messages from 2023-02-21 16:27:29 to 2023-03-07 19:50:35 UTC [more...]
[PATCH v9 0/9] Add minimal MT8365 and MT8365-EVK support
2023-03-07 19:40 UTC (10+ messages)
` [PATCH v9 8/9] dt-bindings: serial: mediatek,uart: add MT8365
` [PATCH v9 9/9] arm64: dts: mediatek: Initial mt8365-evk support
[PATCH 0/4] serial: qcom-geni: fix console shutdown hang
2023-03-07 18:47 UTC (12+ messages)
` [PATCH 1/4] "
` [PATCH 2/4] serial: qcom-geni: fix DMA mapping leak on shutdown
` [PATCH 3/4] serial: qcom-geni: fix mapping of empty DMA buffer
` [PATCH 4/4] serial: qcom-geni: drop bogus uart_write_wakeup()
[PATCH 1/2] tty: serial: qcom-geni-serial: check correct dma address before unprep
2023-03-07 16:48 UTC (6+ messages)
` [PATCH 2/2] tty: serial: qcom-geni-serial: check for valid size before starting dma
[PATCH 1/3] tty: serial: qcom-geni-serial: Fix kdb/kgdb after port shutdown (again)
2023-03-07 16:01 UTC (6+ messages)
` [PATCH 2/3] serial: uart_poll_init() should power on the UART
` [PATCH 3/3] tty: serial: qcom-geni-serial: Add a poll_init() function
[linux-next:master] BUILD SUCCESS WITH WARNING 709c6adf19dc558e44ab5c01659b09a16a2d3c82
2023-03-07 15:02 UTC
[PATCH v6 0/3] Add support for NXP bluetooth chipsets
2023-03-07 11:43 UTC (8+ messages)
` [PATCH v6 1/3] serdev: Add method to assert break signal over tty UART port
` [PATCH v6 2/3] dt-bindings: net: bluetooth: Add NXP bluetooth support
` [PATCH v6 3/3] Bluetooth: NXP: Add protocol support for NXP Bluetooth chipsets
[PATCH v7 0/3] Add support for NXP bluetooth chipsets
2023-03-07 11:29 UTC (5+ messages)
` [PATCH v7 1/3] serdev: Add method to assert break signal over tty UART port
` [PATCH v7 2/3] dt-bindings: net: bluetooth: Add NXP bluetooth support
` [PATCH v7 3/3] Bluetooth: NXP: Add protocol support for NXP Bluetooth chipsets
[PATCH v1] serdev: Set fwnode for serdev devices
2023-03-07 6:51 UTC (13+ messages)
[PATCH 0/4] devres: Provide krealloc_array
2023-03-06 15:30 UTC (6+ messages)
` [PATCH 1/4] "
` [PATCH 2/4] hwmon: pmbus: Use devm_krealloc_array
` [PATCH 3/4] iio: adc: "
` [PATCH 4/4] serial: qcom_geni: "
[PATCH] tty: serial: fsl_lpuart: fix race on RX DMA shutdown
2023-03-06 10:25 UTC (3+ messages)
[PATCH v5 1/1] serial: core: Start managing serial controllers to enable runtime PM
2023-03-06 6:49 UTC (3+ messages)
[PATCH v2 tty-next] serial: 8250_pci1xxxx: Disable SERIAL_8250_PCI1XXXX config by default
2023-03-05 14:51 UTC
[PATCH v2 0/9] i2c: Switch .probe() to not take an id parameter
2023-03-03 22:08 UTC (3+ messages)
` [PATCH v2 3/9] serial: sc16is7xx: Convert to i2c's .probe_new()
[PATCH AUTOSEL 6.2 16/64] tty: serial: fsl_lpuart: disable the CTS when send break signal
2023-03-03 21:40 UTC (3+ messages)
` [PATCH AUTOSEL 6.2 17/64] serial: sc16is7xx: setup GPIO controller later in probe
` [PATCH AUTOSEL 6.2 50/64] tty: pcn_uart: fix memory leak with using debugfs_lookup()
[PATCH AUTOSEL 6.1 13/60] tty: serial: fsl_lpuart: disable the CTS when send break signal
2023-03-03 21:43 UTC (3+ messages)
` [PATCH AUTOSEL 6.1 14/60] serial: sc16is7xx: setup GPIO controller later in probe
` [PATCH AUTOSEL 6.1 46/60] tty: pcn_uart: fix memory leak with using debugfs_lookup()
[PATCH AUTOSEL 4.14 03/11] tty: serial: fsl_lpuart: disable the CTS when send break signal
2023-03-03 21:49 UTC
[PATCH AUTOSEL 4.19 06/16] tty: serial: fsl_lpuart: disable the CTS when send break signal
2023-03-03 21:48 UTC
[PATCH AUTOSEL 5.10 09/30] tty: serial: fsl_lpuart: disable the CTS when send break signal
2023-03-03 21:46 UTC (2+ messages)
` [PATCH AUTOSEL 5.10 10/30] serial: sc16is7xx: setup GPIO controller later in probe
[PATCH AUTOSEL 5.4 08/20] tty: serial: fsl_lpuart: disable the CTS when send break signal
2023-03-03 21:47 UTC
[PATCH AUTOSEL 5.15 11/50] tty: serial: fsl_lpuart: disable the CTS when send break signal
2023-03-03 21:45 UTC (3+ messages)
` [PATCH AUTOSEL 5.15 12/50] serial: sc16is7xx: setup GPIO controller later in probe
` [PATCH AUTOSEL 5.15 39/50] tty: pcn_uart: fix memory leak with using debugfs_lookup()
[PATCH v1 tty-next] serial: 8250_pci1xxxx: Disable SERIAL_8250_PCI1XXXX config by default
2023-03-03 18:45 UTC (2+ messages)
[PATCH] serial: core: fix broken console after suspend
2023-03-02 16:43 UTC (7+ messages)
[PATCH] serial: imx: Drop a few unneeded casts
2023-03-02 16:06 UTC (3+ messages)
[PATCH] serial: imx: Simplify imx_uart_type
2023-03-02 13:19 UTC (4+ messages)
[PATCH tty-next] serial: 8250_pci1xxxx: Disable SERIAL_8250_PCI1XXXX config by default
2023-03-02 7:03 UTC (4+ messages)
[PATCH v5 0/3] Add support for NXP bluetooth chipsets
2023-03-01 15:51 UTC (11+ messages)
` [PATCH v5 1/3] serdev: Add method to assert break signal over tty UART port
` [PATCH v5 2/3] dt-bindings: net: Bluetooth: Add NXP bluetooth support
` [PATCH v5] Bluetooth: NXP: Add protocol support for NXP Bluetooth chipsets
[PATCH 0/8] drivers: select REGMAP instead of depending on it
2023-03-01 12:47 UTC (5+ messages)
` [PATCH 8/8] serial: 8250: ASPEED_VUART: "
[PATCH 00/20] MODULE_LICENSE removals, fifth tranche
2023-02-28 13:47 UTC (3+ messages)
` [PATCH 15/20] tty: serial: imx: remove MODULE_LICENSE in non-modules
[PATCH 1/3] tty: n_gsm: add ioctl for DLC specific parameter configuration
2023-02-28 10:51 UTC (6+ messages)
` [PATCH 2/3] tty: n_gsm: allow window size configuration
` [PATCH 3/3] tty: n_gsm: add ioctl for DLC config via ldisc handle
[GIT PULL] TTY/Serial driver updates for 6.3-rc1
2023-02-28 7:35 UTC (14+ messages)
[PATCH] serial: 8250_fsl: fix handle_irq locking
2023-02-28 6:27 UTC (2+ messages)
[PATCH] Revert "tty: serial: fsl_lpuart: adjust SERIAL_FSL_LPUART_CONSOLE config dependency"
2023-02-28 6:24 UTC (3+ messages)
[PATCH] vc_screen: don't clobber return value in vcs_read
2023-02-28 5:38 UTC (6+ messages)
[PATCH v2] vc_screen: modify vcs_size() handling in vcs_read()
2023-02-28 2:40 UTC (6+ messages)
[PATCH] vc_screen: modify vcs_size() handling in vcs_read()
2023-02-27 20:06 UTC (2+ messages)
[PATCH v5 0/7] Update Renesas {EMMA mobile, RZ/V2M} UART Port type
2023-02-27 11:41 UTC (8+ messages)
` [PATCH v5 1/7] serial: 8250_em: Fix UART port type
` [PATCH v5 2/7] serial: 8250_em: Simplify probe()
` [PATCH v5 3/7] serial: 8250_em: Drop unused header file
` [PATCH v5 4/7] serial: 8250_em: Add missing break statement
` [PATCH v5 5/7] serial: 8250_em: Use devm_clk_get_enabled()
` [PATCH v5 6/7] serial: 8250_em: Use pseudo offset for UART_FCR
` [PATCH v5 7/7] serial: 8250_em: Add serial8250_em_{reg_update(),out_helper()}
[PATCH v3 0/6] Introduce STM32 system bus
2023-02-27 11:26 UTC (7+ messages)
` [PATCH v3 6/6] ARM: dts: stm32: add ETZPC as a system bus for STM32MP13x boards
` [Linux-stm32] "
[bug report] serial: 8250: fix handle_irq locking
2023-02-27 8:52 UTC (2+ messages)
[PATCH v2] tty: serial: fsl_lpuart: select SERIAL_FSL_LPUART for SERIAL_FSL_LPUART_CONSOLE
2023-02-26 16:46 UTC (3+ messages)
[PATCH] tty: serial: fsl_lpuart: select SERIAL_FSL_LPUART for SERIAL_FSL_LPUART_CONSOLE
2023-02-26 15:02 UTC (7+ messages)
UART RX losing bytes
2023-02-26 13:45 UTC (2+ messages)
[PATCH 00/17] Add support for MT8365 EVK board
2023-02-25 16:41 UTC (3+ messages)
` [PATCH 08/17] dt-bindings: watchdog: mtk-wdt: Add MT8365 SoC bindings
[PATCH 0/9] i2c: Switch .probe() to not take an id parameter
2023-02-24 12:05 UTC (2+ messages)
` [PATCH 3/9] serial: sc16is7xx: Convert to i2c's .probe_new()
[PATCH v4 0/3] Add support for NXP bluetooth chipsets
2023-02-23 11:00 UTC (9+ messages)
` [PATCH v4 2/3] dt-bindings: net: bluetooth: Add NXP bluetooth support
` [PATCH v4 3/3] Bluetooth: NXP: Add protocol support for NXP Bluetooth chipsets
[PATCH] tty: serial: fsl_lpuart: skip waiting for transmission complete when UARTCTRL_SBK is asserted
2023-02-23 9:39 UTC
[PATCH 1/2] serial: stm32: Remove unused struct stm32_port txdone element
2023-02-23 4:22 UTC (2+ messages)
` [PATCH 2/2] serial: stm32: Re-assert RTS/DE GPIO in RS485 mode only if more data are transmitted
Faktoring
2023-02-22 9:10 UTC
[PATCH v3 0/3] Add support for NXP bluetooth chipsets
2023-02-21 16:56 UTC (5+ messages)
` [PATCH v3 2/3] dt-bindings: net: bluetooth: Add NXP bluetooth support
page: next (older) | prev (newer) | latest
- recent:[subjects (threaded)|topics (new)|topics (active)]
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).