messages from 2026-09-24 08:44:25 to 2026-09-29 06:41:07 UTC [more...]
[PATCH 00/20] arm64: add Synaptics SL261X SoCs and RDK boards
2026-09-29 6:41 UTC (26+ messages)
` [PATCH 01/20] dt-bindings: serial: snps-dw-apb-uart: Add Synaptics sl261x uart
` [PATCH 02/20] dt-bindings: i2c: dw: Add Synaptics sl261x i2c
` [PATCH 03/20] spi: dt-bindings: snps,dw-apb-ssi: Add Synaptics sl261x spi
` [PATCH 04/20] dt-bindings: i3c: dw: support up to two reset lines
` [PATCH 05/20] i3c: dw: switch to array-based exclusive reset control
` [PATCH 06/20] dt-bindings: i3c: Add Synaptics sl261x i3c
` [PATCH 07/20] arm64: kconfig: let ARCH_BERLIN cover Synaptics arm64 SoCs
` [PATCH 08/20] dt-bindings: reset: add Synaptics SL261X SoCs
` [PATCH 09/20] reset: add Synaptics SL261x reset support
` [PATCH 10/20] pinctrl: berlin: use u16 instead of u8 for the offset
` [PATCH 11/20] pinctrl: berlin: enable module build support
` [PATCH 12/20] pinctrl: berlin: add optional pinconf support
` [PATCH 13/20] dt-bindings: pinctrl: berlin: Support Synaptics SL261X SoCs
` [PATCH 14/20] pinctrl: berlin: support "
` [PATCH 15/20] dt-bindings: clock: add Synaptics SL261X clock
` [PATCH 16/20] clk: berlin: add Synaptics SL261X SoC clocks and plls
` [PATCH 17/20] dt-bindings: mfd: Add Synaptics SL261x global block binding
` [PATCH 18/20] regulator: dt-bindings: sy8827n: support standard properties
` [PATCH 19/20] dt-bindings: arm: berlin: Add Synaptics SL261X SoC and RDK board
` [PATCH 20/20] arm64: dts: synaptics: "
[PATCH -next,v4] serial: core: fix NULL/dangling port_dev on failed re-register
2026-09-29 2:45 UTC (2+ messages)
[PATCH -next,v3] serial: core: fix NULL/dangling port_dev on failed re-register
2026-09-29 2:37 UTC (4+ messages)
[PATCH v2 1/2] serial: use dmaengine_get_dma_device() instead of chan->device->dev
2026-09-28 18:41 UTC (4+ messages)
` [PATCH v2 2/2] serial: amba-pl011: use dmaengine public API instead of raw ops
[PATCH 0/3] Remove obsolete __MODULE_STRING()
2026-09-28 16:18 UTC (6+ messages)
` [PATCH 2/3] drivers: Replace __MODULE_STRING() with __stringify()
[PATCH v2 RESEND] serial: sc16is7xx: fix TX gap caused by kfifo circular buffer wrap-around
2026-09-28 13:47 UTC (3+ messages)
[PATCH] vt: skip screen update for DEC alignment test on backgroup consoles
2026-09-28 12:50 UTC (2+ messages)
[PATCH v3 0/5] fbcon,vgacon,vt: Share helpers for text cursors
2026-09-28 11:45 UTC (15+ messages)
` [PATCH v3 1/5] vt: Add cursor-size helpers
` [PATCH v3 2/5] vgacon: Remove trailing whitespaces
` [PATCH v3 3/5] vgacon: Use vt_cursor_{start,end}()
` [PATCH v3 4/5] lib/fonts: Add font_glyph_cursor() helper
` [PATCH v3 5/5] fbcon: Replace fbcon_fill_cursor_mask() with fbcon_cursor_glyph()
[PATCH] MAINTAINERS: name the gregkh/tty tty-next branch
2026-09-28 11:44 UTC (2+ messages)
[PATCH -next,v2] serial: core: fix NULL/dangling port_dev on failed re-register
2026-09-28 11:39 UTC (4+ messages)
[PATCH v4 0/4] rust: introduce DropGuard
2026-09-28 9:50 UTC (12+ messages)
