messages from 2026-09-06 16:08:03 to 2026-09-13 22:37:16 UTC [more...]
[RFC PATCH 0/2] Landlock signal scope and TIOCSIG
2026-09-13 22:37 UTC (5+ messages)
` [RFC PATCH 1/2] tty: mediate TIOCSIG through task_kill LSM hooks
` [RFC PATCH 2/2] selftests/landlock: cover TIOCSIG signal scoping
[PATCH 03/13] ARM: remove riscpc
2026-09-13 18:13 UTC (18+ messages)
[PATCH RESEND v4] ACPI: SPCR: Support UART clock frequency field
2026-09-13 16:23 UTC (2+ messages)
[PATCH 0/2] serial: 8250_dw: Add ti,tda54-uart support
2026-09-13 9:04 UTC (6+ messages)
` [PATCH 1/2] dt-bindings: serial: snps-dw-apb-uart: Add ti,tda54-uart
` [PATCH 2/2] serial: 8250_dw: Add ti,tda54-uart quirk to skip empty FIFO read
[PATCH 0/2] qcom-geni: Fix QUP Core ICC votes
2026-09-13 8:42 UTC (8+ messages)
` [PATCH 1/2] soc: qcom: geni-se: Correct QUP Core ICC vote constants
` [PATCH 2/2] tty: serial: qcom_geni_serial: Keep console RX functional after deep idle
[PATCH] tty: serial: meson: fix UART driver lifetime
2026-09-13 3:52 UTC (2+ messages)
[PATCH 0/5] fbcon,vgacon,vt: Share helpers for text cursors
2026-09-12 19:01 UTC (12+ messages)
` [PATCH 1/5] vt: Add cursor-size helpers
` [PATCH 2/5] vgacon: Remove trailing whitespaces
` [PATCH 3/5] vgacon: Use vt_font_cursor_{start,end}()
` [PATCH 4/5] lib/fonts: Add font_glyph_cursor() helper
` [PATCH 5/5] fbcon: Replace fbcon_fill_cursor_mask() with fbcon_cursor_glyph()
[PATCH v2 0/9] soc: qcom: geni: Derive SE clock configuration from OPP table on SA8255P
2026-09-11 17:42 UTC (13+ messages)
` [PATCH v2 4/9] soc: qcom: geni-se: Remove OPP rate reset from resource deactivation
` [PATCH v2 7/9] i2c: qcom-geni: Vote for SE clock rate using OPP
[PATCH v6 00/13] Ambarella CV75 SoC minimal bring-up
2026-09-11 12:57 UTC (26+ messages)
` [PATCH v6 02/13] dt-bindings: mfd: syscon: add Ambarella CV75 secure scratchpad
` [PATCH v6 03/13] dt-bindings: clock: add Ambarella CV75 RCT
` [PATCH v6 06/13] dt-bindings: serial: snps-dw-apb-uart: add ambarella,cv75-uart
` [PATCH v6 08/13] gpio: regmap: support write_data_after_dir and girq
` "
` "
` "
` "
` [PATCH v6 11/13] serial: 8250_dw: add Ambarella CV75 quirks
` "
` "
` "
` "
[PATCH] tty: amiserial: fix broken TIOCMIWAIT
2026-09-11 9:17 UTC (3+ messages)
[PATCH] tty: n_gsm: keep DLCI 0 object across mux restarts
2026-09-11 7:56 UTC (3+ messages)
[PATCH] serial: sh-sci: Unregister UART on sysfs setup failure
2026-09-11 3:20 UTC (2+ messages)
[PATCH v4 0/4] serial: fix ioctl hangup race
2026-09-10 13:25 UTC (9+ messages)
` [PATCH v4 1/4] serial: revert guards in uart_wait_modem_status()
` [PATCH v4 2/4] serial: fix ioctl hangup race
` [PATCH v4 3/4] serial: fix TIOCMIWAIT race
` [PATCH v4 4/4] serial: abort TIOCMIWAIT on hangup
[PATCH] tty: port: fix tty_port_tty_vhangup() race
2026-09-10 12:59 UTC (2+ messages)
[PATCH] serial: 8250_bcm7271: fix use-after-free in brcmuart_remove()
2026-09-09 8:57 UTC (2+ messages)
[PATCH 0/2 5.10] serial: 8250_dw: fix port leak on clock notifier failure
