messages from 2026-10-02 07:29:41 to 2026-10-08 14:09:07 UTC [more...]
[PATCH v2] dt-bindings: serial: snps-dw-apb-uart: Add Synaptics sl2610 uart
2026-10-08 13:49 UTC (4+ messages)
[PATCH] serial: 8250_pci: Add support for ASPEED BMC VUARTs over PCIe
2026-10-08 13:38 UTC (2+ messages)
[PATCH v8 0/9] serial: max310x: RS485 delay and RTS fixes, software-timed delays
2026-10-08 10:04 UTC (19+ messages)
` [PATCH v8 1/9] serial: max310x: don't clobber the TX break bit in set_termios
` [PATCH v8 2/9] serial: max310x: fix breaks not reaching the wire in RS485 mode
` [PATCH v8 3/9] serial: max310x: centralize the RS485 transceiver programming
` [PATCH v8 4/9] serial: max310x: fix RS485 delays being programmed as bit-times
` [PATCH v8 5/9] serial: max310x: don't power down the port mid-transmission on close
` [PATCH v8 6/9] serial: max310x: support active-low RTS on the hardware path
` [PATCH v8 7/9] serial: max310x: schedule tx_work directly from the IRQ handler
` [PATCH v8 8/9] serial: max310x: drive RTS in software when hardware delays are too short
` [PATCH v8 9/9] serial: max310x: don't transmit while an RS485 reconfigure is pending
[PATCH v7 0/9] (no cover subject)
2026-10-08 9:06 UTC (25+ messages)
` [PATCH v7 1/9] serial: max310x: don't clobber the TX break bit in set_termios
` [PATCH v7 2/9] serial: max310x: assert the transceiver during a break
` [PATCH v7 3/9] serial: max310x: centralize the RS485 transceiver programming
` [PATCH v7 4/9] serial: max310x: convert RS485 delays from milliseconds to bit-times
` [PATCH v7 5/9] serial: max310x: stop the transmitter before powering down in shutdown
` [PATCH v7 6/9] serial: max310x: support active-low RTS on the hardware path
` [PATCH v7 7/9] serial: max310x: schedule tx_work directly from the IRQ handler
` [PATCH v7 8/9] serial: max310x: drive RTS in software when hardware delays are too short
` [PATCH v7 9/9] serial: max310x: don't transmit while an RS485 reconfigure is pending
[PATCH v2 0/9] soc: qcom: geni: Derive SE clock configuration from OPP table on SA8255P
2026-10-08 7:35 UTC (7+ messages)
` [PATCH v2 2/9] soc: qcom: geni-se: Populate clk_perf_tbl with SE source clock frequencies from perf OPP table
` [PATCH v2 4/9] soc: qcom: geni-se: Remove OPP rate reset from resource deactivation
` [PATCH v2 5/9] serial: qcom-geni: Use geni_se_set_rate() for source clock configuration
[PATCH v7 0/2] serial: core: fix baud rate fallback loop and baud_base overflow
2026-10-07 20:27 UTC (11+ messages)
` [PATCH v7 1/2] serial: core: fix baud rate fallback in uart_get_baud_rate()
` [PATCH v7 2/2] serial: core: reject baud_base values that overflow port->uartclk in uart_set_info()
[PATCH v8 0/2] serial: core: fix baud rate fallback loop and baud_base overflow
2026-10-07 14:13 UTC (5+ messages)
` [PATCH v8 1/2] serial: core: fix baud rate fallback in uart_get_baud_rate()
` [PATCH v8 2/2] serial: core: reject baud_base values that overflow port->uartclk in uart_set_info()
[PATCH RFC v2 00/10] ARM: Add support for Cortina Systems CS75xx and Securifi Almond+
2026-10-07 11:42 UTC (25+ messages)
` [PATCH RFC v2 01/10] dt-bindings: vendor-prefixes: Add Securifi
` [PATCH RFC v2 02/10] dt-bindings: arm: Add Cortina Systems CS7542 and Securifi Almond+
` [PATCH RFC v2 03/10] dt-bindings: arm: cpus: Add Cortina Systems CS7542 enable method
` [PATCH RFC v2 04/10] ARM: goldengate: Add support for the CS75xx SoC family
` [PATCH RFC v2 05/10] ARM: debug: Add Cortina Systems CS75xx UART0 support
` [PATCH RFC v2 06/10] dt-bindings: serial: Add Cortina Systems CS7542 UART
` [PATCH RFC v2 07/10] tty: serial: Add Cortina UART driver
` [PATCH RFC v2 08/10] ARM: dts: cortina: Add CS7542 SoC and Securifi Almond+ board
` [PATCH RFC v2 09/10] ARM: multi_v7_defconfig: Enable Cortina Systems CS75xx support
` [PATCH RFC v2 10/10] MAINTAINERS: Add entry for Cortina Systems CS75xx
[PATCH 0/3] serial: 8250_dw: Allwinner A733 UART support
2026-10-07 10:36 UTC (15+ messages)
` [PATCH 1/3] serial: 8250_dw: Keep the BUSY-safe divisor hook when DLF is present
` [PATCH 2/3] dt-bindings: serial: snps-dw-apb-uart: Add Allwinner A733
` [PATCH 3/3] serial: 8250_dw: Add Allwinner A733 UART
fund transfer opportunity,Reply
2026-10-06 21:55 UTC
[PATCH] serial: sc16is7xx: declare MCR and IER as volatile registers
2026-10-06 19:36 UTC (2+ messages)
[tty:tty-next] BUILD SUCCESS 36844ea19656fb41278799ef3d5cd52120d89149
2026-10-06 2:47 UTC
[syzbot] Monthly serial report (Oct 2026)
2026-10-05 20:33 UTC
[PATCH v6 0/9] serial: max310x: RS485 delay and RTS fixes, software-timed delays
2026-10-05 15:45 UTC (22+ messages)
` [PATCH v6 1/9] serial: max310x: don't clobber the TX break bit in set_termios
` [PATCH v6 2/9] serial: max310x: assert the transceiver during a break
` [PATCH v6 3/9] serial: max310x: centralize the RS485 transceiver programming
` [PATCH v6 4/9] serial: max310x: convert RS485 delays from milliseconds to bit-times
` [PATCH v6 5/9] serial: max310x: wait for TX to drain before powering down in shutdown
` [PATCH v6 6/9] serial: max310x: support active-low RTS on the hardware path
` [PATCH v6 7/9] serial: max310x: schedule tx_work directly from the IRQ handler
` [PATCH v6 8/9] serial: max310x: drive RTS in software when hardware delays are too short
` [PATCH v6 9/9] serial: max310x: don't transmit while an RS485 reconfigure is pending
[PATCH v4 0/5] fbcon,vgacon,vt: Share helpers for text cursors
2026-10-05 13:40 UTC (11+ messages)
` [PATCH v4 1/5] vt: Add cursor-size helpers
` [PATCH v4 2/5] vgacon: Remove trailing whitespaces
` [PATCH v4 3/5] vgacon: Use vt_cursor_{start,end}()
` [PATCH v4 4/5] lib/fonts: Add font_glyph_cursor() helper
` [PATCH v4 5/5] fbcon: Replace fbcon_fill_cursor_mask() with fbcon_cursor_glyph()
[PATCH 00/20] arm64: add Synaptics SL261X SoCs and RDK boards
2026-10-05 10:50 UTC (7+ messages)
` [PATCH 08/20] dt-bindings: reset: add Synaptics SL261X SoCs
[PATCH v2] serial: 8250_uniphier: Use devm_clk_get_enabled()
2026-10-05 6:55 UTC (8+ messages)
Your Consent
2026-10-05 6:37 UTC
[PATCH 0/7] sparc64: add Fujitsu M3000 support
2026-10-04 15:24 UTC (5+ messages)
` [PATCH 7/7] hvc: add an M3000 firmware console backend
[PATCH] tty: pty: preserve open slaves after rejected locked open
2026-10-04 12:45 UTC (4+ messages)
` [PATCH v2] "
[PATCH v5 0/8] serial: max310x: RS485 delay and RTS fixes, software-timed delays
2026-10-04 10:56 UTC (11+ messages)
` [PATCH v5 1/8] serial: max310x: don't clobber the TX break bit in set_termios
` [PATCH v5 4/8] serial: max310x: wait for TX to drain before powering down in shutdown
[PATCH 01/11] params: bound array element output to the caller's page buffer
2026-10-04 10:47 UTC (2+ messages)
[tty:tty-linus] BUILD SUCCESS 6c95ca52f27855dd2fb74131c8d4e8325d2af7de
2026-10-04 4:57 UTC
[PATCH v3] serial: hvc: use modern IRQ acquisition API
2026-10-03 21:41 UTC (2+ messages)
[PATCH] serial: cpm_uart: use irq variable for platform_get_irq()
2026-10-03 21:32 UTC (5+ messages)
[PATCH] serial: core: shut down initialized port on removal
2026-10-03 17:56 UTC (3+ messages)
` [PATCH v2] "
[PATCH v2] serial: fsl_lpuart: add support for GPIO-controlled modem lines
2026-10-03 17:56 UTC (2+ messages)
[GIT PULL] TTY/Serial driver updates for 7.3-rc6
2026-10-03 16:24 UTC (2+ messages)
[PATCH 1/1] tty: serial: pch_uart: use dmaengine_submit() instead of ->tx_submit()
2026-10-03 15:04 UTC (3+ messages)
[PATCH 26/38] mfd: ioc3: add support for IOC4
2026-10-03 1:33 UTC (2+ messages)
[tty:tty-testing] BUILD SUCCESS c44a4925cdac02af781ebfae96df68a7bf3580b0
2026-10-02 20:44 UTC
[PATCH v2 0/3] Remove obsolete __MODULE_STRING()
2026-10-02 14:05 UTC (10+ messages)
` [PATCH v2 1/3] hwmon: Replace __MODULE_STRING() with __stringify()
` [PATCH v2 2/3] drivers: "
` [PATCH v2 3/3] module: Remove obsolete __MODULE_STRING()
[PATCH v2 RESEND] serial: sc16is7xx: fix TX gap caused by kfifo circular buffer wrap-around
2026-10-02 11:38 UTC (3+ messages)
[PATCH v2] MIPS: SGI-IP27: print the NMI dump on an nbcon console
2026-10-02 9:30 UTC (4+ messages)
[PATCH v9 00/15] Ambarella CV75 SoC minimal bring-up
2026-10-02 9:22 UTC (14+ messages)
` [PATCH v9 06/15] clk: ambarella: add CV75 RCT clock controller
` [PATCH v9 07/15] gpiolib: regmap: add GPIO_REGMAP_QUIRK_SET_AFTER_DIR
` [PATCH v9 08/15] gpio: pl061: convert register access to regmap
` [PATCH v9 09/15] gpio: pl061: use IRQ_TYPE_LEVEL_MASK and IRQ_TYPE_EDGE_BOTH
` [PATCH v9 13/15] serial: 8250_dw: add Ambarella CV75 quirks
` "
[PATCH] tty: add missing driver flag kernel-doc colon
2026-10-02 9:14 UTC (2+ messages)
[PATCH v4 0/1] braille: nbcon: Fix Braille console for NBCON API
2026-10-02 9:13 UTC (7+ messages)
` [PATCH v4 1/1] braille: nbcon: Allow to use a serial console with NBCON API as Braille console
[PATCH 0/2] serial: tegra: fix RX/TX DMA descriptor use-after-free
2026-10-02 9:13 UTC (5+ messages)
` [PATCH 1/2] serial: tegra: fix RX "
` [PATCH 2/2] serial: tegra: fix TX "
[tty:tty-linus] BUILD SUCCESS 39495ef5d6f8019e62d65807f217a7ca8232727a
2026-10-02 9:12 UTC
linux-next: Tree for Sep 30 (htmldocs: include/linux/tty_driver.h)
2026-10-02 7:29 UTC (2+ messages)
page: next (older) | prev (newer) | latest
- recent:[subjects (threaded)|topics (new)|topics (active)]
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox