messages from 2018-08-21 06:52:33 to 2018-09-11 15:36:21 UTC [more...]
[PATCH v12 0/6] Driver for at91 usart in spi mode
2018-09-11 15:36 UTC (18+ messages)
` [PATCH v12 1/6] MAINTAINERS: add at91 usart mfd driver
` [PATCH v12 2/6] dt-bindings: add binding for atmel-usart in SPI mode
` [PATCH v12 3/6] mfd: at91-usart: added mfd driver for usart
` [PATCH v12 4/6] MAINTAINERS: add at91 usart spi driver
` [PATCH v12 5/6] spi: at91-usart: add driver for at91-usart as spi
` [PATCH v12 6/6] tty/serial: atmel: change the driver to work under at91-usart mfd
` [GIT PULL v2] Immutable branch between MFD, SPI and TTY due for the v4.20 merge window
[PATCH] kgdboc: Fix restrict error
2018-09-11 12:49 UTC (2+ messages)
[PATCH 0/3] Add slave DMA support for Actios Semi S900 SoC
2018-09-11 12:03 UTC (5+ messages)
` [PATCH 1/3] arm64: dts: actions: s900: Enable Tx DMA for UART5
` [PATCH 2/3] dmaengine: Add Slave and Cyclic mode support for Actions Semi Owl S900 SoC
` [PATCH 3/3] tty: serial: Add Tx DMA support for UART in Actions Semi Owl SoCs
[PATCH v11 0/6] Driver for at91 usart in spi mode
2018-09-11 10:56 UTC (14+ messages)
` [GIT PULL] Immutable branch between MFD, SPI and TTY due for the v4.20 merge window
` [GIT PULL v2] "
[PATCH 1/5] serial: sprd: Remove unused structure
2018-09-11 6:09 UTC (12+ messages)
` [PATCH 2/5] serial: sprd: Use readable macros instead of magic number
` [PATCH 3/5] serial: sprd: Remove unnecessary resource validation
` [PATCH 4/5] serial: sprd: Change 'int' to 'unsigned int'
` [PATCH 5/5] serial: sprd: Fix the indentation issue
[PATCH v4 0/2] add ISO7816 support
2018-09-10 13:19 UTC (4+ messages)
` [PATCH v4 1/2] tty/serial_core: add ISO7816 infrastructure
` [PATCH v4 2/2] tty/serial: atmel: add ISO7816 support
[PATCH] serial: 8250_omap: Make 8250_omap driver driver depend on ARCH_K3
2018-09-10 4:01 UTC (3+ messages)
[PATCH 0/3] ARM: OMAP1: ams-delta: Clean up GPIO setup for MODEM
2018-09-07 16:56 UTC (8+ messages)
` [PATCH 1/3] ARM: OMAP1: ams-delta: assign MODEM IRQ from GPIO descriptor
` [PATCH 2/3] ARM: OMAP1: ams-delta: initialize latch2 pins to safe values
` [PATCH 3/3] ARM: OMAP1: ams-delta: register MODEM device earlier
[PATCH] tty: serial: qcom_geni_serial: Fix serial when not used as console
2018-09-05 23:32 UTC (2+ messages)
[RFC RFT PATCH 0/4] gpiolib: speed up GPIO array processing
2018-09-05 21:50 UTC (48+ messages)
` [RFC RFT PATCH v4 1/4] gpiolib: Pass bitmaps, not integer arrays, to get/set array
` [PATH v5 0/4] gpiolib: speed up GPIO array processing
` [PATCH v5 1/4] gpiolib: Pass bitmaps, not integer arrays, to get/set array
` [PATCH v5 2/4] gpiolib: Identify arrays matching GPIO hardware
` [PATCH v5 3/4] gpiolib: Pass array info to get/set array functions
` [PATCH v5 4/4] gpiolib: Implement fast processing path in get/set array
` [PATH v6 0/4] gpiolib: speed up GPIO array processing
` [PATCH v6 1/4] gpiolib: Pass bitmaps, not integer arrays, to get/set array
` [PATCH v6 2/4] gpiolib: Identify arrays matching GPIO hardware
` [PATCH v6 3/4] gpiolib: Pass array info to get/set array functions
` [PATCH v6 4/4] gpiolib: Implement fast processing path in get/set array
` [PATCH v7 0/4] gpiolib: speed up GPIO array processing
` [PATCH v7 1/4] gpiolib: Pass bitmaps, not integer arrays, to get/set array
` [PATCH v7 2/4] gpiolib: Identify arrays matching GPIO hardware
` [PATCH v7 3/4] gpiolib: Pass array info to get/set array functions
` [PATCH v7 4/4] gpiolib: Implement fast processing path in get/set array
` [PATCH v8 0/4] gpiolib: speed up GPIO array processing
` [PATCH v8 1/4] gpiolib: Pass bitmaps, not integer arrays, to get/set array
` [PATCH v8 2/4] gpiolib: Identify arrays matching GPIO hardware
` [PATCH v8 3/4] gpiolib: Pass array info to get/set array functions
` [PATCH v8 4/4] gpiolib: Implement fast processing path in get/set array
[PATCH v3 0/2] add ISO7816 support
2018-09-05 14:14 UTC (7+ messages)
` [PATCH v3 2/2] tty/serial: atmel: "
[PATCH 00/25] Change tty_port(standard)_install's return type
2018-09-05 5:57 UTC (29+ messages)
` [PATCH 01/25] tty: Change return type to void
` [PATCH 02/25] isdn: i4l: isdn_tty: "
` [PATCH 03/25] s390: char: con3215: "
` [PATCH 04/25] s390: char: tty3270: "
` [PATCH 05/25] tty: hvc: hvc_console: "
` [PATCH 06/25] tty: hvc: hvcs: "
` [PATCH 07/25] tty: mips_ejtag_fdc: "
` [PATCH 08/25] tty: n_gsm: "
` [PATCH 09/25] tty: serial: kgdb_nmi: "
` [PATCH 10/25] tty: synclink: "
` [PATCH 11/25] tty: synclinkmp: "
` [PATCH 12/25] tty: vt: "
` [PATCH 13/25] usb: xhci: dbc: "
` [PATCH 14/25] Bluetooth: "
` [PATCH 15/25] um: "
` [PATCH 16/25] isdn: capi: "
` [PATCH 17/25] misc: pti: "
` [PATCH 18/25] mmc: core: sdio_uart: "
` [PATCH 19/25] staging: fwserial: "
` [PATCH 20/25] staging: gdm724x: gdm_tty: "
` [PATCH 21/25] staging: greybus: uart: "
` [PATCH 22/25] tty: nozomi: "
` [PATCH 23/25] tty: vcc: "
` [PATCH 24/25] usb: cdc-acm: "
` [PATCH 25/25] usb: usb-serial: "
[PATCH V2 1/2] tty: serial: imx: add lock for registers save/restore
2018-09-05 5:55 UTC (4+ messages)
` [PATCH V2 2/2] tty: serial: imx: add pinctrl sleep/default mode switch for suspend
[PATCH v2] tty: Change tty_{port|standard}_install() return type to void
2018-09-05 2:50 UTC
[PATCH 1/2] tty: serial: imx: add lock for registers save/restore
2018-09-05 1:20 UTC (6+ messages)
` [PATCH 2/2] tty: serial: imx: add pinctrl sleep/default mode switch for suspend
[PATCH 2/2] serial: uartps: Change uart ID port allocation
2018-09-03 13:14 UTC
[PATCH v3 00/10] serial: uartps: Add run time support for more IPs than hardcoded 2
2018-09-03 13:10 UTC (11+ messages)
` [PATCH v3 01/10] serial: uartps: console_setup() can't be placed to init section
` [PATCH v3 02/10] serial: uartps: Do not initialize field to zero again
` [PATCH v3 03/10] serial: uartps: Fix suspend functionality
` [PATCH v3 04/10] serial: uartps: Do not use static struct uart_driver out of probe()
` [PATCH v3 05/10] serial: uartps: Move alias reading higher in probe()
` [PATCH v3 06/10] serial: uartps: Move register to probe based on run time detection
` [PATCH v3 07/10] serial: uartps: Fill struct uart_driver in probe()
` [PATCH v3 08/10] serial: uartps: Change logic how console_port is setup
` [PATCH v3 09/10] serial: uartps: Register own uart console and driver structures
` [PATCH v3 10/10] serial: uartps: Move Port ID to device data structure
[PATCH] serial: uartps: Enable automatic flow control
2018-09-03 13:05 UTC
[PATCH v2 00/18] MIPS: intel: add initial support for Intel MIPS SoCs
2018-09-03 10:52 UTC (11+ messages)
` [PATCH v2 02/18] clk: intel: Add clock driver "
[RESEND PATCH v11 0/6] Driver for at91 usart in spi mode
2018-09-01 21:23 UTC (9+ messages)
` [RESEND PATCH v11 1/6] MAINTAINERS: add at91 usart mfd driver
` [RESEND PATCH v11 2/6] dt-bindings: add binding for atmel-usart in SPI mode
` [RESEND PATCH v11 3/6] mfd: at91-usart: added mfd driver for usart
` [RESEND PATCH v11 4/6] MAINTAINERS: add at91 usart spi driver
` [RESEND PATCH v11 5/6] spi: at91-usart: add driver for at91-usart as spi
` [RFC PATCH] spi: at91-usart: at91_usart_spi_transfer_one() can be static
` [RESEND PATCH v11 6/6] tty/serial: atmel: change the driver to work under at91-usart mfd
[PATCH 0/2] serial: sh-sci: Fix earlycon on Renesas ARM platforms
2018-08-30 22:30 UTC (5+ messages)
` [PATCH 1/2] Revert "serial: sh-sci: Remove SCIx_RZ_SCIFA_REGTYPE"
` [PATCH 2/2] Revert "serial: sh-sci: Allow for compressed SCIF address"
[PATCH v2] serial: 8250_of: Fix for lack of interrupt support
2018-08-30 18:21 UTC (3+ messages)
[PATCH] serial: 8250_of: Fix for lack of interrupt support
2018-08-29 19:50 UTC (2+ messages)
[PATCH] tty: serial: lpuart: avoid leaking struct tty_struct
2018-08-28 10:44 UTC
[PATCH] tty:serial:imx: use spin_lock instead of spin_lock_irqsave in isr
2018-08-28 8:36 UTC (2+ messages)
[RFC PATCH 5/6] arm64: dts: ti: Add Support for AM654 SoC
2018-08-28 3:39 UTC (8+ messages)
` "
[PATCH] tty: Convert to using %pOFn instead of device_node.name
2018-08-28 1:52 UTC
[PATCH] serial: mvebu-uart: Fix reporting of effective CSIZE to userspace
2018-08-27 6:25 UTC (2+ messages)
spin_lock instead of spin_lock_irqsave in imx uart interuput
2018-08-26 17:04 UTC (2+ messages)
[PATCH] tty: serial: qcom_geni_serial: Drop useless check for dev.of_node
2018-08-23 21:30 UTC
[PATCH] serial: mxs-auart: Fix potential infinite loop
2018-08-22 6:41 UTC (3+ messages)
` [PATCH v2] "
serdev: How to attach serdev devices to USB based tty devices?
2018-08-21 18:01 UTC (5+ messages)
page: next (older) | prev (newer) | latest
- recent:[subjects (threaded)|topics (new)|topics (active)]
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).