messages from 2026-10-27 11:07:48 to 2026-10-29 05:16:59 UTC [more...]
[PATCH RFC 00/12] Add BL808 UART3 support with a Rust serial-core polling console
2026-10-29 5:16 UTC (23+ messages)
` [PATCH RFC 01/12] dt-bindings: vendor-prefixes: Add Bouffalo Lab
` [PATCH RFC 02/12] dt-bindings: interrupt-controller: Add BL808 PLIC
` [PATCH RFC 03/12] dt-bindings: timer: Add BL808 CLINT
` [PATCH RFC 04/12] dt-bindings: riscv: Add Bouffalo Lab BL808
` [PATCH RFC 05/12] dt-bindings: serial: Add BL808 UART
` [PATCH RFC 06/12] rust: serial: Add minimal serial-core polling console support
` [PATCH RFC 07/12] serial: bflb: Add Rust BL808 polling console
` [PATCH RFC 08/12] riscv: Add Bouffalo Lab SoC selection
` [PATCH RFC 09/12] riscv: dts: bouffalolab: Add BL808 SoC
` [PATCH RFC 10/12] riscv: dts: bouffalolab: Add Sipeed M1s Dock
` [PATCH RFC 11/12] riscv: defconfig: Enable Bouffalo Lab SoCs
` [PATCH RFC 12/12] MAINTAINERS: Add Bouffalo Lab BL808 support
[PATCH] tty: n_tty: convert the full VTIME interval to jiffies
2026-10-29 0:24 UTC (2+ messages)
[PATCH v7 0/5] serial: 8250: serialize DMA cancellation with buffer reuse
2026-10-28 20:48 UTC (14+ messages)
` [PATCH v7 1/5] serial: 8250_omap: separate locked TX DMA completion processing
` [PATCH v7 2/5] serial: serialize asynchronous write wakeups with the port lock
` [PATCH v7 3/5] serial: core: allow drivers to reserve flushed transmit storage
` [PATCH v7 4/5] serial: 8250: drain canceled TX DMA before reusing its buffer
` [PATCH v7 5/5] serial: 8250: retire canceled RX DMA before reusing the receive buffer
[PATCH RFC 00/18] riscv: add initial Zhihe A210 support using SCMI clocks and resets
2026-10-28 17:48 UTC (41+ messages)
` [PATCH RFC 01/18] firmware: arm_scmi: Allow SCMI transports on RISC-V
` [PATCH RFC 02/18] dt-bindings: vendor-prefixes: add Zhihe
` [PATCH RFC 03/18] riscv: add Zhihe A210 support
` [PATCH RFC 04/18] dt-bindings: mailbox: add the A210 AP to E902 doorbell
` [PATCH RFC 05/18] mailbox: add A210 AP to E902 doorbell support
` [PATCH RFC 06/18] dt-bindings: pinctrl: add Zhihe A210 pin controller
` [PATCH RFC 07/18] pinctrl: zhihe: add A210 support
` [PATCH RFC 08/18] dt-bindings: interrupt-controller: add Zhihe A210 PLIC
` [PATCH RFC 09/18] dt-bindings: riscv: add Melon Pi V1 and V2
` [PATCH RFC 10/18] dt-bindings: timer: add Zhihe A210 CLINT
` [PATCH RFC 11/18] dt-bindings: firmware: add A210 SCMI clock and reset IDs
` [PATCH RFC 12/18] dt-bindings: serial: snps-dw-apb-uart: add Zhihe A210 UART
` [PATCH RFC 13/18] riscv: dts: zhihe: add A210 core support
` [PATCH RFC 14/18] riscv: dts: zhihe: add A210 UARTs
` [PATCH RFC 15/18] riscv: dts: zhihe: add A210 module memory
` [PATCH RFC 16/18] riscv: dts: zhihe: add Melon Pi V1 and V2
` [PATCH RFC 17/18] riscv: defconfig: enable A210 support
` [PATCH RFC 18/18] MAINTAINERS: add Zhihe A210
[PATCH v2] Input: serport - defer write wakeups to a worker
2026-10-28 17:09 UTC (3+ messages)
[PATCH v3 0/4] dmaengine: dw: serialize completion and termination
2026-10-28 16:32 UTC (9+ messages)
` [PATCH v3 1/4] dmaengine: dw: Fix XFER bit set, but channel not idle error
` [PATCH v3 2/4] dmaengine: dw: serialize error recovery with channel termination
` [PATCH v3 3/4] dmaengine: dw: Prevent tx-status calling DMA-desc callback
` [PATCH v3 4/4] dmaengine: dw: synchronize completion callbacks
[PATCH v3 0/4] Fix transmit handling on SCI/RSCI ports
2026-10-28 15:47 UTC (10+ messages)
[PATCH 00/24] tty/serial: a bunch of llm-found fixes
2026-10-28 15:10 UTC (85+ messages)
` [PATCH 01/24] vt: serialise the producers of the flip buffer
` [PATCH 02/24] serial: core: respect runtime PM when sending x_char
` [PATCH 03/24] serial: 8250: don't wait for the em485 timers locked
` [PATCH 04/24] serial: 8250: don't report a wakeup to a closed tty