` [PATCH 1/4] rust: mem: add DropGuard
` [PATCH 2/4] rust: block: gen_disk: use DropGuard
` [PATCH 3/4] rust: serdev: "
` [PATCH 4/4] rust: sync: lock: "
[PATCH v2 0/2] serial: sc16is7xx: improve TX FIFO refill
2026-09-28 9:45 UTC (3+ messages)
` [PATCH v2 1/2] serial: sc16is7xx: refill TX FIFO below trigger using fresh TXLVL
` [PATCH v2 2/2] serial: sc16is7xx: reduce TX refill rate with half-FIFO trigger
[PATCH v2] serial: 8250_uniphier: Use devm_clk_get_enabled()
2026-09-28 9:05 UTC (7+ messages)
[PATCH v2 0/9] soc: qcom: geni: Derive SE clock configuration from OPP table on SA8255P
2026-09-28 8:59 UTC (8+ messages)
[PATCH 1/2] serial: use dmaengine_get_dma_device() instead of chan->device->dev
2026-09-28 8:51 UTC (5+ messages)
` [PATCH 2/2] serial: amba-pl011: use dmaengine public API instead of raw ops
[PATCH] serial: 8250_mid: Add missing module namespace import for SERIAL_8250
2026-09-28 8:17 UTC (3+ messages)
[PATCH v2] dt-bindings: serial: renesas,hscif: Increase number of DMA channels to 6
2026-09-28 6:31 UTC (2+ messages)
[PATCH v2] dt-bindings: serial: renesas,scif: Increase number of DMA channels to 6
2026-09-28 6:29 UTC (2+ messages)
[PATCH] serial: imx: cancel RS485 trigger hrtimers in shutdown and remove
2026-09-28 1:21 UTC (5+ messages)
[syzbot] [serial?] KASAN: slab-use-after-free Read in kbd_event (2)
2026-09-28 0:45 UTC (2+ messages)
[PATCH v2] serial: hvc: use modern IRQ acquisition API
2026-09-27 20:53 UTC (2+ messages)
[PATCH v2] serial: ucc_uart: Use platform IRQ helper
2026-09-27 20:50 UTC (2+ messages)
[PATCH] tty: serial: mpc52xx_uart: move static declarations up
2026-09-27 20:40 UTC (2+ messages)
[PATCH 0/2] braille: nbcon: Allow using a serial driver converted to nbcon API as a Braille console
2026-09-27 18:47 UTC (15+ messages)
` [PATCH 1/2] printk: nbcon: Introduce Braille helpers
` [PATCH 2/2] braille: nbcon: Use nbcon atomic console callbacks
[PATCH 1/2] m68k/serial: Use generic BASE_BAUD in asm/serial.h
2026-09-27 14:17 UTC (2+ messages)
[PATCH] serial: 8250: Fix section mismatch with CONFIG_MODULES=n
2026-09-27 14:00 UTC (4+ messages)
[tty:tty-linus] BUILD SUCCESS 5dad87615c9861cfa366ca984b52f581e861df20
2026-09-27 7:56 UTC
[tty:tty-testing] BUILD SUCCESS bf961847813d9edcb5a9c089714069428d141fa9
2026-09-27 6:49 UTC
[PATCH v3] tty: serial: max3100: shut down timer before freeing port
2026-09-27 6:12 UTC (3+ messages)
` [PATCH v4] "
[PATCH v3 0/5] rust: add DropGuard
2026-09-26 23:53 UTC (12+ messages)
` [PATCH v3 1/5] rust: add DropGuard KUnit test configuration
` [PATCH v3 2/5] rust: mem: add DropGuard
` [PATCH v3 3/5] rust: block: gen_disk: use DropGuard
` [PATCH v3 4/5] rust: serdev: "
` [PATCH v3 5/5] rust: sync: lock: "
[PATCH] tty: Serialize saved termios access with device registration
2026-09-26 18:52 UTC (2+ messages)
[PATCH 08/13] HID: ft260: uart: add modem pins control via ioctl
2026-09-26 18:27 UTC (3+ messages)
[PATCH v2 0/5] rust: add DropGuard
2026-09-26 16:46 UTC (11+ messages)
