messages from 2026-10-20 18:43:26 to 2026-10-22 19:03:20 UTC [more...]
[PATCH v2 0/4] dmaengine: dw: serialize completion and termination
2026-10-22 19:03 UTC (7+ messages)
` [PATCH v2 1/4] dmaengine: dw: Prevent tx-status calling DMA-desc callback
` [PATCH v2 2/4] dmaengine: dw: Fix XFER bit set, but channel not idle error
` [PATCH v2 3/4] dmaengine: dw: serialize error recovery with channel termination
` [PATCH v2 4/4] dmaengine: dw: synchronize completion callbacks
[PATCH] serial: 8250: release the transmit PM reference on shutdown
2026-10-22 17:25 UTC (2+ messages)
[PATCH] serial: 8250: calculate TX length before preparing DMA flow control
2026-10-22 17:18 UTC (2+ messages)
[PATCH 00/27] rockchip: Add RK3572 and Forlinx OK3572-C support
2026-10-22 16:13 UTC (65+ messages)
` [PATCH 01/27] dt-bindings: clock: rockchip: Add RK3572 CRU
` [PATCH 02/27] dt-bindings: power: rockchip: Add RK3572 power domains
` [PATCH 03/27] dt-bindings: soc: rockchip: Add RK3572 PMU and GRF
` [PATCH 04/27] dt-bindings: mfd: syscon: Add RK3572 QoS register compatible
` [PATCH 05/27] dt-bindings: pinctrl: rockchip: Add RK3572
` [PATCH 06/27] dt-bindings: gpio: rockchip: Add RK3572 GPIO banks
` [PATCH 07/27] clk: rockchip: Add RK3572 clock and reset support
` [PATCH 08/27] pinctrl: rockchip: Add RK3572 support
` [PATCH 09/27] gpio: rockchip: Add RK3572 GPIO support
` [PATCH 10/27] pmdomain: rockchip: Add RK3572 boot peripheral domains
` [PATCH 11/27] dt-bindings: i2c: rk3x: Add RK3572
` [PATCH 12/27] dt-bindings: serial: snps-dw-apb-uart: "
` [PATCH 13/27] dt-bindings: mmc: rockchip: Add RK3572 controllers
` [PATCH 14/27] dt-bindings: net: rockchip-dwmac: Add RK3572
` [PATCH 15/27] dt-bindings: thermal: rockchip: "
` [PATCH 16/27] net: stmmac: dwmac-rk: Add RK3572 support
` [PATCH 17/27] thermal: rockchip: "
` [PATCH 18/27] dt-bindings: phy: rockchip-inno-usb2: Add RK3572
` [PATCH 19/27] dt-bindings: phy: rockchip-naneng-combphy: "
` [PATCH 20/27] dt-bindings: usb: rockchip: Add RK3572 DWC3 controller
` [PATCH 21/27] phy: rockchip-inno-usb2: Add RK3572 support
` [PATCH 22/27] phy: rockchip-naneng-combphy: "
` [PATCH 23/27] usb: dwc3: Configure RK3572 PIPE port before discovery
` [PATCH 24/27] mmc: dw_mmc-rockchip: Keep RK3572 NVM domain powered
` [PATCH 25/27] dt-bindings: arm: rockchip: Add Forlinx OK3572-C
` [PATCH 26/27] arm64: dts: rockchip: Add RK3572 SoC
` [PATCH 27/27] arm64: dts: rockchip: Add initial support for Forlinx OK3572-C
[PATCH 0/2] serial: 8250: serialize DMA cancellation with buffer reuse
2026-10-22 15:20 UTC (8+ messages)
` [PATCH 1/2] serial: 8250: drain canceled TX DMA before reusing its buffer
` [PATCH 2/2] serial: 8250: retire canceled RX DMA before reusing the receive buffer
[PATCH] [v3] serial: 8250: remove obsolete and broken PORT_RSA support
2026-10-22 13:54 UTC (8+ messages)
[GIT PULL] TTY/Serial driver updates for 7.4-rc1
2026-10-22 13:50 UTC
[PATCH 00/11] Add NVIDIA LSTP USB adapter drivers
2026-10-22 13:29 UTC (4+ messages)
[PATCH v4 0/4] rust: serdev: Refactor
2026-10-22 12:45 UTC (4+ messages)
` [PATCH v4 1/4] tty: serdev: Add mutex lock
[PATCH v3 0/8] soc: qcom: geni: Derive SE clock configuration from OPP table on SA8255P
2026-10-22 12:28 UTC (5+ messages)
` [PATCH v3 1/8] soc: qcom: geni-se: Populate clk_perf_tbl with SE source clock frequencies from perf OPP table
` [PATCH v3 6/8] i2c: qcom-geni: Vote for SE clock rate using OPP
[PATCH v5 0/4] rust: serdev: Refactor
2026-10-22 12:19 UTC (10+ messages)
` [PATCH v5 1/4] tty: serdev: Add mutex lock
` [PATCH v5 2/4] tty: serdev: Export functions to pause receive_buf callback calls
` [PATCH v5 3/4] rust: serdev: Replace `active` mutex with receive pause
` [PATCH v5 4/4] rust: serdev: Simplify callbacks
[PATCH v2 0/4] Fix transmit handling on SCI/RSCI ports
2026-10-22 10:29 UTC (11+ messages)
` [PATCH v2 1/4] serial: sh-sci: Drop TE disable at end of transmission on SCI
` [PATCH v2 2/4] serial: sh-sci: Keep TX enabled on TEI while data is pending
