messages from 2026-10-25 05:10:06 to 2026-10-27 16:18:13 UTC [more...]
[PATCH RFC 00/18] riscv: add initial Zhihe A210 support using SCMI clocks and resets
2026-10-27 16:18 UTC (38+ messages)
` [PATCH RFC 01/18] firmware: arm_scmi: Allow SCMI transports on RISC-V
` [PATCH RFC 02/18] dt-bindings: vendor-prefixes: add Zhihe
` [PATCH RFC 03/18] riscv: add Zhihe A210 support
` [PATCH RFC 04/18] dt-bindings: mailbox: add the A210 AP to E902 doorbell
` [PATCH RFC 05/18] mailbox: add A210 AP to E902 doorbell support
` [PATCH RFC 06/18] dt-bindings: pinctrl: add Zhihe A210 pin controller
` [PATCH RFC 07/18] pinctrl: zhihe: add A210 support
` [PATCH RFC 08/18] dt-bindings: interrupt-controller: add Zhihe A210 PLIC
` [PATCH RFC 09/18] dt-bindings: riscv: add Melon Pi V1 and V2
` [PATCH RFC 10/18] dt-bindings: timer: add Zhihe A210 CLINT
` [PATCH RFC 11/18] dt-bindings: firmware: add A210 SCMI clock and reset IDs
` [PATCH RFC 12/18] dt-bindings: serial: snps-dw-apb-uart: add Zhihe A210 UART
` [PATCH RFC 13/18] riscv: dts: zhihe: add A210 core support
` [PATCH RFC 14/18] riscv: dts: zhihe: add A210 UARTs
` [PATCH RFC 15/18] riscv: dts: zhihe: add A210 module memory
` [PATCH RFC 16/18] riscv: dts: zhihe: add Melon Pi V1 and V2
` [PATCH RFC 17/18] riscv: defconfig: enable A210 support
` [PATCH RFC 18/18] MAINTAINERS: add Zhihe A210
[PATCH 00/24] tty/serial: a bunch of llm-found fixes
2026-10-27 15:51 UTC (77+ messages)
` [PATCH 01/24] vt: serialise the producers of the flip buffer
` [PATCH 02/24] serial: core: respect runtime PM when sending x_char
` [PATCH 03/24] serial: 8250: don't wait for the em485 timers locked
` [PATCH 04/24] serial: 8250: don't report a wakeup to a closed tty
` [PATCH 05/24] serial: 8250: clear subdriver state on port unregister
` [PATCH 06/24] serial: 8250: add bounds check for line array in setup_serial()
` [PATCH 07/24] serial: 8250: hold hash_mutex across irq_info lookup and linking
` [PATCH 08/24] serial: 8250: cancel overrun backoff work on port shutdown and unregister
` [PATCH 09/24] serial: 8250: 8250_bcm7271: fix DMA address truncation to 32 bits
` [PATCH 10/24] serial: 8250: pericom: validate port offset against BAR length
` [PATCH 11/24] serial: 8250: cap OxSemi Tornado UART count against BAR size
` [PATCH 12/24] serial: 8250: dfl: add bounds check for device-provided regshift
` [PATCH 13/24] serial: 8250: dfl: validate MMIO resource size and regshift
` [PATCH 14/24] serial: 8250: ioc3: store registered line number in driver data
` [PATCH 15/24] serial: 8250: omap: acquire rx_dma_lock in DMA completion callback
` [PATCH 16/24] serial: 8250_lpss: don't divide by 0 above 6.25 Mbaud
` [PATCH 17/24] serial: 8250_mxpcie: handle hangup during break
` [PATCH 18/24] serial: fsl_lpuart: fix tty ref of wakeup event
` [PATCH 19/24] serial: imx: fix the tty reference of the "
` [PATCH 20/24] serial: rda: free the interrupt on shutdown
` [PATCH 21/24] serial: samsung: don't leak the tty on an RX IRQ
` [PATCH 22/24] serial: samsung: put the previous baud clock
` [PATCH 23/24] serial: st-asc: don't report a wakeup to a closed tty
` [PATCH 24/24] serial: stm32: "
[PATCH v2] tty: discard flip-buffer input for TCSAFLUSH
2026-10-27 15:39 UTC (3+ messages)
[PATCH v3 0/4] serial: 8250_dw: describe the Allwinner H616 UART configuration
2026-10-27 10:04 UTC (13+ messages)
` [PATCH v3 1/4] serial: 8250_dw: select port setup through platform data
` [PATCH v3 2/4] dt-bindings: serial: snps-dw-apb-uart: add Allwinner H616
` [PATCH v3 3/4] serial: 8250_dw: configure the Allwinner H616 UART
[PATCH v3 0/4] Fix transmit handling on SCI/RSCI ports
2026-10-27 9:34 UTC (14+ messages)
` [PATCH v3 1/4] serial: sh-sci: Drop TE disable at end of transmission on SCI
` [PATCH v3 2/4] serial: sh-sci: Keep TX enabled on TEI while data is pending
` [PATCH v3 3/4] serial: sh-sci: Skip TDxE clear when hardware clears it automatically
` [PATCH v3 4/4] serial: sh-sci: Toggle TE when restoring SCSCR in console write on SCI
[PATCH] tty: discard flip-buffer input for TCSAFLUSH
2026-10-27 9:25 UTC (5+ messages)
[PATCH 00/20] arm64: add Synaptics SL261X SoCs and RDK boards
2026-10-27 9:11 UTC (5+ messages)
` [PATCH 13/20] dt-bindings: pinctrl: berlin: Support Synaptics SL261X SoCs
` [PATCH 19/20] dt-bindings: arm: berlin: Add Synaptics SL261X SoC and RDK board
[PATCH 00/27] rockchip: Add RK3572 and Forlinx OK3572-C support
2026-10-27 8:14 UTC (6+ messages)
` [PATCH 11/27] dt-bindings: i2c: rk3x: Add RK3572
` [PATCH 24/27] mmc: dw_mmc-rockchip: Keep RK3572 NVM domain powered
[PATCH] tty: Correct tty_operations @remove description
2026-10-27 6:53 UTC (2+ messages)
[PATCH v3 0/3] serial: tegra: fix DMA descriptor use-after-free and stale completions
2026-10-27 6:52 UTC (2+ messages)
[PATCH] serial: 8250: clear RX trigger callbacks when removing a port
2026-10-27 6:32 UTC (3+ messages)
[PATCH v5 0/5] serial: 8250: serialize DMA cancellation with buffer reuse
2026-10-26 21:36 UTC (19+ messages)
` [PATCH v5 2/5] serial: serialize asynchronous write wakeups with the port lock
[PATCH v3] serial: 8250_dw: preserve BUSY-safe fractional divisor programming
2026-10-26 19:16 UTC (3+ messages)
[PATCH v6 0/5] serial: 8250: serialize DMA cancellation with buffer reuse
2026-10-26 18:05 UTC (6+ messages)
` [PATCH v6 2/5] serial: serialize asynchronous write wakeups with the port lock
[PATCH v6 0/3] serdev: handle devices without an ACPI or device tree node
2026-10-26 13:59 UTC (3+ messages)
` [PATCH v6 1/3] "
[PATCH v2 0/2] serial: 8250_ingenic: Set UMR and UACR, add the X1600
2026-10-26 12:41 UTC (6+ messages)
` [PATCH v2 1/2] dt-bindings: serial: ingenic: Add "
` [PATCH v2 2/2] serial: 8250_ingenic: Set UMR and UACR at probe
[PATCH v2] serial: 8250_dw: preserve BUSY-safe fractional divisor programming
2026-10-26 11:04 UTC (2+ messages)
[PATCH 1/2] dt-bindings: serial: ingenic: Add the X1600
2026-10-26 11:03 UTC (2+ messages)
[PATCH] tty: serial: mvebu-uart: use device_get_match_data()
2026-10-26 9:11 UTC (2+ messages)
[PATCH 0/2] serial: tegra: Fix 32-bit overflows in the clock rate adjustment
2026-10-26 8:50 UTC (7+ messages)
` [PATCH 1/2] serial: tegra: Fix overflow in tegra_get_tolerance_rate()
` [PATCH 2/2] serial: tegra: Fix overflow in tegra_check_rate_in_range()
[PATCH v3 0/7] vt: Simplify console-blanking interface
2026-10-26 7:41 UTC (5+ messages)
` [PATCH v3 7/7] vt: Remove old-style con_blank
[PATCH] serial: qcom-geni: Add tracepoints for SE reg dump
2026-10-26 7:06 UTC (3+ messages)
[PATCH 0/3] serial: 8250_dw: describe the Allwinner H616 UART configuration
2026-10-25 17:38 UTC (11+ messages)
` [PATCH 2/3] serial: 8250_dw: configure the Allwinner H616 UART
page: next (older) | prev (newer) | latest
- recent:[subjects (threaded)|topics (new)|topics (active)]
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox