Linux Serial subsystem development
 help / color / mirror / Atom feed
 messages from 2026-11-17 09:11:41 to 2026-11-20 20:24:47 UTC [more...]

[PATCH v11 0/7] dmaengine: dw: serialize completion and termination
 2026-11-20 20:24 UTC  (10+ messages)
` [PATCH v11 1/7] dmaengine: dw: Fix XFER bit set, but channel not idle error
` [PATCH v11 2/7] dmaengine: dw: serialize error recovery with channel termination
` [PATCH v11 3/7] dmaengine: dw: embed a virt-dma channel
` [PATCH v11 4/7] dmaengine: dw: use virt-dma for descriptor and callback ownership
` [PATCH v11 5/7] dmaengine: dw: extract hardware-LLP residue calculation
` [PATCH v11 6/7] dmaengine: dw: calculate residue in the status getter
` [PATCH v11 7/7] dmaengine: dw: report residue for queued transfers

[PATCH] serial: 8250_exar: check IS_ERR() on __xr17v35x_register_gpio()
 2026-11-20 20:00 UTC  (3+ messages)

[PATCH v4 00/13] riscv: add initial Zhihe A210 support using SCMI clocks and resets
 2026-11-20 19:21 UTC  (26+ messages)
` [PATCH v4 01/13] riscv: add Zhihe A210 support
` [PATCH v4 02/13] dt-bindings: mailbox: add Zhihe A210 AP to E902 mailbox
` [PATCH v4 03/13] mailbox: add Zhihe A210 AP to E902 mailbox driver
` [PATCH v4 04/13] dt-bindings: interrupt-controller: add Zhihe A210 PLIC
` [PATCH v4 05/13] dt-bindings: riscv: add Melon Pi V1 and V2
` [PATCH v4 06/13] dt-bindings: timer: add Zhihe A210 CLINT
` [PATCH v4 07/13] dt-bindings: serial: snps-dw-apb-uart: add Zhihe A210 UART
` [PATCH v4 08/13] riscv: dts: zhihe: add A210 core support
` [PATCH v4 09/13] riscv: dts: zhihe: add A210 UARTs
` [PATCH v4 10/13] riscv: dts: zhihe: add A210 module memory
` [PATCH v4 11/13] riscv: dts: zhihe: add Melon Pi V1 and V2
` [PATCH v4 12/13] riscv: defconfig: enable A210 support
` [PATCH v4 13/13] MAINTAINERS: add Zhihe A210

[PATCH mainline-linux 0/4] serial: sh-sci: rsci: Add RS485 support
 2026-11-20 16:11 UTC  (7+ messages)
` [PATCH mainline-linux 1/4] tty: serial: sh-sci: set the RSCI RX FIFO trigger to half the FIFO
` [PATCH mainline-linux 2/4] dt-bindings: serial: renesas,rsci: Document RS485 properties
` [PATCH mainline-linux 3/4] serial: sh-sci: rsci: Add RS485 support
` [PATCH mainline-linux 4/4] arm64: dts: renesas: r9a08g046l48-smarc: Add RS485 support on RSCI2

[PATCH v22 0/5] rust: add `Ownable` trait and `Owned` type
 2026-11-20 13:41 UTC  (13+ messages)
` [PATCH v22 1/5] rust: alloc: add `KBox::into_non_null`
` [PATCH v22 2/5] rust: types: Add Ownable/Owned types
` [PATCH v22 3/5] rust: implement `ForeignOwnable` for `Owned`
` [PATCH v22 4/5] rust: rename `AlwaysRefCounted` to `RefCounted`
` [PATCH v22 5/5] rust: Add `OwnableIntoShared` and `OwnableTryFromShared`

[PATCH] tty: reset ldisc to N_TTY on reopen after hangup
 2026-11-20 11:33 UTC  (2+ messages)

[PATCH] serial: max310x: look at the port once after enabling its interrupts
 2026-11-20  7:53 UTC  (2+ messages)

[PATCH 0/3] serial: max310x: teardown ordering and CTS locking fixes
 2026-11-20  7:45 UTC  (7+ messages)
` [PATCH 1/3] serial: max310x: fix use-after-free on remove
` [PATCH 2/3] serial: max310x: unwind only the registered ports when probe fails
` [PATCH 3/3] serial: max310x: hold the port lock around the CTS change

[PATCH 0/3] serial: 8250: Add Loongson-2K0300 and Loongson-2K3000 UART support
 2026-11-19 21:45 UTC  (6+ messages)
` [PATCH 1/3] dt-bindings: serial: 8250: Document Loongson-2K0300 UART compatible
` [PATCH 2/3] dt-bindings: serial: 8250: Add dedicated Loongson-2K3000 "

[PATCH] serial: sc16is7xx: Use devm_clk_get_optional_enabled() in sc16is7xx_probe()
 2026-11-19 17:43 UTC  (4+ messages)
  `  "

[PATCH] vt: allocate the screen buffers with kvzalloc()
 2026-11-19 16:49 UTC  (2+ messages)

[PATCH 04/27] dt-bindings: mfd: syscon: Add RK3572 QoS register compatible
 2026-11-19 16:48 UTC  (2+ messages)
` (subset) "

[PATCH v10 0/7] dmaengine: dw: serialize completion and termination
 2026-11-19 10:29 UTC  (17+ messages)
` [PATCH v10 1/7] dmaengine: dw: Fix XFER bit set, but channel not idle error
` [PATCH v10 2/7] dmaengine: dw: serialize error recovery with channel termination
` [PATCH v10 3/7] dmaengine: dw: embed a virt-dma channel
` [PATCH v10 4/7] dmaengine: dw: use virt-dma for descriptor and callback ownership
` [PATCH v10 5/7] dmaengine: dw: extract hardware-LLP residue calculation
` [PATCH v10 6/7] dmaengine: dw: calculate residue in the status getter
` [PATCH v10 7/7] dmaengine: dw: report residue for queued transfers

[PATCH 5.10 0515/1848] serial: 8250_lpss: do not touch uninitialized line in ehl_serial_exit()
 2026-11-18 14:42 UTC 

[PATCH v2] tty: vt: protect tty lifetime in keyboard path
 2026-11-19  2:52 UTC  (2+ messages)

[PATCH 5.15 0637/2214] serial: 8250_lpss: do not touch uninitialized line in ehl_serial_exit()
 2026-11-18 14:38 UTC 

[PATCH 6.1 0948/2857] serial: 8250_lpss: do not touch uninitialized line in ehl_serial_exit()
 2026-11-18 14:33 UTC 

[PATCH 6.6 1108/3318] serial: 8250_lpss: do not touch uninitialized line in ehl_serial_exit()
 2026-11-18 14:28 UTC 

[PATCH v4 00/16] HID: ft260: add UART and GPIO support, plus I2C fixes
 2026-11-18 20:57 UTC  (40+ messages)
` [PATCH v4 01/16] HID: ft260: add serial driver
` [PATCH v4 02/16] HID: ft260: uart: fix "
` [PATCH v4 03/16] HID: ft260: add GPIO support
` [PATCH v4 04/16] HID: ft260: i2c: reduce driver module loading time
` [PATCH v4 05/16] HID: ft260: fix sysfs store failure notice for big numbers
` [PATCH v4 06/16] HID: ft260: i2c: reduce bus-error message severity
` [PATCH v4 07/16] HID: ft260: uart: enable flow control
` [PATCH v4 08/16] HID: ft260: uart: add modem pins control via ioctl
` [PATCH v4 09/16] HID: ft260: group sysfs attrs per HID interface
` [PATCH v4 10/16] HID: ft260: i2c: fix large write transaction failure
` [PATCH v4 11/16] HID: ft260: workaround for TN_189 errata endpoint STALL after enumeration
` [PATCH v4 12/16] HID: ft260: i2c: abort in-flight transfers with STOP before reset
` [PATCH v4 13/16] HID: ft260: i2c: reject an I2C clock outside the supported range
` [PATCH v4 14/16] HID: ft260: i2c: fix i2c_reset sysfs store return value
` [PATCH v4 15/16] HID: ft260: i2c: recover a bus held by a slave
` [PATCH v4 16/16] HID: ft260: use lock guards

[PATCH v9 0/6] dmaengine: dw: serialize completion and termination
 2026-11-18 18:04 UTC  (14+ messages)
` [PATCH v9 1/6] dmaengine: dw: Fix XFER bit set, but channel not idle error
` [PATCH v9 2/6] dmaengine: dw: serialize error recovery with channel termination
` [PATCH v9 3/6] dmaengine: dw: use virt-dma for descriptor and callback ownership
` [PATCH v9 4/6] dmaengine: dw: extract hardware-LLP residue calculation
` [PATCH v9 5/6] dmaengine: dw: calculate residue in the status getter
` [PATCH v9 6/6] dmaengine: dw: report residue for queued transfers

[PATCH 00/22] mm: introduce N_MEMORY_COMMON
 2026-11-18 15:56 UTC  (18+ messages)
` [PATCH 01/22] mm: add node-state-filtered zone and node iterators
` [PATCH 02/22] mm: publish and clear node memory states via helpers
` [PATCH 03/22] mm: introduce the common-memory node state
` [PATCH 05/22] mm/mempolicy: keep interleave and tmpfs mount policies on common memory
` [PATCH 13/22] mm/hugetlb: restrict pool growth to "

[PATCH] serial: pic32_uart: don't enable clock with interrupts disabled
 2026-11-18 11:20 UTC  (2+ messages)

[PATCH] tty: vt: protect tty lifetime in keyboard path
 2026-11-18  6:05 UTC  (3+ messages)

[PATCH v3] rust: serdev: use Delta<Jiffy> for timeouts
 2026-11-18  5:25 UTC  (4+ messages)

[PATCH v2] vt: modify a constant prefix that looks like a ReST target
 2026-11-18  0:15 UTC  (2+ messages)

[PATCH v5 0/7] Fix transmit handling on SCI/RSCI ports
 2026-11-18  0:04 UTC  (15+ messages)
` [PATCH v5 1/7] serial: sh-sci: Drop TE disable at end of transmission on SCI
` [PATCH v5 2/7] serial: sh-sci: Keep TX enabled on TEI while data is pending
` [PATCH v5 3/7] serial: rsci: Enable transmit end interrupt in rsci_stop_tx()
` [PATCH v5 4/7] serial: sh-sci: Do not kick TX from sci_er_interrupt() on RSCI
` [PATCH v5 5/7] serial: sh-sci: Skip TDxE clear when hardware clears it automatically
` [PATCH v5 6/7] serial: sh-sci: Toggle TE when restoring SCSCR in console write on SCI
` [PATCH v5 7/7] serial: rsci: Simplify rsci_transmit_chars()

[PATCH v4 0/7] Fix transmit handling on SCI/RSCI ports
 2026-11-17 22:46 UTC  (7+ messages)
` [PATCH v4 2/7] serial: sh-sci: Keep TX enabled on TEI while data is pending
` [PATCH v4 3/7] serial: rsci: Enable transmit end interrupt in rsci_stop_tx()

[PATCH v2] serial: mvebu-uart: drop of_match_ptr for ID table
 2026-11-17 14:35 UTC  (2+ messages)

[PATCH v2 0/6] arm64: Initial support for MediaTek MT8163 SoC
 2026-11-17 12:02 UTC  (3+ messages)

[PATCH v2 0/5] arm64: dts: mediatek: Add MT6833 and the Xiaomi Redmi Note 13 5G
 2026-11-17 11:22 UTC  (13+ messages)
` [PATCH v2 1/5] dt-bindings: arm: "
` [PATCH v2 2/5] dt-bindings: watchdog: mediatek,mtk-wdt: Add MT6833
` [PATCH v2 3/5] watchdog: mediatek: "
` [PATCH v2 4/5] dt-bindings: serial: mediatek,uart: "
` [PATCH v2 5/5] arm64: dts: mediatek: Add MT6833 and the Xiaomi Redmi Note 13 5G


This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox