messages from 2017-05-23 13:12:53 to 2017-06-07 23:07:20 UTC [more...]
CPU_BIG_ENDIAN in generic code (was: Re: [PATCH v3 3/7] arch/sparc: Define config parameter CPU_BIG_ENDIAN)
2017-06-07 23:07 UTC (17+ messages)
[PATCH v3] serial: 8250_of: Add reset support
2017-06-07 20:10 UTC (2+ messages)
[PATCH v4 00/28] ARM: Initial Actions Semi S500 and S900 enablement
2017-06-07 14:37 UTC (6+ messages)
` [PATCH v4 08/28] dt-bindings: serial: Document Actions Semi Owl UARTs
` [PATCH v4 09/28] tty: serial: Add Actions Semi Owl UART earlycon
` [PATCH v4 16/28] tty: serial: owl: Implement console driver
[PATCH] Fix serial console on SNI RM400 machines
2017-06-07 13:47 UTC (2+ messages)
[PATCH 0/9] tty: drop broken alt-speed handling
2017-06-07 9:53 UTC (13+ messages)
` [PATCH 1/9] serial: rate limit custom-speed deprecation notice
` [PATCH 2/9] USB: serial: ftdi_sio: simplify TIOCSSERIAL flag logic
` [PATCH 3/9] USB: serial: ftdi_sio: remove broken alt-speed handling
` [PATCH 4/9] tty: simserial: drop unused alt_speed handling
` [PATCH 5/9] tty: amiserial: drop broken alt-speed support
` [PATCH 6/9] tty: cyclades: "
` [PATCH 7/9] tty: rocket: "
` [PATCH 8/9] tty: ircomm: remove dead and broken ioctl code
` [PATCH 9/9] tty: drop unused alt_speed from tty_struct
[PATCH v5 0/3] printk: fix double printing with earlycon
2017-06-07 9:13 UTC (13+ messages)
` [PATCH v9 3/3] "
[GIT PULL] TTY fix for 4.12-rc4
2017-06-04 15:41 UTC
[RFC, PATCH] imx: serial: Take tty->files_lock opportunistically
2017-06-03 9:30 UTC (5+ messages)
[PATCH 0/6] tty: serial: lpuart: add imx7ulp support
2017-06-02 17:11 UTC (5+ messages)
` [PATCH 6/6] tty: serial: lpuart: add a more accurate baud rate calculation method
[PATCH v5 00/11] serial/gpio: exar: Fixes and support for IOT2000
2017-06-02 10:32 UTC (13+ messages)
` [PATCH v5 01/11] serial: exar: Leave MPIOs as output for Commtech adapters
` [PATCH v5 02/11] gpio-exar/8250-exar: Do not even instantiate a GPIO device for Commtech cards
` [PATCH v5 03/11] gpio-exar/8250-exar: Fix passing in of parent PCI device
` [PATCH v5 04/11] gpio: exar: Allocate resources on behalf of the platform device
` [PATCH v5 05/11] gpio: exar: Fix iomap request
` [PATCH v5 06/11] gpio: exar: Fix reading of directions and values
` [PATCH v5 07/11] gpio-exar/8250-exar: Rearrange gpiochip parenthood
` [PATCH v5 08/11] serial: exar: Factor out platform hooks
` [PATCH v5 09/11] platform: Accept const properties
` [PATCH v5 10/11] gpio-exar/8250-exar: Make set of exported GPIOs configurable
` [PATCH v5 11/11] serial: exar: Add support for IOT2040 device
[GIT PULL] TTY/Serial driver fixes for 4.11-rc4
2017-06-02 0:06 UTC (16+ messages)
[PATCH v4 0/9] serial/gpio: exar: Fixes and support for IOT2000
2017-05-31 18:02 UTC (16+ messages)
` [PATCH v4 1/9] serial: exar: Leave MPIOs as output for Commtech adapters
` [PATCH v4 2/9] gpio-exar/8250-exar: Do not even instantiate a GPIO device for Commtech cards
` [PATCH v4 3/9] gpio-exar/8250-exar: Fix passing in of parent PCI device
` [PATCH v4 4/9] gpio: exar: Allocate resources on behalf of the platform device
` [PATCH v4 5/9] gpio: exar: Fix iomap request
` [PATCH v4 6/9] gpio: exar: Fix reading of directions and values
` [PATCH v4 7/9] gpio-exar/8250-exar: Rearrange gpiochip parenthood
` [PATCH v4 8/9] gpio-exar/8250-exar: Make set of exported GPIOs configurable
` [PATCH v4 9/9] serial: exar: Add support for IOT2040 device
[PATCH v2 0/2] Add basic support for Mediatek MT2712 SoC
2017-05-31 12:42 UTC (5+ messages)
` [PATCH v2 1/2] dt-bindings: arm: Add bindings for Mediatek MT2712 SoC Platform
` [PATCH v2 2/2] arm64: dts: Add Mediatek SoC MT2712 and evaluation board dts and Makefile
[PATCH V2 2/6] tty: serial: lpuart: add little endian 32 bit register support
2017-05-31 8:07 UTC (17+ messages)
` [V2, "
[PATCH v3 00/10] serial/gpio: exar: Fixes and support for IOT2000
2017-05-31 0:01 UTC (29+ messages)
` [PATCH v3 01/10] serial: exar: Leave MPIOs as output for Commtech adapters
` [PATCH v3 02/10] gpio-exar/8250-exar: Do not even instantiate a GPIO device for Commtech cards
` [PATCH v3 03/10] gpio-exar/8250-exar: Fix passing in of parent PCI device
` [PATCH v3 04/10] gpio: exar: Allocate resources on behalf of the platform device
` [PATCH v3 05/10] gpio: exar: Fix iomap request
` [PATCH v3 06/10] gpio: exar: Fix reading of directions and values
` [PATCH v3 07/10] gpio-exar/8250-exar: Rearrange gpiochip parenthood
` [PATCH v3 08/10] gpio: exar: Refactor address and bit calculations
` [PATCH v3 09/10] gpio-exar/8250-exar: Make set of exported GPIOs configurable
` [PATCH v3 10/10] serial: exar: Add support for IOT2040 device
[PATCH v8 net-next 00/17] net: qualcomm: add QCA7000 UART driver
2017-05-30 18:03 UTC (19+ messages)
` [PATCH v8 net-next 01/17] net: qualcomm: qca_7k: clean up header includes
` [PATCH v8 net-next 02/17] net: qca_framing: use u16 for frame offset
` [PATCH v8 net-next 03/17] net: qca_7k: Use BIT macro
` [PATCH v8 net-next 04/17] net: qca_spi: Use SET_NETDEV_DEV()
` [PATCH v8 net-next 05/17] net: qualcomm: use net_device_ops instead of direct call
` [PATCH v8 net-next 07/17] net: qca_spi: remove QCASPI_MTU
` [PATCH v8 net-next 08/17] net: qualcomm: move qcaspi_tx_cmd to qca_spi.c
` [PATCH v8 net-next 09/17] net: qca_spi: Clarify MODULE_DESCRIPTION
` [PATCH v8 net-next 10/17] net: qualcomm: rename qca_framing.c to qca_7k_common.c
` [PATCH v8 net-next 11/17] net: qualcomm: prepare frame decoding for UART driver
` [PATCH v8 net-next 12/17] net: qualcomm: make qca_7k_common a separate kernel module
` [PATCH v8 net-next 13/17] dt-bindings: qca7000-spi: Rework binding
` [PATCH v8 net-next 14/17] dt-bindings: qca7000: rename binding
` [PATCH v8 net-next 15/17] dt-bindings: slave-device: add current-speed property
` [PATCH v8 net-next 16/17] dt-bindings: qca7000: append UART interface to binding
` [PATCH v8 net-next 17/17] net: qualcomm: add QCA7000 UART driver
` [PATCH v8 net-next 06/17] net: qualcomm: Improve readability of length defines
[PATCH v2] serial: 8250_of: Add reset support
2017-05-29 9:57 UTC (3+ messages)
[GIT PULL] TTY/Serial fixes for 4.12-rc3
2017-05-27 10:01 UTC
[PATCH 0/8] serial/gpio: exar: Fixes and support for IOT2000
2017-05-26 18:38 UTC (5+ messages)
` [PATCH 1/8] serial: exar: Preconfigure xr17v35x MPIOs as output
[PATCH 0/2] Add basic support for Mediatek MT2712 SoC
2017-05-26 14:33 UTC (6+ messages)
` [PATCH 1/2] Document: DT: Add bindings for Mediatek MT2712 SoC Platform
` [PATCH 2/2] arm64: dts: Add Mediatek SoC MT2712 and evaluation board dts and Makefile
[PATCH] serial: uartps: Fix kernel doc warnings
2017-05-26 11:13 UTC
[PATCH] serial: 8250_of: Add reset support
2017-05-26 1:54 UTC (3+ messages)
[BUG] tty/serial: stty hangs for 30 seconds after interrupted transfer
2017-05-25 22:34 UTC (3+ messages)
[PATCH v6 net-next 00/17] net: qualcomm: add QCA7000 UART driver
2017-05-25 17:13 UTC (16+ messages)
` [PATCH v6 net-next 01/17] net: qualcomm: remove unnecessary includes
` [PATCH v6 net-next 17/17] net: qualcomm: add QCA7000 UART driver
` [PATCH v7 "
` [PATCH RESEND "
` Aw: Re: [PATCH v6 "
[PATCH 1/1] xilinx ps uart: Adding a kernel parameter for the number of xilinx ps uarts
2017-05-25 15:33 UTC (13+ messages)
[PATCH V1] serial: imx: revert setup DCEDTE early and ensure DCD and RI irqs to be off
2017-05-24 16:08 UTC (15+ messages)
gpio-exar: Why filtering out Commtech devices?
2017-05-23 21:16 UTC (8+ messages)
page: next (older) | prev (newer) | latest
- recent:[subjects (threaded)|topics (new)|topics (active)]
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).