` [PATCH v2 3/4] serial: sh-sci: Skip TDxE clear when hardware clears it automatically
` [PATCH v2 4/4] serial: sh-sci: Toggle TE when restoring SCSCR in console write on SCI
[PATCH] tty: serial: core: fix synchronous external abort in uart_tiocmget() for runtime-suspended ports
2026-10-22 10:16 UTC (2+ messages)
[PATCH v2] usb: gadget: u_serial: pin ports while TTYs are installed
2026-10-22 9:37 UTC (2+ messages)
[PATCH] serial: qcom-geni: Set UPSTAT_AUTOCTS for hardware flow control
2026-10-22 3:59 UTC (3+ messages)
[PATCH 0/2] tty: serial: lpuart: keep RTS deasserted while the port is being configured
2026-10-22 3:20 UTC (5+ messages)
` [PATCH 1/2] tty: serial: lpuart: deassert RTS while reconfiguring in set_termios()
` [PATCH 2/2] tty: serial: lpuart: disable hardware flow control in lpuart32_startup()
[PATCH v2 1/3] serdev: handle devices without an ACPI or device tree node
2026-10-22 3:10 UTC (12+ messages)
` [PATCH v2 2/3] platform/x86: dell-uart-backlight: Bind through normal serdev matching
` [PATCH v2 3/3] platform/x86: lenovo-yoga-tab2-pro-1380-fastcharger: "
[PATCH] serial: 8250: account for partial receive DMA delivery to TTY
2026-10-21 22:13 UTC (2+ messages)
[PATCH] serial: 8250: prevent DMA callbacks from restarting a closing port
2026-10-21 21:32 UTC (2+ messages)
[PATCH] serial: 8250: check DMA channel configuration errors
2026-10-21 21:28 UTC (2+ messages)
[PATCH v2 0/4] serial: 8250_dw: Allwinner A733 UART support
2026-10-21 18:07 UTC (22+ messages)
` [PATCH v2 1/4] serial: 8250_dw: Keep the BUSY-safe divisor hook when DLF is present
` [PATCH v2 2/4] serial: 8250_dw: Only accept a contiguous DLF readback
` [PATCH v2 3/4] dt-bindings: serial: snps-dw-apb-uart: Add Allwinner A733
[PATCH v2 00/53] MIPS: SGI-IP27: add support for the IP35 (Bedrock hub) machines
2026-10-21 14:39 UTC (9+ messages)
` [PATCH v2 31/53] mfd: ioc3: Add support for IOC4
[PATCH v4 0/2] serial: amba-pl011: fix RS485 state on enable and reconfiguration
2026-10-21 12:19 UTC (6+ messages)
` [PATCH v4 1/2] serial: amba-pl011: finish a transmission still running when RS485 is enabled
` [PATCH v4 2/2] serial: amba-pl011: keep RS485 transmission running on reconfiguration
[PATCH] serial: amba-pl011: end an RS485 transmission when TX is flushed
2026-10-21 12:06 UTC (2+ messages)
[PATCH 1/2] [v4] serial: 8250: remove obsolete PORT_RSA support
2026-10-21 9:27 UTC (5+ messages)
` [PATCH 2/2] [v4] serial: 8250: remove hub6 multiport support
[PATCH] serdev: handle devices without an ACPI or device tree node
2026-10-21 6:05 UTC (3+ messages)
[PATCH 0/2] serial: core: add transceiver interface select GPIO
2026-10-21 5:41 UTC (5+ messages)
` [PATCH 1/2] dt-bindings: serial: rs485: Add "
` [PATCH 2/2] serial: core: Drive the "
[PATCH] serial: qcom-geni: Clear pending IRQs while suspended
2026-10-21 4:11 UTC (2+ messages)
[PATCH v3 0/2] tty: sysrq: fix the reset sequence state kept per input device
2026-10-21 2:34 UTC (5+ messages)
` [PATCH v3 1/2] tty: sysrq: reparse the reset sequence when its length changes
` [PATCH v3 2/2] tty: sysrq: reset the per-device key state when reparsing reset_seq
[PATCH] selftests/tty: tiocsti: expect the privileged parent to succeed
2026-10-21 2:03 UTC (2+ messages)
[PATCH 0/5] serial: core: fixes and improvements to uart_get_baud_rate()
2026-10-20 18:57 UTC (11+ messages)
` [PATCH 1/5] serial: core: fix division by zero if old termios is present but has invalid rate
` [PATCH 2/5] serial: core: clip out-of-range baud rate to min/max, not min+1/max-1
` [PATCH 3/5] serial: core: always return in-range baud rate even in case of failure
` [PATCH 4/5] serial: core: avoid redundant baud assignment without any UPF_SPD_* flags
` [PATCH 5/5] serial: core: refactor uart_get_baud_rate() for readability
page: next (older) | prev (newer) | latest
- recent:[subjects (threaded)|topics (new)|topics (active)]
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox