of exported GPIOs configurable
` [PATCH v2 6/6] serial: exar: Add support for IOT2040 device
[PATCH 0/8] serial/gpio: exar: Fixes and support for IOT2000
2017-05-22 15:39 UTC (27+ messages)
` [PATCH 1/8] serial: exar: Preconfigure xr17v35x MPIOs as output
` [PATCH 2/8] gpio: exar: Fix passing in of parent PCI device
` [PATCH 3/8] gpio: exar: Allocate resources on behalf of the platform device
` [PATCH 4/8] gpio: exar: Fix iomap request
` [PATCH 5/8] gpio: exar: Fix reading of directions and values
` [PATCH 6/8] serial: uapi: Add support for bus termination
` [PATCH 7/8] gpio-exar/8250-exar: Make set of exported GPIOs configurable
` [PATCH 8/8] serial: exar: Add support for IOT2040 device
[PATCH] serial: meson: hide an unused function
2017-05-22 13:37 UTC
[PATCH] serial: sh-sci: Update warning message in sci_request_dma_chan()
2017-05-22 13:15 UTC
[PATCH] serial: of_serial: remove NULL pointer check for clk_disable_unprepare
2017-05-20 19:04 UTC (2+ messages)
[PATCH] serial: 8250: Add CAP_MINI, set for bcm2835aux
2017-05-19 18:09 UTC (2+ messages)
[PATCH v5 00/17] net: qualcomm: add QCA7000 UART driver
2017-05-19 12:37 UTC (11+ messages)
` [PATCH v5 15/17] dt-bindings: qca7000: append UART interface to binding
` [PATCH v5 16/17] tty: serdev-ttyport: return actual baudrate from ttyport_set_baudrate
[PATCH v5 0/3] printk: fix double printing with earlycon
2017-05-18 15:49 UTC (11+ messages)
` [PATCH v9 3/3] "
[PATCH 0/4] serdev: fix broken lifetime assumptions
2017-05-18 15:39 UTC (7+ messages)
` [PATCH 3/4] tty/serdev: add serdev registration interface
[PATCH v2 0/2] serdev: fix broken lifetime assumptions
2017-05-18 15:33 UTC (3+ messages)
` [PATCH v2 1/2] tty/serdev: add serdev registration interface
` [PATCH v2 2/2] serial: enable serdev support
[PATCH-stable] serial: samsung: Bring back removed variable to fix compilation
2017-05-18 13:16 UTC (4+ messages)
[PATCH] serdev: Restore serdev_device_write_buf for atomic context
2017-05-17 12:46 UTC (9+ messages)
[PATCH] imx-serial: RX DMA startup latency
2017-05-17 10:04 UTC (2+ messages)
[PATCH] serial: meson: add Magic SysRq support
2017-05-16 8:00 UTC (2+ messages)
[PATCH] serial: exar: Fix stuck MSIs
2017-05-14 11:32 UTC (8+ messages)
` [PATCH v2] "
[PATCH] serial: altera_jtaguart: adding iounmap()
2017-05-13 11:00 UTC (2+ messages)
page: next (older) | prev (newer) | latest
- recent:[subjects (threaded)|topics (new)|topics (active)]
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).