messages from 2026-10-12 11:30:04 to 2026-10-13 17:54:01 UTC [more...]
[PATCH v8 00/18] Ambarella CV75 SoC minimal bring-up
2026-10-13 17:51 UTC (11+ messages)
` [PATCH v8 04/18] dt-bindings: pinctrl: add Ambarella CV75 pinctrl
` "
` "
` "
[PATCH] serial: core: shut down initialized port on removal
2026-10-13 16:45 UTC (3+ messages)
` [PATCH v2] "
[PATCH v2] serial: core: Shut down a running console port before removing it
2026-10-13 16:42 UTC (4+ messages)
[PATCH v2] nbcon/reboot: Switch NBCON consoles into the emergency mode in emergency_restart()
2026-10-13 16:09 UTC (3+ messages)
[PATCH] serial: sc16is7xx: declare MCR and IER as volatile registers
2026-10-13 15:33 UTC (3+ messages)
[PATCH v2] tty: hvc: dcc: Detect JTAG connection only on CPU core 0
2026-10-13 15:15 UTC (2+ messages)
[PATCH] tty: hvc: dcc: Detect JTAG connection only on CPU core 0
2026-10-13 14:53 UTC (4+ messages)
[PATCH v2 00/53] MIPS: SGI-IP27: add support for the IP35 (Bedrock hub) machines
2026-10-13 14:25 UTC (4+ messages)
` [PATCH v2 31/53] mfd: ioc3: Add support for IOC4
[PATCH v2 0/6] serial: 8250: make port operations work on struct uart_8250_port
2026-10-13 13:42 UTC (17+ messages)
` [PATCH v2 1/6] serial: 8250: drop err label from serial8250_register_8250_port()
` [PATCH v2 2/6] serial: 8250_exar: remove useless void * casts
` [PATCH v2 3/6] serial: 8250_exar: store the GPIO platform device in struct exar8250
` [PATCH v2 4/6] serial: 8250_lpss: do not touch uninitialized line in ehl_serial_exit()
` [PATCH v2 5/6] serial: 8250_omap: set priv->line before enabling the IRQ
` [PATCH v2 6/6] serial: 8250: make port operations work on struct uart_8250_port
[PATCH v2] serial: amba-pl011: drive the bus during break in RS485 mode
2026-10-13 13:40 UTC (2+ messages)
finally caught up on linux-serial submitted patches
2026-10-13 13:26 UTC
[PATCH] serial: amba-pl011: drive the bus during break in RS485 mode
2026-10-13 13:22 UTC (2+ messages)
[PATCH v2] dt-bindings: serial: snps-dw-apb-uart: Add Synaptics sl2610 uart
2026-10-13 13:18 UTC (2+ messages)
[PATCH v2 0/1] serial: core: Don't clobber the baud rate on hangup via B0
2026-10-13 13:16 UTC (5+ messages)
` [PATCH v2 1/1] "
[PATCH] serial: core: Shut down a running console port before removing it
2026-10-13 13:14 UTC (2+ messages)
[PATCH v6 0/6] soc: aspeed: Add BMC and host driver for PCIe BMC device
2026-10-13 13:09 UTC (5+ messages)
` [PATCH v6 4/6] mfd: aspeed-pci-core: add AST2600 PCIe BMC device driver
[PATCH v3 0/8] sparc64: add Fujitsu M3000 support
2026-10-13 13:04 UTC (18+ messages)
` [PATCH v3 1/8] sparc64: return from the generic clear_page implementation
` [PATCH v3 2/8] sparc64: honor queued spinlock layout in secondary startup
` [PATCH v3 3/8] sparc64: avoid huge kernel PUD mappings on sun4u
` [PATCH v3 4/8] sparc64: stop IRQ setup when descriptor allocation fails
` [PATCH v3 5/8] sparc64: validate Fire register properties before initialization
` [PATCH v3 6/8] sparc64: add SPARC64 VII CPU, MMU and SMP support
` [PATCH v3 7/8] sparc64: add M3000 Oberon PCIe support
` [PATCH v3 8/8] hvc: add an M3000 firmware console backend
[PATCH 0/5] serial: mcf: add devicetree support
2026-10-13 12:49 UTC (11+ messages)
` [PATCH 1/5] serial: mcf: update author email address
` [PATCH 2/5] serial: mcf: convert to use proper platform resources
` [PATCH 3/5] serial: mcf: dynamically allocate memory
` [PATCH 4/5] dt-bindings: serial: create binding for mcf-uart
` [PATCH 5/5] serial: mcf: add devicetree support
[PATCH 00/11] Add NVIDIA LSTP USB adapter drivers
2026-10-13 11:39 UTC (6+ messages)
` [PATCH 10/11] tty: Add NVIDIA LSTP UART driver
[PATCH v6 00/10] ARM: Add support for Cortina Systems CS75xx and Securifi Almond+
2026-10-13 9:07 UTC (24+ messages)
` [PATCH v6 01/10] dt-bindings: vendor-prefixes: Add Securifi
` [PATCH v6 02/10] dt-bindings: arm: Add Cortina Systems CS7542 and Securifi Almond+
` [PATCH v6 03/10] dt-bindings: arm: cpus: Add Cortina Systems CS7542 enable method
` [PATCH v6 04/10] ARM: goldengate: Add support for the CS75xx SoC family
` [PATCH v6 05/10] ARM: debug: Add Cortina Systems CS75xx UART0 support
` [PATCH v6 06/10] dt-bindings: serial: Add Cortina Systems CS7542 UART
` [PATCH v6 07/10] tty: serial: Add Cortina UART driver
` [PATCH v6 08/10] ARM: dts: cortina: Add CS7542 SoC and Securifi Almond+ board
` [PATCH v6 09/10] ARM: multi_v7_defconfig: Enable Cortina Systems CS75xx support
` [PATCH v6 10/10] MAINTAINERS: Add entry for Cortina Systems CS75xx
[PATCH v5 00/10] ARM: Add support for Cortina Systems CS75xx and Securifi Almond+
2026-10-13 3:57 UTC (20+ messages)
` [PATCH v5 01/10] dt-bindings: vendor-prefixes: Add Securifi
` [PATCH v5 02/10] dt-bindings: arm: Add Cortina Systems CS7542 and Securifi Almond+
` [PATCH v5 03/10] dt-bindings: arm: cpus: Add Cortina Systems CS7542 enable method
` [PATCH v5 04/10] ARM: goldengate: Add support for the CS75xx SoC family
` [PATCH v5 05/10] ARM: debug: Add Cortina Systems CS75xx UART0 support
` [PATCH v5 06/10] dt-bindings: serial: Add Cortina Systems CS7542 UART
` [PATCH v5 07/10] tty: serial: Add Cortina UART driver
` [PATCH v5 08/10] ARM: dts: cortina: Add CS7542 SoC and Securifi Almond+ board
` [PATCH v5 09/10] ARM: multi_v7_defconfig: Enable Cortina Systems CS75xx support
` [PATCH v5 10/10] MAINTAINERS: Add entry for Cortina Systems CS75xx
[PATCH 0/2] serial: pmac_zilog: two receive fixes
2026-10-13 1:48 UTC (5+ messages)
` [PATCH 1/2] serial: pmac_zilog: push received data to the port that received it
` [PATCH 2/2] serial: pmac_zilog: report received breaks
[PATCH v1 1/1] Revert "serial: 8250_port: Drop duplicate NULL check"
2026-10-12 20:28 UTC (2+ messages)
[PATCH] serial: 8250_pci: Add support for ASPEED BMC VUARTs over PCIe
2026-10-12 19:57 UTC (7+ messages)
[PATCH v4 00/10] ARM: Add support for Cortina Systems CS75xx and Securifi Almond+
2026-10-12 17:40 UTC (20+ messages)
` [PATCH v4 01/10] dt-bindings: vendor-prefixes: Add Securifi
` [PATCH v4 02/10] dt-bindings: arm: Add Cortina Systems CS7542 and Securifi Almond+
` [PATCH v4 03/10] dt-bindings: arm: cpus: Add Cortina Systems CS7542 enable method
` [PATCH v4 04/10] ARM: goldengate: Add support for the CS75xx SoC family
` [PATCH v4 05/10] ARM: debug: Add Cortina Systems CS75xx UART0 support
` [PATCH v4 06/10] dt-bindings: serial: Add Cortina Systems CS7542 UART
` [PATCH v4 07/10] tty: serial: Add Cortina UART driver
` [PATCH v4 08/10] ARM: dts: cortina: Add CS7542 SoC and Securifi Almond+ board
` [PATCH v4 09/10] ARM: multi_v7_defconfig: Enable Cortina Systems CS75xx support
` [PATCH v4 10/10] MAINTAINERS: Add entry for Cortina Systems CS75xx
[PATCH 0/2] vt: Simplify console-blanking interface
2026-10-12 16:13 UTC (9+ messages)
` [PATCH 1/2] vt: Use boolean as parameter to do_blank_screen() and do_unblank_screen()
` [PATCH 2/2] vt: Distinguish between blanking and VESA blank mode in con_blank
[PATCH v2 0/6] sparc64: add Fujitsu M3000 support
2026-10-12 14:57 UTC (4+ messages)
` [PATCH v2 6/6] hvc: add an M3000 firmware console backend
[PATCH v2] serial: amba-pl011: keep transmitter enabled when disabling RS485
2026-10-12 14:34 UTC (2+ messages)
[PATCH] nbcon/reboot: Flush nbcon consoles synchronously on reboot
2026-10-12 14:14 UTC (5+ messages)
[PATCH] serial: 8250_dw: retain programmed timing for BUSY waits
2026-10-12 12:08 UTC (2+ messages)
page: | prev (newer) | latest
- recent:[subjects (threaded)|topics (new)|topics (active)]
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox