messages from 2018-05-28 08:21:26 to 2018-06-07 13:18:02 UTC [more...]
[PATCH v6 0/6] Driver for at91 usart in spi mode
2018-06-07 13:18 UTC (8+ messages)
` [PATCH v6 1/6] MAINTAINERS: add at91 usart mfd driver
` [PATCH v6 2/6] dt-bindings: add binding for atmel-usart in SPI mode
` [PATCH v6 3/6] mfd: at91-usart: added mfd driver for usart
` [PATCH v6 4/6] MAINTAINERS: add at91 usart spi driver
` [PATCH v6 5/6] spi: at91-usart: add driver for at91-usart as spi
` [PATCH v6 6/6] tty/serial: atmel: change the driver to work under at91-usart mfd
[PATCH 00/19] Dynamically load/remove serdev devices via sysfs*
2018-06-07 12:51 UTC (38+ messages)
` [PATCH 01/19] serdev: Add id_table to serdev_device_driver
` [PATCH 02/19] Bluetooth: hci_bcm: Add serdev_id_table
` [PATCH 03/19] Bluetooth: hci_ll: "
` [PATCH 04/19] Bluetooth: hci_nokia: "
` [PATCH 05/19] serdev: Introduce modalias field
` [PATCH 06/19] serdev: Support bus matching with "
` [PATCH 07/19] serdev: Allows dynamic creation of devices via sysfs
` [PATCH 08/19] serdev: Provide modalias attribute for modalias devices
` [PATCH 09/19] serdev: Provide modalias uevent "
` [PATCH 10/19] file2alias: Support for serdev devices
` [PATCH 11/19] Bluetooth: hci_bcm: MODULE_DEVICE_TABLE(serdev)
` [PATCH 12/19] Bluetooth: hci_ll: MODULE_DEVICE_TABLE(serdev)
` [PATCH 13/19] Bluetooth: hci_nokia: MODULE_DEVICE_TABLE(serdev)
` [PATCH 14/19] mfd: rave-sp: MODULE_DEVICE_TABLE(serdev)
` [PATCH 15/19] net: qualcomm: MODULE_DEVICE_TABLE(serdev)
` [PATCH 16/19] serdev: ttyport: Move serport structure to its own header
` [PATCH 17/19] serdev: Mark controllers compatible with ttyport
` [PATCH 18/19] serdev: ttydev: Serdev driver that creates an standard TTY port
` [PATCH 19/19] serdev: Instantiate a ttydev serdev if acpi and of fails
[PATCH 0/8] serial: 8250: Add 485 emulation to 8250_dw
2018-06-07 12:43 UTC (49+ messages)
` [PATCH 1/8] serial: 8250_dw: add em485 support
` [PATCH 2/8] serial: 8250_dw: allow enable rs485 at boot time
` [PATCH 3/8] serial: 8250: Copy em485 from port to real port
` [PATCH 4/8] serial: 8250: Handle case port doesn't have TEMT interrupt using em485
` [PATCH 2/4] serial: 8250: Copy mctrl when register port
` [PATCH 3/4] serial: 8250: Make em485_rts_after_send() set mctrl according to rts state
` [PATCH 4/4] serial: core: Mask mctrl with TIOCM_RTS too if rs485 on and RTS_AFTER_SEND set
` [PATCH 1/4] serial: 8250: Copy em485 from port to real port
` [PATCH 2/4] serial: 8250_dw: allow enable rs485 at boot time
` [PATCH 3/4] serial: 8250: Handle case port doesn't have TEMT interrupt using em485
` [PATCH 4/4] serial: 8250_dw: treat rpm suspend with -EBUSY if RS485 ON and RTS_AFTER_SEND
` [PATCH 1/4] serial: 8250_dw: add em485 support
` [PATCH 5/8] serial: 8250_dw: treat rpm suspend with -EBUSY if RS485 ON and RTS_AFTER_SEND
` [PATCH 6/8] serial: 8250: Copy mctrl when register port
` [PATCH 7/8] serial: 8250: Make em485_rts_after_send() set mctrl according to rts state
` [PATCH 8/8] serial: core: Mask mctrl with TIOCM_RTS too if rs485 on and RTS_AFTER_SEND set
possible deadlock in console_unlock
2018-06-07 11:40 UTC (3+ messages)
[PATCH v2] serial: imx: fix cached UCR2 read on software reset
2018-06-07 7:56 UTC (2+ messages)
[PATCH] uart: fix race between uart_put_char() and uart_shutdown()
2018-06-06 21:42 UTC (3+ messages)
[PATCH] serial: 8250_dw: 8250_dw need to depend on COMMON_CLK
2018-06-06 18:47 UTC
[RFC PATCH v2 0/6] serial: uartps: Add run time support for more IPs than hardcoded 2
2018-06-06 12:41 UTC (7+ messages)
` [RFC PATCH v2 1/6] serial: uartps: Do not initialize field to zero again
` [RFC PATCH v2 2/6] serial: uartps: Move register to probe based on run time detection
` [RFC PATCH v2 3/6] serial: uartps: Do not use static struct uart_driver out of probe()
` [RFC PATCH v2 4/6] serial: uartps: Move alias reading higher in probe()
` [RFC PATCH v2 5/6] serial: uartps: Fill struct uart_driver "
` [RFC PATCH v2 6/6] serial: uartps: Remove CDNS_UART_NR_PORTS macro
[PATCH v5 0/6] Driver for at91 usart in spi mode
2018-06-06 11:02 UTC (8+ messages)
` [PATCH v5 1/6] MAINTAINERS: add at91 usart mfd driver
` [PATCH v5 2/6] dt-bindings: add binding for atmel-usart in SPI mode
` [PATCH v5 3/6] mfd: at91-usart: added mfd driver for usart
` [PATCH v5 4/6] MAINTAINERS: add at91 usart spi driver
` [PATCH v5 5/6] spi: at91-usart: add driver for at91-usart as spi
` [PATCH v5 6/6] tty/serial: atmel: changed the driver to work under at91-usart mfd
[GIT PULL] TTY/Serial patches for 4.18-rc1
2018-06-05 18:59 UTC
[RFC PATCH 5/6] arm64: dts: ti: Add Support for AM654 SoC
2018-06-05 14:14 UTC (4+ messages)
` [RFC PATCH 6/6] arm64: dts: ti: Add support for AM654 EVM base board
[PATCH v4.9-stable] serial: pl011: add console matching function
2018-06-05 10:19 UTC (2+ messages)
[PATCH 1/2] serial: 8250: enable SERIAL_MCTRL_GPIO by default
2018-06-05 10:00 UTC (5+ messages)
` [PATCH 2/2] serial: 8250: Add SERIAL_MCTRL_GPIO support to 8250
[RFC PATCH 0/6] arm64: Initial support Texas Instrument's AM654 Platform
2018-06-05 6:01 UTC (5+ messages)
` [RFC PATCH 1/6] Documentation: arm: ti: Add bindings for AM654 SoC
` [RFC PATCH 2/6] arm64: Add support for TI's K3 Multicore SoC architecture
` [RFC PATCH 3/6] serial: 8250_omap: Add support for AM654 UART controller
` [RFC PATCH 4/6] serial: 8250_omap: Make 8250_omap driver driver depend on ARCH_K3
[PATCH v3 0/3] serial: xuartps: hardware race condition and cleanup
2018-06-04 10:22 UTC (4+ messages)
` [PATCH v3 1/3] serial: xuartps: fix typo in cdns_uart_startup
` [PATCH v3 2/3] serial: xuartps: reduce hardware TX race condition
` [PATCH v3 3/3] serial: xuartps: remove unnecessary register write
[PATCH 0/4] lib/vsprintf: Remove atomic-unsafe support for printk format %pCr
2018-06-01 16:37 UTC (12+ messages)
` [PATCH 1/4] clk: renesas: cpg-mssr: Stop using "
` [PATCH 2/4] thermal: bcm2835: "
` [PATCH 3/4] serial: sh-sci: "
` [PATCH 4/4] lib/vsprintf: Remove atomic-unsafe support for %pCr
[PATCH v4 0/6] Driver for at91 usart in spi mode
2018-05-31 1:02 UTC (15+ messages)
` [PATCH v4 2/6] dt-bindings: add binding for atmel-usart in SPI mode
` [PATCH v4 3/6] mfd: at91-usart: added mfd driver for usart
` [PATCH v4 5/6] spi: at91-usart: add driver for at91-usart as spi
` [PATCH v4 6/6] tty/serial: atmel: changed the driver to work under at91-usart mfd
[PATCH RESEND] serdev: add controller runtime PM support
2018-05-30 13:20 UTC (2+ messages)
[patch v25 0/4] JTAG driver introduction
2018-05-29 20:40 UTC (7+ messages)
` [patch v25 1/4] drivers: jtag: Add JTAG core driver
` [patch v25 2/4] drivers: jtag: Add Aspeed SoC 24xx and 25xx families JTAG master driver
` [patch v25 3/4] Documentation: jtag: Add bindings for "
` [patch v25 4/4] Documentation: jtag: Add ABI documentation
[patch v22 0/4] JTAG driver introduction
2018-05-29 20:08 UTC (9+ messages)
` [patch v22 1/4] drivers: jtag: Add JTAG core driver
` [patch v22 2/4] drivers: jtag: Add Aspeed SoC 24xx and 25xx families JTAG master driver
` [patch v22 3/4] Documentation: jtag: Add bindings for "
` [patch v22 4/4] Documentation: jtag: Add ABI documentation
[patch v23 0/4] JTAG driver introduction
2018-05-29 13:11 UTC (8+ messages)
` [patch v23 1/4] drivers: jtag: Add JTAG core driver
` [patch v23 2/4] drivers: jtag: Add Aspeed SoC 24xx and 25xx families JTAG master driver
` [patch v23 3/4] Documentation: jtag: Add bindings for "
` [patch v23 4/4] Documentation: jtag: Add ABI documentation
[patch v24 0/4] JTAG driver introduction
2018-05-29 12:58 UTC (5+ messages)
` [patch v24 1/4] drivers: jtag: Add JTAG core driver
` [patch v24 2/4] drivers: jtag: Add Aspeed SoC 24xx and 25xx families JTAG master driver
` [patch v24 3/4] Documentation: jtag: Add bindings for "
` [patch v24 4/4] Documentation: jtag: Add ABI documentation
[patch v22 0/4] JTAG driver introduction
2018-05-29 12:06 UTC (7+ messages)
` [patch v22 1/4] drivers: jtag: Add JTAG core driver
` [patch v22 2/4] drivers: jtag: Add Aspeed SoC 24xx and 25xx families JTAG master driver
` [patch v22 3/4] Documentation: jtag: Add bindings for "
` [patch v22 4/4] Documentation: jtag: Add ABI documentation
[PATCH v2 0/6] Driver for at91 usart in spi mode
2018-05-29 8:33 UTC (3+ messages)
page: next (older) | prev (newer) | latest
- recent:[subjects (threaded)|topics (new)|topics (active)]
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).