messages from 2019-05-14 07:37:36 to 2019-06-10 08:44:55 UTC [more...]
[PATCH 1/2] serial: xilinx_uartps: Fix warnings in the driver
2019-06-10 8:44 UTC
[PATCH v2] tty: serial: msm_serial: avoid system lockup condition
2019-06-10 7:55 UTC
[PATCH] tty: serial: msm_serial: avoid system lockup condition
2019-06-10 7:37 UTC
[PATCH 0/6] arm64: Initial support Texas Instrument's J721E Platform
2019-06-07 20:58 UTC (8+ messages)
` [PATCH 1/6] dt-bindings: arm: ti: Add bindings for J721E SoC
` [PATCH 2/6] dt-bindings: serial: 8250_omap: Add compatible for J721E UART controller
` [PATCH 3/6] arm64: dts: ti: Add Support for J721E SoC
` [PATCH 4/6] soc: ti: Add Support for J721E SoC config option
` [PATCH 5/6] arm64: dts: ti: Add support for J721E Common Processor Board
` [PATCH 6/6] arm64: defconfig: Enable TI's J721E SoC platform
[PATCH v3] serial: stm32: fix a recursive locking in stm32_config_rs485
2019-06-07 10:53 UTC (3+ messages)
` [PATCH v4] "
[PATCH] serial: stm32: fix a recursive locking in stm32_config_rs485
2019-06-06 7:42 UTC (5+ messages)
` Fwd: "
` [PATCH v2] "
[patch 0/5] *** Cover Letter: patch submission for AST2500 UART driver ***
2019-06-05 12:23 UTC (6+ messages)
` [patch 1/5] AST2500 DMA UART driver
` [patch 2/5] build configuration for "
` [patch 3/5] DT nodes "
` [patch 4/5] defconfig and MAINTAINERS updated "
` [patch 5/5] Documentation: DT bindings "
[PATCH -next] serial: stm32: Make stm32_get_databits static
2019-06-05 9:52 UTC (2+ messages)
` Fwd: "
[PATCH 1/2 v4] serial: mctrl_gpio: Check if GPIO property exisits before requesting it
2019-06-05 9:35 UTC (5+ messages)
` [PATCH 2/2 v4] tty/serial/8250: use mctrl_gpio helpers
[PATCH 0/6] Convert sa1100 serial to use mctrl gpios
2019-06-04 11:16 UTC (18+ messages)
` [PATCH 1/6] serial: sa1100: add support for "
` [PATCH] serial: sa1100: add note about modem control signals
` [PATCH v2] "
` [PATCH 2/6] ARM: sa1100/assabet: convert serial to gpiod APIs
` [PATCH 3/6] ARM: sa1100/h3xxx: "
` [PATCH 4/6] ARM: sa1100/badge4: remove commented out modem control initialisers
` [PATCH 5/6] ARM: sa1100/hackkit: remove empty serial mctrl functions
` [PATCH 6/6] ARM: sa1100/neponset: convert serial to use gpiod APIs
[PATCH 00/10] STM32 usart power improvements
2019-06-04 8:55 UTC (11+ messages)
` [PATCH 01/10] dt-bindings: serial: stm32: add wakeup option
` [PATCH 02/10] dt-bindings: serial: add optional pinctrl states
` [PATCH 03/10] serial: stm32: select pinctrl state in each suspend/resume function
` [PATCH 04/10] serial: stm32: add pm_runtime support
` [PATCH 05/10] serial: stm32: Use __maybe_unused instead of #if CONFIG_PM_SLEEP
` [PATCH 06/10] serial: stm32: add support for no_console_suspend
` [PATCH 07/10] ARM: dts: stm32: update uart4 pin configurations for low power
` [PATCH 08/10] ARM: dts: stm32: Update pin states for uart4 on stm32mp157c-ed1
` [PATCH 09/10] ARM: dts: stm32: Update UART4 pin states on stm32mp157a-dk1
` [PATCH 10/10] ARM: dts: stm32: add wakeup capability on each usart/uart on stm32mp157c
[PATCH v3 0/2] support 8250-mtk uart in-band wake up
2019-06-03 3:31 UTC (4+ messages)
` [PATCH v3 1/2] dt-bindings: serial: add documentation for Rx in-band wakeup support
` [PATCH v3 2/2] uart: mediatek: support Rx in-band wakeup
[PATCH] tty/serial: digicolor: Fix digicolor-usart already registered warning
2019-06-01 20:21 UTC (2+ messages)
[PATCH AUTOSEL 4.4 52/56] dmaengine: idma64: Use actual device for DMA transfers
2019-06-01 13:25 UTC
[GIT PULL] TTY/Serial fixes for 5.2-rc3
2019-05-31 17:25 UTC (2+ messages)
[PATCH v13 0/2] add uart DMA function
2019-05-30 9:34 UTC (7+ messages)
` [PATCH v13 1/2] arm: dts: mt2712: add uart APDMA to device tree
` [PATCH 2/2] serial: 8250-mtk: modify uart DMA rx
[PATCH 1/2 v3] serial: mctrl_gpio: Check if GPIO property exisits before requesting it
2019-05-29 13:57 UTC (6+ messages)
` [PATCH 2/2 v3] tty/serial/8250: use mctrl_gpio helpers
[PATCH 0/2] serial: 8250: Add support for 8250/16550 as MFD function
2019-05-27 19:56 UTC (17+ messages)
` [PATCH 2/2] "
[PATCH v5 0/2] tty: serial: add DT bindings and serial driver for the SiFive FU540 UART
2019-05-27 16:12 UTC (4+ messages)
[PATCH v11 0/6] Add basic node support for Mediatek MT8183 SoC
2019-05-27 9:04 UTC (7+ messages)
` [PATCH v11 1/6] arm64: dts: Add Mediatek SoC MT8183 and evaluation board dts and Makefile
` [PATCH v11 2/6] arm64: dts: mt8183: add capacity-dmips-mhz
` [PATCH v11 3/6] arm64: dts: mt8183: add pinctrl device node
` [PATCH v11 4/6] arm64: dts: mt8183: Add auxadc "
` [PATCH v11 5/6] arm64: dts: mt8183: add spi node
` [PATCH v11 6/6] arm64: dts: mt8183: add efuse and Mediatek Chip id node to read
[PATCH v2 0/2] support 8250-mtk uart in-band wake up
2019-05-27 7:11 UTC (4+ messages)
` [PATCH v2 1/2] dt-bindings: serial: add documentation for Rx in-band wakeup support
` [PATCH v2 2/2] uart: mediatek: support Rx in-band wakeup
[PATCH 1/2 v2] serial: mctrl_gpio: Check if GPIO property exisits before requesting it
2019-05-27 7:05 UTC (8+ messages)
` [PATCH 2/2 v2] tty/serial/8250: use mctrl_gpio helpers
serial driver cleanups v2
2019-05-27 5:57 UTC (3+ messages)
` [PATCH v2 20/45] drivers: tty: serial: msm_serial: use devm_* functions
[PATCH] serial: Fix an invalid comparing statement
2019-05-27 5:01 UTC
[PATCH 1/1] dt-bindings: stm32: serial: Add optional reset
2019-05-24 15:30 UTC
[PATCH 1/2] serial: mctrl_gpio: Check if GPIO property exisits before requesting it
2019-05-24 7:56 UTC (3+ messages)
` [PATCH 2/2] tty/serial/8250: use mctrl_gpio helpers
[PATCH 0/2] support 8250-mtk uart in-band wake up
2019-05-24 7:55 UTC (5+ messages)
` [PATCH 1/2] dt-bindings: serial: add documentation for Rx in-band wakeup support
` [PATCH 2/2] uart: mediatek: support Rx in-band wakeup
[RFC v2 00/11] DVFS in the OPP core
2019-05-24 6:03 UTC (5+ messages)
` [RFC v2 08/11] arm64: dts: sdm845: Add ufs opps and power-domains
[PATCH] serial-uartlite: Fix null-ptr-deref in ulite_exit
2019-05-23 12:47 UTC (8+ messages)
[PATCH] tty: serial: cpm_uart - fix init when SMC is relocated
2019-05-22 12:17 UTC
[PATCH v12 0/4] add uart DMA function
2019-05-22 5:24 UTC (10+ messages)
` [PATCH 1/4] dmaengine: mediatek: Add MediaTek UART APDMA support
` [PATCH 3/4] dt-bindings: dma: uart: rename binding
` [PATCH 4/4] serial: 8250-mtk: modify uart DMA rx
[PATCH] serial: 8250: Add support for using platform_device resources
2019-05-21 17:03 UTC (25+ messages)
` [PATCH resend] "
[PATCH 0/7] usart various fixes for STM32
2019-05-21 15:45 UTC (8+ messages)
` [PATCH 1/7] serial: stm32: fix word length configuration
` [PATCH 2/7] serial: stm32: fix rx error handling
` [PATCH 3/7] serial: stm32: fix rx data length when parity enabled
` [PATCH 4/7] serial: stm32: fix transmit_chars when tx is stopped
` [PATCH 5/7] serial: stm32: Add support of TC bit status check
` [PATCH 6/7] serial: stm32: fix wakeup source initialization
` [PATCH 7/7] serial: stm32: fix the get_irq error case
[PATCH] tracing: fix typos in code and comments
2019-05-21 14:59 UTC (3+ messages)
[PATCH v2] tty: serial: msm_serial: Fix XON/XOFF
2019-05-21 10:31 UTC (5+ messages)
[PATCH 0/7] tty: max310x: Simplify the code and fix a few bugs
2019-05-21 10:17 UTC (9+ messages)
` [PATCH 1/7] tty: max310x: Simplify tx-work item code
` [PATCH 2/7] tty: max310x: Introduce max310x_one port macro-wrapper
` [PATCH 3/7] tty: max310x: Don't pass stacked buffers to SPI
` [PATCH 4/7] tty: max310x: Fix invalid baudrate divisors calculator
` [PATCH 5/7] tty: max310x: Add rx-during-tx rs485 flag support
` [PATCH 6/7] tty: max310x: Optionally enable rs485 on startup
` [PATCH 7/7] tty: max310x: Split uart characters insertion loop
[PATCH] tty: serial: msm_serial: Fix XON/XOFF
2019-05-20 15:20 UTC (9+ messages)
[PATCH] tty: serial_core: Fix the incorrect configuration of baud rate and data length at the console serial port resume
2019-05-15 9:15 UTC (3+ messages)
[PATCH v3] serial: sh-sci: disable DMA for uart_console
2019-05-15 3:29 UTC
[PATCH v2] serial: sh-sci: disable DMA for uart_console
2019-05-14 16:16 UTC (5+ messages)
[PATCH v2 0/4] Use MFD framework for SGI IOC3 drivers
2019-05-14 14:29 UTC (7+ messages)
` [PATCH v2 2/4] mfd: ioc3: Add driver for SGI IOC3 chip
page: next (older) | prev (newer) | latest
- recent:[subjects (threaded)|topics (new)|topics (active)]
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).