` [PATCH 05/24] serial: 8250: clear subdriver state on port unregister
` [PATCH 06/24] serial: 8250: add bounds check for line array in setup_serial()
` [PATCH 07/24] serial: 8250: hold hash_mutex across irq_info lookup and linking
` [PATCH 08/24] serial: 8250: cancel overrun backoff work on port shutdown and unregister
` [PATCH 09/24] serial: 8250: 8250_bcm7271: fix DMA address truncation to 32 bits
` [PATCH 10/24] serial: 8250: pericom: validate port offset against BAR length
` [PATCH 11/24] serial: 8250: cap OxSemi Tornado UART count against BAR size
` [PATCH 12/24] serial: 8250: dfl: add bounds check for device-provided regshift
` [PATCH 13/24] serial: 8250: dfl: validate MMIO resource size and regshift
` [PATCH 14/24] serial: 8250: ioc3: store registered line number in driver data
` [PATCH 15/24] serial: 8250: omap: acquire rx_dma_lock in DMA completion callback
` [PATCH 16/24] serial: 8250_lpss: don't divide by 0 above 6.25 Mbaud
` [PATCH 17/24] serial: 8250_mxpcie: handle hangup during break
` [PATCH 18/24] serial: fsl_lpuart: fix tty ref of wakeup event
` [PATCH 19/24] serial: imx: fix the tty reference of the "
` [PATCH 20/24] serial: rda: free the interrupt on shutdown
` [PATCH 21/24] serial: samsung: don't leak the tty on an RX IRQ
` [PATCH 22/24] serial: samsung: put the previous baud clock
` [PATCH 23/24] serial: st-asc: don't report a wakeup to a closed tty
` [PATCH 24/24] serial: stm32: "
[PATCH 00/20] arm64: add Synaptics SL261X SoCs and RDK boards
2026-10-28 14:32 UTC (3+ messages)
` [PATCH 12/20] pinctrl: berlin: add optional pinconf support
[PATCH 0/3] tty: n_hdlc: fix hangup handling
2026-10-28 13:27 UTC (7+ messages)
` [PATCH 1/3] tty: n_hdlc: fix missing write() hangup check
` [PATCH 2/3] tty: n_hdlc: fix read() hangup race
` [PATCH 3/3] tty: n_hdlc: fix read() hangup check
[PATCH v4 0/5] serial: 8250_dw: describe the Allwinner H616 UART configuration
2026-10-28 11:05 UTC (24+ messages)
` [PATCH v4 1/5] serial: 8250_dw: select port setup through platform data
` [PATCH v4 2/5] serial: 8250: share the RX trigger conversion helper
` [PATCH v4 3/5] dt-bindings: serial: snps-dw-apb-uart: add Allwinner H616
` [PATCH v4 4/5] serial: 8250_dw: configure the Allwinner H616 UART
` [PATCH v4 5/5] arm64: dts: allwinner: h616: describe the UART integration
[PATCH 00/27] rockchip: Add RK3572 and Forlinx OK3572-C support
2026-10-28 10:16 UTC (3+ messages)
` [PATCH 09/27] gpio: rockchip: Add RK3572 GPIO support
[PATCH] Input: serport - defer write wakeups to a worker
2026-10-28 5:54 UTC (2+ messages)
[PATCH v2] usb: gadget: u_serial: pin ports while TTYs are installed
2026-10-28 1:42 UTC (2+ messages)
[PATCH v2] serial: qcom-geni: Set the serial engine up again after hibernation
2026-10-27 23:01 UTC (2+ messages)
[PATCH v3 0/4] serial: 8250_dw: describe the Allwinner H616 UART configuration
2026-10-27 22:25 UTC (8+ messages)
` [PATCH v3 2/4] dt-bindings: serial: snps-dw-apb-uart: add Allwinner H616
[PATCH v6 0/3] serdev: handle devices without an ACPI or device tree node
2026-10-27 21:47 UTC (4+ messages)
` [PATCH v6 1/3] "
[PATCH 0/5] serial: mcf: add devicetree support
2026-10-27 21:07 UTC (7+ messages)
` [PATCH 4/5] dt-bindings: serial: create binding for mcf-uart
[PATCH] serial: qcom-geni: Set the serial engine up again after hibernation
2026-10-27 20:50 UTC (2+ messages)
[PATCH v2] tty: discard flip-buffer input for TCSAFLUSH
2026-10-27 19:17 UTC (4+ messages)
[PATCH v4] serial: 8250_dw: preserve BUSY-safe fractional divisor programming
2026-10-27 17:19 UTC (3+ messages)
[PATCH] tty: discard flip-buffer input for TCSAFLUSH
2026-10-27 16:36 UTC (5+ messages)
page: next (older) | prev (newer) | latest
- recent:[subjects (threaded)|topics (new)|topics (active)]
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox