messages from 2026-10-19 07:51:45 to 2026-10-21 17:15:08 UTC [more...]
[PATCH 00/27] rockchip: Add RK3572 and Forlinx OK3572-C support
2026-10-21 17:14 UTC (30+ messages)
` [PATCH 01/27] dt-bindings: clock: rockchip: Add RK3572 CRU
` [PATCH 02/27] dt-bindings: power: rockchip: Add RK3572 power domains
` [PATCH 03/27] dt-bindings: soc: rockchip: Add RK3572 PMU and GRF
` [PATCH 04/27] dt-bindings: mfd: syscon: Add RK3572 QoS register compatible
` [PATCH 05/27] dt-bindings: pinctrl: rockchip: Add RK3572
` [PATCH 06/27] dt-bindings: gpio: rockchip: Add RK3572 GPIO banks
` [PATCH 07/27] clk: rockchip: Add RK3572 clock and reset support
` [PATCH 08/27] pinctrl: rockchip: Add RK3572 support
` [PATCH 09/27] gpio: rockchip: Add RK3572 GPIO support
` [PATCH 10/27] pmdomain: rockchip: Add RK3572 boot peripheral domains
` [PATCH 11/27] dt-bindings: i2c: rk3x: Add RK3572
` [PATCH 12/27] dt-bindings: serial: snps-dw-apb-uart: "
` [PATCH 13/27] dt-bindings: mmc: rockchip: Add RK3572 controllers
` [PATCH 14/27] dt-bindings: net: rockchip-dwmac: Add RK3572
` [PATCH 15/27] dt-bindings: thermal: rockchip: "
` [PATCH 16/27] net: stmmac: dwmac-rk: Add RK3572 support
` [PATCH 17/27] thermal: rockchip: "
` [PATCH 18/27] dt-bindings: phy: rockchip-inno-usb2: Add RK3572
` [PATCH 19/27] dt-bindings: phy: rockchip-naneng-combphy: "
` [PATCH 20/27] dt-bindings: usb: rockchip: Add RK3572 DWC3 controller
` [PATCH 21/27] phy: rockchip-inno-usb2: Add RK3572 support
` [PATCH 22/27] phy: rockchip-naneng-combphy: "
` [PATCH 23/27] usb: dwc3: Configure RK3572 PIPE port before discovery
` [PATCH 24/27] mmc: dw_mmc-rockchip: Keep RK3572 NVM domain powered
` [PATCH 25/27] dt-bindings: arm: rockchip: Add Forlinx OK3572-C
` [PATCH 26/27] arm64: dts: rockchip: Add RK3572 SoC
` [PATCH 27/27] arm64: dts: rockchip: Add initial support for Forlinx OK3572-C
[PATCH v2 0/4] serial: 8250_dw: Allwinner A733 UART support
2026-10-21 17:04 UTC (26+ messages)
` [PATCH v2 1/4] serial: 8250_dw: Keep the BUSY-safe divisor hook when DLF is present
` [PATCH v2 2/4] serial: 8250_dw: Only accept a contiguous DLF readback
` [PATCH v2 3/4] dt-bindings: serial: snps-dw-apb-uart: Add Allwinner A733
` [PATCH v2 4/4] serial: 8250_dw: Add Allwinner A733 UART
[PATCH v2 1/3] serdev: handle devices without an ACPI or device tree node
2026-10-21 15:08 UTC (9+ messages)
` [PATCH v2 2/3] platform/x86: dell-uart-backlight: Bind through normal serdev matching
` [PATCH v2 3/3] platform/x86: lenovo-yoga-tab2-pro-1380-fastcharger: "
[PATCH v2 00/53] MIPS: SGI-IP27: add support for the IP35 (Bedrock hub) machines
2026-10-21 14:39 UTC (9+ messages)
` [PATCH v2 31/53] mfd: ioc3: Add support for IOC4
[PATCH v2 0/4] Fix transmit handling on SCI/RSCI ports
2026-10-21 13:38 UTC (9+ messages)
` [PATCH v2 1/4] serial: sh-sci: Drop TE disable at end of transmission on SCI
` [PATCH v2 2/4] serial: sh-sci: Keep TX enabled on TEI while data is pending
` [PATCH v2 3/4] serial: sh-sci: Skip TDxE clear when hardware clears it automatically
` [PATCH v2 4/4] serial: sh-sci: Toggle TE when restoring SCSCR in console write on SCI
[PATCH v4 0/2] serial: amba-pl011: fix RS485 state on enable and reconfiguration
2026-10-21 12:19 UTC (6+ messages)
` [PATCH v4 1/2] serial: amba-pl011: finish a transmission still running when RS485 is enabled
` [PATCH v4 2/2] serial: amba-pl011: keep RS485 transmission running on reconfiguration
[PATCH] serial: amba-pl011: end an RS485 transmission when TX is flushed
2026-10-21 12:06 UTC (2+ messages)
[PATCH 1/2] [v4] serial: 8250: remove obsolete PORT_RSA support
2026-10-21 9:27 UTC (5+ messages)
` [PATCH 2/2] [v4] serial: 8250: remove hub6 multiport support
[PATCH] [v3] serial: 8250: remove obsolete and broken PORT_RSA support
2026-10-21 8:50 UTC (10+ messages)
[PATCH] serdev: handle devices without an ACPI or device tree node
2026-10-21 6:05 UTC (3+ messages)
[PATCH 0/2] serial: core: add transceiver interface select GPIO
2026-10-21 5:41 UTC (5+ messages)
` [PATCH 1/2] dt-bindings: serial: rs485: Add "
` [PATCH 2/2] serial: core: Drive the "
[PATCH] serial: qcom-geni: Clear pending IRQs while suspended
2026-10-21 4:11 UTC (2+ messages)
[PATCH v3 0/2] tty: sysrq: fix the reset sequence state kept per input device
2026-10-21 2:34 UTC (5+ messages)
` [PATCH v3 1/2] tty: sysrq: reparse the reset sequence when its length changes
` [PATCH v3 2/2] tty: sysrq: reset the per-device key state when reparsing reset_seq
[PATCH] selftests/tty: tiocsti: expect the privileged parent to succeed
2026-10-21 2:03 UTC (2+ messages)
[PATCH 0/5] serial: core: fixes and improvements to uart_get_baud_rate()
2026-10-20 18:57 UTC (11+ messages)
` [PATCH 1/5] serial: core: fix division by zero if old termios is present but has invalid rate
` [PATCH 2/5] serial: core: clip out-of-range baud rate to min/max, not min+1/max-1
` [PATCH 3/5] serial: core: always return in-range baud rate even in case of failure
` [PATCH 4/5] serial: core: avoid redundant baud assignment without any UPF_SPD_* flags
` [PATCH 5/5] serial: core: refactor uart_get_baud_rate() for readability
[PATCH 00/20] arm64: add Synaptics SL261X SoCs and RDK boards
2026-10-20 17:47 UTC (8+ messages)
` [PATCH 04/20] dt-bindings: i3c: dw: support up to two reset lines
` [PATCH 05/20] i3c: dw: switch to array-based exclusive reset control
[PATCH 0/4] Fix transmit handling on SCI/RSCI ports
2026-10-20 15:28 UTC (13+ messages)
` [PATCH 1/4] serial: sh-sci: Drop TE disable at end of transmission on SCI
` [PATCH 2/4] serial: sh-sci: Don’t disable TX on TEI while the xmit kfifo still holds data
` [PATCH 3/4] serial: sh-sci: Skip TDxE status clear for PORT_SCI
` [PATCH 4/4] serial: sh-sci: Toggle TE when restoring SCSCR in console write on SCI
[PATCH] tty: atmel: Replace SIMPLE_DEV_PM_OPS with DEFINE_SIMPLE_DEV_PM_OPS
2026-10-20 9:22 UTC (4+ messages)
[PATCH] tty: atmel: Replace SIMPLE_DEV_PM_OPS with DEFINE_SIMPLE_DEV_PM_OPS
2026-10-20 8:34 UTC (4+ messages)
[linux-next:master] [serial] d353934702: BUG:kernel_reboot-without-warning_in_test_stage
2026-10-20 7:27 UTC (5+ messages)
[PATCH 0/8] arm64: Initial support for MediaTek MT8163 SoC
2026-10-20 1:41 UTC (14+ messages)
` [PATCH 1/8] dt-bindings: arm: mediatek: Add MT8163 Amazon Echo Dot (2016)
` [PATCH 2/8] dt-bindings: interrupt-controller: mediatek,mt6577-sysirq: Add MT8163
` [PATCH 3/8] dt-bindings: timer: mediatek,timer: "
` [PATCH 4/8] dt-bindings: serial: mediatek,uart: "
` [PATCH 5/8] dt-bindings: watchdog: mediatek,mtk-wdt: "
` [PATCH 6/8] watchdog: mediatek: Add support for MT8163 TOPRGU/WDT
[PATCH 0/3] vt: make VS16 emoji widening controllable
2026-10-19 21:23 UTC (7+ messages)
` [PATCH 1/3] vt: don't make VS16 widening depend on earlier screen contents
` [PATCH 2/3] vt: add DEC private mode 2027 to control VS16 widening
` [PATCH 3/3] vt: add DECRQM support to report mode states
[PATCH AUTOSEL 6.18-5.10] tty: serial: pch_uart: add check for pci_get_slot()
2026-10-19 15:51 UTC (6+ messages)
` [PATCH AUTOSEL 6.18-6.12] serial: 8250: force synchronous probe for the ISA and PNP drivers
` [PATCH AUTOSEL 6.18-6.6] serial: qcom_geni: Disable closing_wait for console to prevent shutdown timeout
[PATCH] [v3] serial: 8250: remove hub6 multiport support
2026-10-19 15:08 UTC (3+ messages)
tty: timbuart: tasklet may trigger UAF during remove
2026-10-19 14:16 UTC (4+ messages)
` [PATCH] tty: timbuart: kill tasklet after freeing IRQ
tty: timbuart: tasklet may trigger UAF during remove
2026-10-19 11:42 UTC
serial: pch_uart: possible TX DMA use-after-free race
2026-10-19 11:48 UTC (2+ messages)
tty: hvc: possible use-after-free in resize work during hvc_remove()
2026-10-19 10:05 UTC
[PATCH v3 0/2] serial: amba-pl011: fix RS485 state on enable and reconfiguration
2026-10-19 9:58 UTC (5+ messages)
` [PATCH v3 1/2] serial: amba-pl011: finish a transmission still running when RS485 is enabled
` [PATCH v3 2/2] serial: amba-pl011: keep RS485 transmission running on reconfiguration
serial: pch_uart: possible RX DMA buffer use-after-free during shutdow
2026-10-19 9:41 UTC
[PATCH 1/2] tty: serial: remove hub6 multiport support
2026-10-19 9:09 UTC (8+ messages)
page: next (older) | prev (newer) | latest
- recent:[subjects (threaded)|topics (new)|topics (active)]
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox