messages from 2019-08-02 12:13:01 to 2019-08-19 16:31:28 UTC [more...]
[PATCH v5 00/17] Use MFD framework for SGI IOC3 drivers
2019-08-19 16:31 UTC (6+ messages)
` [PATCH v5 01/17] w1: add 1-wire master driver for IP block found in SGI ASICs
` [PATCH v5 02/17] w1: add DS2501, DS2502, DS2505 EPROM device driver
` [PATCH v5 03/17] nvmem: core: add nvmem_device_find
` [PATCH v5 04/17] MIPS: PCI: refactor ioc3 special handling
` [PATCH v5 05/17] MIPS: PCI: use information from 1-wire PROM for IOC3 detection
[PATCH v4 0/9] Use MFD framework for SGI IOC3 drivers
2019-08-19 16:03 UTC (26+ messages)
` [PATCH v4 1/9] w1: add 1-wire master driver for IP block found in SGI ASICs
` [PATCH v4 2/9] w1: add DS2501, DS2502, DS2505 EPROM device driver
` [PATCH v4 3/9] nvmem: core: add nvmem_device_find
` [PATCH v4 4/9] MIPS: PCI: refactor ioc3 special handling
` [PATCH v4 5/9] MIPS: PCI: use information from 1-wire PROM for IOC3 detection
` [PATCH v4 6/9] MIPS: SGI-IP27: remove ioc3 ethernet init
` [PATCH v4 7/9] mfd: ioc3: Add driver for SGI IOC3 chip
` [PATCH v4 8/9] MIPS: SGI-IP27: fix readb/writeb addressing
` [PATCH v4 9/9] Input: add IOC3 serio driver
[PATCH 0/3] serial: Don't check for mctrl_gpio_to_gpiod() returning error
2019-08-19 12:26 UTC (13+ messages)
` [PATCH 1/3] serial: atmel: "
` [PATCH 2/3] serial: mxs-auart: "
` [PATCH 3/3] serial: sh-sci: "
[PATCH v2 0/6] Add initial support for S32V234-EVB
2019-08-19 8:58 UTC (10+ messages)
` [PATCH v2 1/6] dt-bindings: arm: fsl: Add the S32V234-EVB board
` [PATCH v2 2/6] arm64: Introduce config for S32
` [PATCH v2 3/6] arm64: dts: fsl: Add device tree for S32V234-EVB
` [PATCH v2 4/6] dt-bindings: serial: Document Freescale LINFlex UART
` [PATCH v2 5/6] tty: serial: Add linflexuart driver for S32V234
` [PATCH v2 6/6] arm64: defconfig: Enable configs "
[PATCH V1 1/1] serial: 8250_pci: Add F81504A series Support
2019-08-19 0:49 UTC (3+ messages)
[PATCH] serial: 8250_pci: Merge 8250_moxa to 8250_pci
2019-08-16 16:51 UTC
[PATCH 00/14] ARM: move lpc32xx and dove to multiplatform
2019-08-15 19:38 UTC (31+ messages)
` [PATCH 02/14] usb: udc: lpc32xx: allow compile-testing
` [PATCH 03/14] watchdog: pnx4008_wdt: "
` [PATCH 04/14] serial: lpc32xx_hs: "
` [PATCH 05/14] gpio: lpc32xx: allow building on non-lpc32xx targets
` [PATCH 07/14] net: lpc-enet: move phy setup into platform code
` [PATCH 08/14] net: lpc-enet: allow compile testing
` [PATCH 10/14] ARM: lpc32xx: clean up header files
[PATCH v6 0/8] Add basic SoC support for mt6765
2019-08-15 13:44 UTC (4+ messages)
` [PATCH v6 5/8] clk: mediatek: Add MT6765 clock support
[PATCH v2 00/13] v2: ARM: move lpc32xx to multiplatform
2019-08-15 13:40 UTC (4+ messages)
` [PATCH v2 04/13] serial: lpc32xx_hs: allow compile-testing
` [PATCH v2 11/13] serial: lpc32xx: allow compile testing
[PATCH 0/2] dt-bindings: serial: lantiq: Convert to YAML & add support for new SoC
2019-08-14 8:22 UTC (3+ messages)
` [PATCH 1/2] dt-bindings: serial: lantiq: Convert to YAML schema
` [PATCH 2/2] dt-bindings: lantiq: Update for new SoC
[PATCH 0/9] dt-bindings: first tentative of conversion to yaml format
2019-08-13 21:19 UTC (3+ messages)
` [PATCH 8/9] dt-bindings: serial: meson-uart: convert to yaml
[PATCH 00/14] serial: tegra: Tegra186 support and fixes
2019-08-13 10:24 UTC (25+ messages)
` [PATCH 01/14] serial: tegra: add internal loopback functionality
` [PATCH 02/14] serial: tegra: add support to ignore read
` [PATCH 03/14] serial: tegra: avoid reg access when clk disabled
` [PATCH 04/14] serial: tegra: protect IER against LCR.DLAB
` [PATCH 05/14] serial: tegra: flush the RX fifo on frame error
` [PATCH 06/14] serial: tegra: report error to upper tty layer
` [PATCH 07/14] serial: tegra: add compatible for new chips
` [PATCH 08/14] serial: tegra: check for FIFO mode enabled status
` [PATCH 09/14] serial: tegra: set maximum num of uart ports to 8
` [PATCH 10/14] serial: tegra: add support to use 8 bytes trigger
` [PATCH 11/14] serial: tegra: DT for Adjusted baud rates
` [PATCH 12/14] serial: tegra: add support to adjust baud rate
` [PATCH 13/14] serial: tegra: report clk rate errors
` [PATCH 14/14] serial: tegra: Add PIO mode support
[PATCH v2 1/2] serial: 8250_pci: Add support for Sunix serial boards
2019-08-13 8:23 UTC (6+ messages)
` [PATCH v2 2/2] parport: parport_serial: Add support for Sunix Multi I/O boards
[PATCH] tty/serial: atmel: reschedule TX after RX was started
2019-08-13 7:40 UTC
[PATCH] tty/serial: atmel: remove redundant assignment to ret
2019-08-12 15:05 UTC (2+ messages)
[PATCH] serial: 8250_pci: Implement MSI(-X) support
2019-08-12 11:21 UTC
[GIT PULL] TTY/Serial fixes for 5.3-rc4
2019-08-10 19:30 UTC (2+ messages)
[PATCH 00/16] ARM: remove ks8695 and w90x900 platforms
2019-08-10 7:29 UTC (3+ messages)
` [PATCH 02/16] serial: remove ks8695 driver
[PATCH v3 0/7] Use MFD framework for SGI IOC3 drivers
2019-08-09 12:22 UTC (5+ messages)
` [PATCH v3 5/7] mfd: ioc3: Add driver for SGI IOC3 chip
[PATCH 0/6] Add initial support for S32V234-EVB
2019-08-09 9:57 UTC (21+ messages)
` [PATCH 1/6] dt-bindings: arm: fsl: Add the S32V234-EVB board
` [EXT] "
` [PATCH 2/6] arm64: Introduce config for S32
` [PATCH 3/6] arm64: dts: fsl: Add device tree for S32V234-EVB
` [PATCH 4/6] dt-bindings: serial: Document Freescale LINFlex UART
` [PATCH 5/6] tty: serial: Add linflexuart driver for S32V234
` [PATCH 6/6] arm64: defconfig: Enable configs "
[PATCH 1/2] serial: 8250_pci: Add support for Sunix serial boards
2019-08-09 9:18 UTC (4+ messages)
` [PATCH 2/2] parport: parport_serial: Add support for Sunix Multi I/O boards
[PATCH 12/22] serial: 8250/omap1: include linux/soc/ti/omap1-soc.h
2019-08-08 21:22 UTC
Device to write to all (serial) consoles
2019-08-08 14:52 UTC (8+ messages)
[PATCH v2 0/3] serial: lantiq: Update driver to support new SoC
2019-08-08 11:26 UTC (7+ messages)
` [PATCH v2 1/3] serial: lantiq: Use proper DT compatible string
` [PATCH v2 2/3] serial: lantiq: Make IRQ & ISR assignment dynamic
` [PATCH v2 3/3] serial: lantiq: Add support for Lightning Mountain SoC
[PATCH V38 18/29] Lock down TIOCSSERIAL
2019-08-08 0:07 UTC
[PATCH 4/5] dt-bindings: serial: lantiq: Update for new SoC
2019-08-07 13:31 UTC (5+ messages)
` [PATCH 1/5] serial: lantiq: Add SMP support
` [PATCH 2/5] serial: lantiq: Use proper DT compatible string
` [PATCH 3/5] serial: lantiq: Make IRQ & ISR assignment dynamic
` [PATCH 5/5] serial: lantiq: Add support for Lightning Mountain SoC
[PATCH] tty: serial: Introduce uart_tx_stoppped_or_empty()
2019-08-07 8:02 UTC (4+ messages)
[RFCv2 0/9] dt-bindings: first tentative of conversion to yaml format
2019-08-06 19:18 UTC (5+ messages)
` [RFCv2 8/9] dt-bindings: serial: meson-uart: convert to yaml
[PATCH v3 1/4] serial: mctrl_gpio: Avoid probe failures in case of missing gpiolib
2019-08-06 8:09 UTC (14+ messages)
` [PATCH v3 2/4] serial: mctrl_gpio: Add a NULL check to mctrl_gpio_to_gpiod()
` [PATCH v3 3/4] serial: sh-sci: Don't check for mctrl_gpio_init() returning -ENOSYS
` [PATCH v3 4/4] serial: 8250: "
[PATCH v3 0/6] LPUART fixes and improvements
2019-08-05 18:57 UTC (7+ messages)
` [PATCH v3 1/6] tty: serial: fsl_lpuart: Introduce lpuart_tx_dma_startup()
` [PATCH v3 2/6] tty: serial: fsl_lpuart: Introduce lpuart_rx_dma_startup()
` [PATCH v3 3/6] tty: serial: fsl_lpuart: Introduce lpuart32_configure()
` [PATCH v3 4/6] tty: serial: fsl_lpuart: Introduce lpuart*_setup_watermark_enable()
` [PATCH v3 5/6] tty: serial: fsl_lpuart: Don't enable TIE in .startup() or .resume()
` [PATCH v3 6/6] tty: serial: fsl_lpuart: Ignore TX/RX interrupts if DMA is enabled
[engineering.redhat.com #494100] Question on submitting patch for a security bug
2019-08-05 17:38 UTC
[PATCH -next] tty: serial: qcom_geni_serial: use devm_platform_ioremap_resource() to simplify code
2019-08-02 13:08 UTC
page: next (older) | prev (newer) | latest
- recent:[subjects (threaded)|topics (new)|topics (active)]
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).