2026-09-08 22:59 UTC (5+ messages)
` [PATCH 1/2 5.10] serial: 8250_dw: Use dev_err_probe()
` [PATCH 2/2 5.10] serial: 8250_dw: unregister 8250 port if clk_notifier_register() fails
[PATCH v4 0/2] WK2xxx SPI to UART bridge driver
2026-09-08 17:51 UTC (7+ messages)
` [PATCH v4 1/2] dt-bindings: serial: Document WK2xxx SPI UART
` [PATCH v4 2/2] serial: wk2xxx: Add WK2xxx SPI UART driver
[PATCH v3] serial: 8250_dw: Prefer SRBR in bogus RX timeout workaround if available
2026-09-08 15:58 UTC (3+ messages)
[PATCH v2] serial: 8250_dw: Prefer SRBR in bogus RX timeout workaround if available
2026-09-08 11:52 UTC (4+ messages)
[PATCH] tty: atmel: Replace SIMPLE_DEV_PM_OPS with DEFINE_SIMPLE_DEV_PM_OPS
2026-09-08 11:44 UTC (2+ messages)
[PATCH] tty: tty_port: restore TTY_IO_ERROR on activation failure
2026-09-08 8:46 UTC (2+ messages)
[PATCH v2 0/2] powerpc: fix typos and repeated words in comments
2026-09-08 5:56 UTC (5+ messages)
` [PATCH v2 1/2] powerpc: fix typos "
` [PATCH v2 2/2] powerpc: fix repeated words "
[PATCH 0/2] powerpc: fix typos and repeated words in comments
2026-09-07 18:05 UTC (6+ messages)
` [PATCH 1/2] powerpc: fix typos "
` [PATCH 2/2] powerpc: fix repeated words "
[PATCH] serial: 8250_of: set UART_CAP_NOTEMT for rts-gpios RS485 direction
2026-09-07 17:36 UTC (2+ messages)
[PATCH] Documentation: rs485: Pull uart_get_rs485_mode() from serial_core.c
2026-09-07 15:52 UTC (2+ messages)
[PATCH] serial: 8250_of: set UART_CAP_NOTEMT for rts-gpios RS485 direction
2026-09-07 15:37 UTC (2+ messages)
[PATCH 0/2] WK2xxx SPI to UART bridge driver
2026-09-07 8:20 UTC (3+ messages)
` [PATCH 1/2] serial: wk2xxx: Add WK2xxx SPI UART driver
[PATCH v3 0/4] serial: fix ioctl hangup race
2026-09-07 7:37 UTC (13+ messages)
` [PATCH v3 1/4] serial: revert guards in uart_wait_modem_status()
` [PATCH v3 2/4] serial: fix ioctl hangup race
` [PATCH v3 3/4] serial: fix TIOCMIWAIT race
` [PATCH v3 4/4] serial: abort TIOCMIWAIT on hangup
[PATCH] tty: serial: fix typo "satify" in comment
2026-09-07 6:29 UTC (2+ messages)
[PATCH v3] tty: serial: qcom_geni: don't ida_free() the console port line
2026-09-07 4:38 UTC (3+ messages)
[PATCH] tty: serial: qcom_geni: don't ida_free() the console port line
2026-09-07 4:37 UTC (2+ messages)
[PATCH] ecard: use module_driver() to avoid repeated boilerplate code
2026-09-07 2:12 UTC (2+ messages)
[PATCH 0/5] rust: serdev: Refactor
2026-09-06 22:51 UTC (15+ messages)
` [PATCH 1/5] tty: serdev: Export functions to pause receive_buf callback calls
` [PATCH 2/5] rust: serdev: Replace `active` mutex with receive pause
` [PATCH 3/5] rust: serdev: Simplify callbacks
` [PATCH 4/5] rust: Add `Device::drvdata_borrow_mut`
` [PATCH 5/5] rust: serdev: Pause receive callback before calling unbind
[GIT PULL] virtio driver fix for 7.3-rc2
2026-09-06 18:11 UTC (2+ messages)
page: | prev (newer) | latest
- recent:[subjects (threaded)|topics (new)|topics (active)]
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox