messages from 2017-08-16 11:52:42 to 2017-09-19 09:29:12 UTC [more...]
[PATCH v2 0/9] Various patches for SAMA5D2 backup mode
2017-09-19 9:29 UTC (13+ messages)
` [PATCH v2 1/9] clk: at91: pmc: Wait for clocks when resuming
` [PATCH v2 2/9] clk: at91: pmc: Save SCSR during suspend
` [PATCH v2 3/9] clk: at91: pmc: Support backup for programmable clocks
` [PATCH v2 4/9] mtd: nand: atmel: Avoid ECC errors when leaving backup mode
` [PATCH v2 5/9] mtd: nand: atmel: Report PMECC failures as errors
` [PATCH v2 6/9] ehci-atmel: Power down during suspend is normal
` [PATCH v2 7/9] pwm: atmel-tcb: Support backup mode
` [PATCH v2 8/9] atmel_flexcom: "
` [PATCH v2 9/9] tty/serial: atmel: Prevent a warning on suspend
[PATCH] tty fix oops when rmmod 8250
2017-09-18 8:43 UTC (2+ messages)
[PATCH v2 3/6] serial: imx: remove CTSC and CTS handling
2017-09-15 20:57 UTC (2+ messages)
[PATCH] tty fix oops when rmmod 8250
2017-09-15 9:45 UTC
[PATCH v1 00/10] Various patches for SAMA5D2 backup mode
2017-09-14 16:15 UTC (21+ messages)
` [PATCH v1 01/10] clk: at91: pmc: Wait for clocks when resuming
` [PATCH v1 02/10] clk: at91: pmc: Save SCSR during suspend
` [PATCH v1 03/10] clk: at91: pmc: Support backup for programmable clocks
` [PATCH v1 04/10] mtd: nand: atmel: Avoid ECC errors when leaving backup mode
` [PATCH v1 05/10] mtd: nand: atmel: Report PMECC failures as errors
` [PATCH v1 06/10] ehci-atmel: Power down during suspend is normal
` [PATCH v1 07/10] iio:adc:at91-sama5d2: Support backup mode
` [PATCH v1 09/10] atmel_flexcom: "
` [PATCH v1 08/10] pwm: atmel-tcb: "
` [PATCH v1 10/10] tty/serial: atmel: Prevent a warning on suspend
[PATCH] tty: serial: make sport_uart_ops static and const
2017-09-13 20:04 UTC
[PATCH v5 1/7] serial: Add common rs485 device tree parsing function
2017-09-13 9:54 UTC (4+ messages)
` [PATCH v5 7/7] dt-bindings: serial: document rs485 bindings for various devices
[PATCH repost v2] serial: sh-sci: document R8A77970 bindings
2017-09-12 17:13 UTC (5+ messages)
[PATCH v2 1/2] mxser: fix timeout calculation for low rates
2017-09-12 10:39 UTC (2+ messages)
` [PATCH v2 2/2] mxser: remove unused parameters
[PATCH v10 0/4] ACPI: parse the SPCR table
2017-09-11 13:23 UTC (10+ messages)
` [PATCH v11 1/4] of/serial: move earlycon early_param handling to serial
` [PATCH v11 2/4] ACPI: parse SPCR and enable matching console
[RFC 0/3] ACPI serdev support
2017-09-09 18:50 UTC (18+ messages)
` [RFC 1/3] serdev: Add ACPI support
` [RFC 2/3] ACPI / scan: Fix enumeration for special UART devices
` [RFC 3/3] Bluetooth: hci_bcm: Add ACPI serdev support for BCM2E39
[patch v8 0/4] JTAG driver introduction
2017-09-08 19:51 UTC (6+ messages)
` [patch v8 1/4] drivers: jtag: Add JTAG core driver
` [patch v8 2/4] drivers: jtag: Add Aspeed SoC 24xx and 25xx families JTAG master driver
` [patch v8 3/4] Documentation: jtag: Add bindings for "
` [patch v8 4/4] Documentation: jtag: Add ABI documentation
[PATCH 1/2] mxser: fix timeout calculation for low rates
2017-09-08 13:36 UTC (2+ messages)
` [PATCH 2/2] mxser: remove unused parameters
[patch v7 0/4] JTAG driver introduction
2017-09-08 3:41 UTC (9+ messages)
` [patch v7 1/4] drivers: jtag: Add JTAG core driver
` [patch v7 2/4] drivers: jtag: Add Aspeed SoC 24xx and 25xx families JTAG master driver
` [patch v7 3/4] Documentation: jtag: Add bindings for "
` [patch v7 4/4] Documentation: jtag: Add ABI documentation
[PATCH] tty: xilinx_uartps: move to arch_initcall for earlier console
2017-09-07 6:10 UTC (6+ messages)
[PATCH v2] serial: meson: add Magic SysRq support
2017-09-06 13:52 UTC
[PATCH 0/8] MIPS: BCM63XX: add and use clkdev lookup support
2017-09-06 12:37 UTC (9+ messages)
` [PATCH 3/8] tty/bcm63xx_uart: use refclk for the expected clock name
` [PATCH 4/8] tty/bcm63xx_uart: allow naming clock in device tree
` [PATCH 6/8] bcm63xx_enet: just use "enet" as the clock name
[GIT PULL] TTY/Serial updates for 4.14-rc1
2017-09-04 16:41 UTC
[PATCH] serial: sccnxp: Fix error handling in sccnxp_probe()
2017-09-02 20:13 UTC
[PATCH v2] serial: sh-sci: document R8A77970 bindings
2017-09-01 22:11 UTC (2+ messages)
[PATCH v3] earlycon: initialise baud field of earlycon device structure
2017-08-31 13:33 UTC (2+ messages)
[PATCH][serial-next] serial: 8250: don't dereference em485 until it has been null checked
2017-08-29 20:22 UTC (4+ messages)
[patch v1 0/2] JTAG driver introduction
2017-08-28 20:03 UTC (5+ messages)
[PATCH 0/6] serdev multiplexing support
2017-08-28 12:55 UTC (10+ messages)
` [PATCH 1/6] serdev: add method to set parity
` [PATCH 2/6] serdev: add multiplexer support
` [PATCH 3/6] serial: core: support deferring serdev controller registration
` [PATCH 4/6] max9260: add driver for i2c over GMSL passthrough
` [PATCH 5/6] ARM: dts: blanche: add SCIF1 and MAX9260 deserializer
` [PATCH 6/6] dt-bindings: slave-device: add reg property
[PATCH] USB: serial: ti_usb_3410_5052: Port uart_mode from io_ti
2017-08-28 8:56 UTC (5+ messages)
[patch v6 0/3] JTAG driver introduction
2017-08-28 8:36 UTC (14+ messages)
` [patch v6 1/3] drivers: jtag: Add JTAG core driver
` [patch v6 2/3] drivers: jtag: Add Aspeed SoC 24xx and 25xx families JTAG master driver
` [patch v6 3/3] Doccumentation: jtag: Add bindings for "
[PATCH v2 0/2]
2017-08-28 5:21 UTC (6+ messages)
` [PATCH v2 1/2] dt-bindings: serial: 8250: Add MediaTek BTIF controller bindings
` [PATCH v2 RESEND "
` [PATCH v2 2/2] serial: 8250: of: Add new port type for MediaTek BTIF controller on MT7622/23 SoC
[PATCH] tty: serial: 8250_mtk: Use PTR_ERR_OR_ZERO
2017-08-27 18:49 UTC (2+ messages)
[PATCH] serial: sh-sci: document R8A7797 bindings
2017-08-25 7:09 UTC (2+ messages)
[PATCH] tty: xilinx_uartps: move to arch_initcall for earlier console
2017-08-24 5:55 UTC
[PATCH] serial: pl010: constify amba_id
2017-08-23 16:48 UTC (2+ messages)
` [PATCH] serial: pl011: "
[patch v5 0/3] JTAG driver introduction
2017-08-23 10:02 UTC (6+ messages)
` [patch v5 1/3] drivers: jtag: Add JTAG core driver
` [patch v5 2/3] drivers: jtag: Add Aspeed SoC 24xx and 25xx families JTAG master driver
` [patch v5 3/3] doccumentation: jtag: Add bindings for "
[PATCH v3] serial: 8250_of: Add basic PM runtime support
2017-08-23 8:15 UTC (6+ messages)
[PATCH v3 0/2] serial: 8250: add support for MediaTek BTIF controller
2017-08-23 0:34 UTC (5+ messages)
` [PATCH v3 1/2] dt-bindings: serial: 8250: Add MediaTek BTIF controller bindings
` [PATCH v3 2/2] serial: 8250: of: Add new port type for MediaTek BTIF controller on MT7622/23 SoC
Specifying console via "stdout-path" property
2017-08-22 18:10 UTC
[PATCH] dt-bindings: serial: sh-sci: Add support for r8a77995 (H)SCIF
2017-08-22 2:17 UTC (3+ messages)
[PATCH 3/4] tty: 8250: constify parisc_device_id
2017-08-19 17:54 UTC (2+ messages)
` [PATCH 4/4] tty: mux: "
[patch v3 2/3] drivers: jtag: Add Aspeed SoC 24xx and 25xx families JTAG master driver
2017-08-19 12:27 UTC (3+ messages)
[PATCH] serial: earlycon: Only try fdt when specify 'earlycon' exactly
2017-08-19 1:43 UTC
[patch v4 0/3] JTAG driver introduction
2017-08-18 9:49 UTC (4+ messages)
` [patch v4 1/3] drivers: jtag: Add JTAG core driver
` [patch v4 2/3] drivers: jtag: Add Aspeed SoC 24xx and 25xx families JTAG master driver
` [patch v4 3/3] doccumentation: jtag: Add bindings for "
[patch v3 0/3] JTAG driver introduction
2017-08-17 21:24 UTC (6+ messages)
` [patch v3 1/3] drivers: jtag: Add JTAG core driver
` [patch v3 3/3] doccumentation: jtag: Add bindings for Aspeed SoC 24xx and 25xx families JTAG master driver
[PATCH v2] earlycon: initialise baud field of earlycon device structure
2017-08-17 18:08 UTC
[PATCH repost] serial: sh-sci: use of_property_read_bool()
2017-08-17 13:00 UTC (2+ messages)
Race between release_tty() and vt_disallocate()
2017-08-17 12:11 UTC (4+ messages)
[PATCH] earlycon: initialise baud field of earlycon device structure
2017-08-16 15:26 UTC (5+ messages)
[RFC v2 0/6] serdev multiplexing support
2017-08-16 13:32 UTC (11+ messages)
` [RFC v2 3/6] serdev: add multiplexer support
` [RFC v2 5/6] max9260: add driver for i2c over GMSL passthrough
page: next (older) | prev (newer) | latest
- recent:[subjects (threaded)|topics (new)|topics (active)]
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).