messages from 2018-04-23 08:48:10 to 2018-05-10 15:44:22 UTC [more...]
[patch v19 0/4] JTAG driver introduction
2018-05-10 15:44 UTC (3+ messages)
` [patch v19 1/4] drivers: jtag: Add JTAG core driver
` [patch v19 2/4] drivers: jtag: Add Aspeed SoC 24xx and 25xx families JTAG master driver
[patch v18 0/4] JTAG driver introduction
2018-05-10 15:13 UTC (3+ messages)
[PATCH] serial: 8250_dw: Fix runtime PM handling
2018-05-10 14:13 UTC
[PATCH] tty: implement a rx led trigger
2018-05-10 11:25 UTC (11+ messages)
` [PATCH v2] tty: implement led triggers
[PATCH v3 0/3] led_trigger_register_format and tty triggers
2018-05-10 11:22 UTC (12+ messages)
` [PATCH v3 1/3] leds: triggers: provide led_trigger_register_format()
` [PATCH v3 2/3] can: simplify LED trigger handling
` [PATCH v3 3/3] tty: implement led triggers
[PATCH] tty: serial: msm_geni_serial: Fix TX infinite loop
2018-05-09 20:44 UTC
Serdev runtime PM (was: Re: [PATCH 4/7] dt-bindings: gnss: add u-blox binding)
2018-05-09 14:05 UTC (5+ messages)
` OMAP serial runtime PM and autosuspend (was: Re: [PATCH 4/7] dt-bindings: gnss: add u-blox binding))
[RFC PATCH 0/3] serial: uartps: Add run time support for more IPs than hardcoded 2
2018-05-09 12:09 UTC (5+ messages)
` [RFC PATCH 2/3] serial: uartps: Move register to probe based on run time detection
` [RFC PATCH 3/3] serial: uartps: Change uart ports allocation
[PATCH 0/2] serial: imx: cleanup shutdown
2018-05-09 11:28 UTC (11+ messages)
` [PATCH 1/2] serial: imx: cleanup imx_uart_disable_dma()
` [PATCH 2/2] serial: imx: dma_unmap_sg buffers on shutdown
[PATCH 1/2] serdev: add controller runtime PM support
2018-05-09 9:44 UTC (2+ messages)
` [PATCH EXAMPLE 2/2] dbg: gnss: sirf: allow aggressive controller runtime PM
[PATCH] tty: pl011: Avoid spuriously stuck-off interrupts
2018-05-08 12:44 UTC (6+ messages)
[PATCH 0/8] Tegra Combined UART driver
2018-05-08 11:44 UTC (9+ messages)
` [PATCH 1/8] dt-bindings: tegra186-hsp: Add shared interrupts
` [PATCH 2/8] dt-bindings: serial: Add bindings for nvidia,tegra194-tcu
` [PATCH 3/8] mailbox: Add transmit done by blocking option
` [PATCH 4/8] mailbox: tegra-hsp: Refactor in preparation of mailboxes
` [PATCH 5/8] mailbox: tegra-hsp: Add support for shared mailboxes
` [PATCH 6/8] serial: Add Tegra Combined UART driver
` [PATCH 7/8] arm64: tegra: Add nodes for tcu on Tegra194
` [PATCH 8/8] arm64: tegra: Mark tcu as primary serial port on Tegra194 P2888
[PATCH v3] serial: sh-sci: Use spin_{try}lock_irqsave instead of open coding version
2018-05-08 9:52 UTC (2+ messages)
[PATCH v2] serial: 8250_of: Add IO space support
2018-05-08 9:15 UTC (2+ messages)
[PATCH v2] serial: sh-sci: Use spin_{try}lock_irqsave instead of open coding version
2018-05-08 7:40 UTC (5+ messages)
[PATCH] serial: sh-sci: Use spin_{try}lock_irqsave instead of open coding version
2018-05-08 7:29 UTC (5+ messages)
[PATCH v3 0/3] sh: make early_platform code SuperH-specific
2018-05-08 6:45 UTC (9+ messages)
` [PATCH v3 1/3] clocksource: timer-ti-dm: remove the early platform driver registration
` [PATCH v3 2/3] platform: move the early platform device support to arch/sh
` [PATCH v3 3/3] sh: add the sh_ prefix to early platform symbols
[PATCH] tty/serial: atmel: use port->name as name in request_irq()
2018-05-07 17:11 UTC (13+ messages)
` [PATCH v2] "
` [PATCH v3] "
[PATCH v3 00/20] Allow compile-testing NO_DMA (drivers)
2018-05-07 7:21 UTC (8+ messages)
` [PATCH v3 03/20] crypto: Remove depends on HAS_DMA in case of platform dependency
` [PATCH v3 09/20] iommu: "
` [PATCH v3 12/20] media: "
[PATCHv2] serial: 8250: omap: Fix idling of clocks for unused uarts
2018-05-04 17:58 UTC (4+ messages)
[PATCHv3] serial: 8250: omap: Fix idling of clocks for unused uarts
2018-05-04 17:44 UTC
serial: uart_port->type
2018-05-04 17:38 UTC
[PATCH v2 0/6] Driver for at91 usart in spi mode
2018-05-04 15:47 UTC (7+ messages)
` [PATCH v2 1/6] MAINTAINERS: add at91 usart mfd driver
` [PATCH v2 2/6] mfd: at91-usart: added mfd driver for usart
` [PATCH v2 3/6] MAINTAINERS: add at91 usart spi driver
` [PATCH v2 4/6] dt-bindings: add binding for at91-usart in spi mode
` [PATCH v2 5/6] spi: at91-usart: add driver for at91-usart as spi
` [PATCH v2 6/6] tty/serial: atmel: changed the driver to work under at91-usart mfd
serial: start_tx & buffer handling
2018-05-04 14:10 UTC (6+ messages)
serial: custom baud rate
2018-05-04 13:59 UTC (5+ messages)
[PATCH] serial: imx: enable IMX21_UCR3_RXDMUXSEL for non-dte-mode
2018-05-04 3:59 UTC (5+ messages)
[PATCH] serial: 8250: omap: Fix idling of clocks for unused uarts
2018-05-03 14:31 UTC (3+ messages)
[PATCH v2 0/3] sh: make early_platform code SuperH-specific
2018-05-02 21:05 UTC (6+ messages)
` [PATCH v2 1/3] clocksource: timer-ti-dm: remove the early platform driver registration
` [PATCH v2 2/3] platform: move the early platform device support to arch/sh
` [PATCH v2 3/3] sh: add the sh_ prefix to early platform symbols
[PATCH 0/3] sh: make early_platform code SuperH-specific
2018-04-30 23:52 UTC (8+ messages)
` [PATCH 1/3] clocksource: timer-ti-dm: remove the early platform driver registration
` [PATCH 2/3] platform: move the early platform device support to arch/sh
` [PATCH 3/3] sh: add the sh_ prefix to early platform symbols
[PATCH 4.4 17/44] tty: n_gsm: Fix long delays with control frame timeouts in ADM mode
2018-04-30 19:24 UTC (2+ messages)
` [PATCH 4.4 18/44] tty: n_gsm: Fix DLCI handling for ADM mode if debug & 2 is not set
[PATCH 4.9 21/61] tty: n_gsm: Fix long delays with control frame timeouts in ADM mode
2018-04-30 19:24 UTC (2+ messages)
` [PATCH 4.9 22/61] tty: n_gsm: Fix DLCI handling for ADM mode if debug & 2 is not set
[PATCH 4.14 30/91] tty: n_gsm: Fix long delays with control frame timeouts in ADM mode
2018-04-30 19:24 UTC (2+ messages)
` [PATCH 4.14 31/91] tty: n_gsm: Fix DLCI handling for ADM mode if debug & 2 is not set
[PATCH 4.16 032/113] tty: n_gsm: Fix long delays with control frame timeouts in ADM mode
2018-04-30 19:24 UTC (2+ messages)
` [PATCH 4.16 033/113] tty: n_gsm: Fix DLCI handling for ADM mode if debug & 2 is not set
[PATCH 3.18 13/25] tty: n_gsm: Fix long delays with control frame timeouts in ADM mode
2018-04-30 19:23 UTC (2+ messages)
` [PATCH 3.18 14/25] tty: n_gsm: Fix DLCI handling for ADM mode if debug & 2 is not set
drivers/tty/serial/samsung.c s3c24xx_uart_copy_rx_to_tty
2018-04-27 16:41 UTC
[GIT PULL] TTY/Serial fixes for 4.17-rc3
2018-04-27 14:41 UTC
[RFC PATCH v4] tty: pl011: Avoid spuriously stuck-off interrupts
2018-04-26 15:25 UTC (6+ messages)
[PATCH v1 2/7] serdev: add dev_pm_domain_attach|detach()
2018-04-26 5:29 UTC (3+ messages)
[RFC PATCH v3] tty: pl011: Avoid spuriously stuck-off interrupts
2018-04-25 14:59 UTC (7+ messages)
[PATCH] earlycon: Remove hardcoded port->uartclk initialization in of_setup_earlycon
2018-04-25 13:48 UTC
[PATCH] serial: 8250_early: Setup divider when uartclk is passed
2018-04-25 12:51 UTC (4+ messages)
[RFC][PATCH 0/1] serdev: Support HS-UART serdev slaves over tty
2018-04-25 9:12 UTC (5+ messages)
[PATCH] Check for an error when the clock is enabled
2018-04-24 16:03 UTC (3+ messages)
` [PATCH v2] sc16is7xx: "
[RFC. PATCH] earlycon: Remove hardcoded port->uartclk initialization in of_setup_earlycon
2018-04-23 13:22 UTC (3+ messages)
[PATCH 0/4] serial: uartps: Dynamic allocation
2018-04-23 9:51 UTC (5+ messages)
` [PATCH 1/4] serial: uartps: Remove console_initcall from the driver
` [PATCH 2/4] serial: uartps: Use dynamic array for console port
` [PATCH 3/4] serial: uartps: Move cnds_uart_get_port to probe
` [PATCH 4/4] serial: uartps: Remove static port array
[PATCH] serial: 8250_of: Add IO space support
2018-04-23 9:22 UTC (3+ messages)
[RESEND PATCH] tty: serial: xuartps: Setup early console when uartclk is also passed
2018-04-23 8:55 UTC
[PATCH] tty: serial: xuartps: Setup early console when uartclk is also passed
2018-04-23 8:52 UTC (5+ messages)
page: next (older) | prev (newer) | latest
- recent:[subjects (threaded)|topics (new)|topics (active)]
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).