messages from 2017-11-02 14:14:33 to 2017-11-27 12:28:22 UTC [more...]
[PATCH v2 00/35] Andes(nds32) Linux Kernel Port
2017-11-27 12:28 UTC (36+ messages)
` [PATCH v2 01/35] nds32: Assembly macros and definitions
` [PATCH v2 02/35] nds32: Kernel booting and initialization
` [PATCH v2 03/35] nds32: Exception handling
` [PATCH v2 04/35] nds32: MMU definitions
` [PATCH v2 05/35] nds32: MMU initialization
` [PATCH v2 06/35] nds32: MMU fault handling and page table management
` [PATCH v2 07/35] nds32: Cache and TLB routines
` [PATCH v2 08/35] nds32: Process management
` [PATCH v2 09/35] nds32: IRQ handling
` [PATCH v2 11/35] nds32: Device specific operations
` [PATCH v2 12/35] nds32: DMA mapping API
` [PATCH v2 13/35] nds32: ELF definitions
` [PATCH v2 14/35] nds32: System calls handling
` [PATCH v2 15/35] nds32: VDSO support
` [PATCH v2 16/35] nds32: Signal handling support
` [PATCH v2 17/35] nds32: Library functions
` [PATCH v2 18/35] nds32: Debugging support
` [PATCH v2 19/35] nds32: L2 cache support
` [PATCH v2 20/35] nds32: Loadable modules
` [PATCH v2 21/35] nds32: Generic timers support
` [PATCH v2 22/35] nds32: Device tree support
` [PATCH v2 24/35] nds32: defconfig
` [PATCH v2 10/35] nds32: Atomic operations
` [PATCH v2 23/35] nds32: Miscellaneous header files
` [PATCH v2 25/35] nds32: Build infrastructure
` [PATCH v2 26/35] dt-bindings: interrupt-controller: Andestech Internal Vector Interrupt Controller
` [PATCH v2 27/35] irqchip: Andestech Internal Vector Interrupt Controller driver
` [PATCH v2 28/35] MAINTAINERS: Add nds32
` [PATCH v2 29/35] dt-bindings: nds32 CPU Bindings
` [PATCH v2 30/35] net: faraday add nds32 support
` [PATCH v2 31/35] earlycon: add reg-offset to physical address before mapping
` [PATCH v2 32/35] asm-generic/io.h: move ioremap_nocache/ioremap_uc/ioremap_wc/ioremap_wt out of ifndef CONFIG_MMU
` [PATCH v2 33/35] clocksource/drivers/atcpit100: Add andestech atcpit100 timer
` [PATCH v2 34/35] clocksource/drivers/Kconfig: Support "
` [PATCH v2 35/35] dt-bindings: timer: Add andestech atcpit100 timer binding doc
[RFC v1 0/8] Realtek Bluetooth serdev support (H5 protocol)
2017-11-27 10:00 UTC (21+ messages)
` [RFC v1 1/8] serdev: implement parity configuration
` [RFC v1 2/8] Bluetooth: btrtl: add MODULE_FIRMWARE declarations
` [RFC v1 3/8] Bluetooth: btrtl: split the device initialization into smaller parts
` [RFC v1 4/8] Bluetooth: btrtl: add support for retrieving the UART settings
` [RFC v1 5/8] Bluetooth: btrtl: add support for the RTL8723BS and RTL8723DS chips
` [RFC v1 6/8] Bluetooth: hci_h5: add support for Realtek UART Bluetooth modules
` [RFC v1 7/8] Bluetooth: hci_serdev: remove the HCI_UART_INIT_PENDING check
` [RFC v1 8/8] dt-bindings: net: bluetooth: add support for Realtek Bluetooth chips
[PATCH][RFC] 8250_dw: unregister dw8250_set_termios for rk3188 chip
2017-11-24 17:06 UTC (12+ messages)
[PATCH 1/2] serial: 8250_fintek: Return -EINVAL on invalid configuration
2017-11-23 5:03 UTC (5+ messages)
` [PATCH 2/2] serial: 8250_fintek: Disable delays for ports != 0
[serial8250_interrupt] RIP: 0010:arch_local_irq_restore+0x2/0x8
2017-11-22 23:43 UTC (6+ messages)
[PATCH] Bluetooth: hci_bcm: Add support for BCM2E72
2017-11-22 13:37 UTC
[PATCH 1/2] serial: 8250_early: Only set divisor if valid clk & baud
2017-11-22 9:57 UTC (2+ messages)
` [PATCH 2/2] MIPS: Add custom serial.h with BASE_BAUD override for generic kernel
[PATCH 3.16 013/133] printk/console: Always disable boot consoles that use init memory before it is freed
2017-11-22 1:58 UTC
[PATCH][RFC] 8250_dw: unregister dw8250_set_termios for rk3188 chip
2017-11-20 14:49 UTC
[PATCH] serial: 8250_pci: Add Amazon PCI serial device ID
2017-11-19 8:41 UTC (5+ messages)
` [PATCH v2] "
[PATCH v5 1/1] tty: serial: imx: remove imx_disable_rx_int
2017-11-16 18:14 UTC
[PATCH v4 1/1] tty: serial: imx: remove imx_disable_rx_int
2017-11-16 7:30 UTC (2+ messages)
[PATCH 0/2] HSCIF tweaks support
2017-11-15 15:37 UTC (7+ messages)
` [PATCH 1/2] serial: sh-sci: Support for variable HSCIF hardware RX timeout
` [PATCH 2/2] serial: sh-sci: Support for HSCIF RX sampling point adjustment
[PATCH v2] serial: 8250: convert to threaded IRQ
2017-11-15 12:40 UTC
[patch v12 0/4] JTAG driver introduction
2017-11-14 16:11 UTC (5+ messages)
` [patch v12 1/4] drivers: jtag: Add JTAG core driver
` [patch v12 2/4] drivers: jtag: Add Aspeed SoC 24xx and 25xx families JTAG master driver
` [patch v12 3/4] Documentation: jtag: Add bindings for "
` [patch v12 4/4] Documentation: jtag: Add ABI documentation
[patch v11 0/4] JTAG driver introduction
2017-11-14 11:31 UTC (13+ messages)
` [patch v11 2/4] drivers: jtag: Add Aspeed SoC 24xx and 25xx families JTAG master driver
` [patch v11 1/4] drivers: jtag: Add JTAG core driver
` [v11,1/4] "
` [patch v11 3/4] Documentation: jtag: Add bindings for Aspeed SoC 24xx and 25xx families JTAG master driver
` [patch v11 4/4] Documentation: jtag: Add ABI documentation
[PATCH 0/3] MIPS: AR7: assorted fixes
2017-11-14 11:02 UTC (4+ messages)
` [PATCH RFC 3/3] MIPS: AR7: ensure the port type's FCR value is used
[GIT PULL] TTY/Serial patches for 4.15-rc1
2017-11-13 16:19 UTC
[PATCH 4.13 20/33] MIPS: AR7: Defer registration of GPIO
2017-11-13 12:56 UTC (2+ messages)
` [PATCH 4.13 21/33] MIPS: AR7: Ensure that serial ports are properly set up
[PATCH 4.9 74/87] MIPS: AR7: Defer registration of GPIO
2017-11-13 12:56 UTC (2+ messages)
` [PATCH 4.9 75/87] MIPS: AR7: Ensure that serial ports are properly set up
[PATCH 4.4 48/56] MIPS: AR7: Defer registration of GPIO
2017-11-13 12:56 UTC (2+ messages)
` [PATCH 4.4 49/56] MIPS: AR7: Ensure that serial ports are properly set up
[PATCH 3.18 25/28] MIPS: AR7: Ensure that serial ports are properly set up
2017-11-13 12:55 UTC
[PATCH] serial: 8250: convert to threaded IRQ
2017-11-12 19:14 UTC (2+ messages)
` [serial] b5c545ac2f: WARNING:inconsistent_lock_state
[PATCH] dt-bindings: serial: fsl-imx-uart: Remove 'fsl,irda-mode' property
2017-11-10 21:59 UTC (2+ messages)
[PATCH 0/5] rs485 properties: platform agnosticism + RTS polarity
2017-11-10 21:58 UTC (8+ messages)
` [PATCH 4/5] serial: fsl_lpuart: Support common rs485 binding for "
` [PATCH 3/5] serial: core: "
` [PATCH 5/5] serial: imx: "
` [PATCH 2/5] dt-bindings: serial: Add "
[PATCH v12 1/5] serdev: Make .remove in struct serdev_device_driver optional
2017-11-09 16:05 UTC (2+ messages)
` [PATCH v12 2/5] serdev: Introduce devm_serdev_device_open()
[PATCH V1 1/1] serial: 8250_fintek: Fix crash with baud rate B0
2017-11-08 17:34 UTC (2+ messages)
[PATCH v2] Devicetree documentation: add rs485-rts-active-high property
2017-11-08 6:11 UTC (2+ messages)
` [v2] "
[PATCH] tty: serial: jsm: remove redundant pointer ts
2017-11-07 12:53 UTC (2+ messages)
[RFC PATCH] earlycon: Search for uartclk provided by DT
2017-11-07 11:24 UTC
[PATCH v3 1/1] tty: serial: imx: remove imx_disable_rx_int
2017-11-07 9:50 UTC (2+ messages)
[PATCH] Devicetree documentation: add rs485-rts-active-high property
2017-11-07 7:36 UTC
[PATCH v11 1/5] serdev: Make .remove in struct serdev_device_driver optional
2017-11-06 15:29 UTC (2+ messages)
` [PATCH v11 2/5] serdev: Introduce devm_serdev_device_open()
[PATCH] tty: fix tty_ldisc_receive_buf() documentation
2017-11-06 13:57 UTC (3+ messages)
[PATCH 0/5] TTY/JSM coding style fixes
2017-11-06 13:16 UTC (7+ messages)
` [PATCH 1/5] tty: serial: jsm: change the type of local variable
` [PATCH 2/5] tty: serial: jsm: add blank line after declarations
` [PATCH 3/5] tty: serial: jsm: delete space between function name and '('
` [PATCH 4/5] tty: serial: jsm: fix coding style
` [PATCH 5/5] tty: serial: jsm: add space before the open parenthesis '('
[PATCH v10 1/5] serdev: Make .remove in struct serdev_device_driver optional
2017-11-05 22:19 UTC (6+ messages)
` [PATCH v10 2/5] serdev: Introduce devm_serdev_device_open()
[PATCH v5] tty: serial: meson: allow baud-rates lower than 9600
2017-11-05 19:36 UTC
[PATCH] tty: serial: meson: allow baud-rates lower than 9600
2017-11-05 19:35 UTC
[PATCH v4] tty: serial: meson: allow baud-rates lower than 9600
2017-11-05 19:34 UTC (4+ messages)
[PATCH v3] dt-bindings: mvebu-uart: update documentation with extended UART
2017-11-05 16:47 UTC (3+ messages)
[PATCH v3] tty: serial: meson: allow baud-rates lower than 9600
2017-11-05 7:21 UTC (5+ messages)
[PATCH v2 1/3] tty: serial: imx: disable ageing timer interrupt if dma in use
2017-11-04 11:39 UTC (3+ messages)
` [PATCH v2 3/3] tty: serial: imx: remove imx_disable_rx_int
[PATCH 0/8] serdev: receive_buf and locking fixes
2017-11-03 14:30 UTC (9+ messages)
` [PATCH 1/8] serdev: ttyport: add missing receive_buf sanity checks
` [PATCH 2/8] serdev: fix receive_buf return value when no callback
` [PATCH 3/8] serdev: document driver callbacks
` [PATCH 4/8] serdev: ttyport: fix NULL-deref on hangup
` [PATCH 5/8] serdev: ttyport: fix tty locking in close
` [PATCH 6/8] serdev: ttyport: release tty lock sooner on open
` [PATCH 7/8] serdev: ttyport: ignore carrier detect to avoid hangups
` [PATCH 8/8] serdev: ttyport: do not used keyed wakeup in write_wakeup
How to enable output to serial console at run-time?
2017-11-02 22:29 UTC (4+ messages)
Is 115200 still the maximum baudrate?
2017-11-02 18:44 UTC (3+ messages)
[PATCH] tty: max3100: remove unused variable rts and remove unused assignment
2017-11-02 14:36 UTC (5+ messages)
page: next (older) | prev (newer) | latest
- recent:[subjects (threaded)|topics (new)|topics (active)]
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).