` [PATCH v2 1/5] rust: add DropGuard KUnit test configuration
` [PATCH v2 2/5] rust: mem: add DropGuard
` [PATCH v2 3/5] rust: block: gen_disk: use DropGuard
` [PATCH v2 4/5] rust: serdev: "
` [PATCH v2 5/5] rust: sync: lock: "
[PATCH] serial: core: shut down initialized port on removal
2026-09-26 13:05 UTC (4+ messages)
[PATCH 0/2] serial: sc16is7xx: fix TX inter-frame gaps on SPI UARTs
2026-09-24 16:01 UTC (5+ messages)
` [PATCH 1/2] serial: sc16is7xx: fix TX gap caused by kfifo circular buffer wrap-around
[PATCH] tty: add break_wait kernel-doc
2026-09-26 0:32 UTC (6+ messages)
[PATCH] serial: hvc: use modern IRQ acquisition API
2026-09-25 18:59 UTC (2+ messages)
[PATCH] serial: ucc_uart: Use platform IRQ helper
2026-09-25 18:50 UTC (3+ messages)
[PATCH] serial: arc_uart: Use platform IRQ helper
2026-09-25 18:38 UTC (2+ messages)
[PATCH] serial: cpm_uart: use irq variable for platform_get_irq()
2026-09-25 18:22 UTC (2+ messages)
[PATCH v2 0/2] serial: 8250_port: Update runtime PM flow
2026-09-25 17:00 UTC (6+ messages)
` [PATCH v2 1/2] serial: 8250_port: Remove redundant pm_runtime_mark_last_busy() call
` [PATCH v2 2/2] serial: 8250_port: properly handle runtime PM in IRQ
[PATCH v2 0/1] braille: nbcon: Fix Braille console for NBCON API
2026-09-25 14:34 UTC (3+ messages)
` [PATCH v2 1/1] braille: nbcon: Allow to use a serial console with NBCON API as Braille console
[PATCH] tty: atmel: Replace SIMPLE_DEV_PM_OPS with DEFINE_SIMPLE_DEV_PM_OPS
2026-09-25 13:40 UTC (2+ messages)
[PATCH v2] serial: sc16is7xx: fix TX gap caused by kfifo circular buffer wrap-around
2026-09-25 13:04 UTC (3+ messages)
[PATCH v3 3/3] serial: core: reject baud_base values that overflow port->uartclk in uart_set_info()
2026-09-24 20:24 UTC (3+ messages)
` [PATCH v4] "
[PATCH -next] serial: core: fix NULL/dangling port_dev on failed re-register
2026-09-24 14:37 UTC (4+ messages)
[linux-next:master] [serial] d353934702: BUG:kernel_reboot-without-warning_in_test_stage
2026-09-24 13:10 UTC (5+ messages)
[PATCH v4 0/3] serial: fix IRQ chain race, baud fallback, and uartclk overflow
2026-09-24 12:29 UTC (6+ messages)
` [PATCH v4 2/3] serial: core: allow third iteration in uart_get_baud_rate() fallback
` [PATCH v4 3/3] serial: core: reject baud_base values that overflow port->uartclk in uart_set_info()
[PATCH v1 0/2] serial: 8250_port: Update runtime PM flow
2026-09-24 12:20 UTC (3+ messages)
[PATCH] serial: ma35d1: unmap MMIO on remove
2026-09-24 11:11 UTC (2+ messages)
[PATCH v3 0/4] Add support for the Mediatek Genio 520-EVK and 720-EVK boards
2026-09-24 8:54 UTC (7+ messages)
` [PATCH v3 2/4] dt-bindings: arm: mediatek: add Mediatek Genio 520/720-EVK boards
` [PATCH v3 3/4] arm64: dts: mediatek: add Genio 720-EVK board
` [PATCH v3 4/4] arm64: dts: mediatek: add Genio 520-EVK board
page: next (older) | prev (newer) | latest
- recent:[subjects (threaded)|topics (new)|topics (active)]
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox