From: Bastian Hecht <hechtb@googlemail.com>
To: dedekind1@gmail.com, linux-sh@vger.kernel.org,
linux-mtd@lists.infradead.org
Cc: Magnus Damm <magnus.damm@gmail.com>,
Laurent Pichart <laurent.pinchart@ideasonboard.com>
Subject: [PATCH] mtd: sh_flctl: Add power management with QoS request
Date: Sun, 18 Mar 2012 14:13:20 +0000 [thread overview]
Message-ID: <1332080000-21650-1-git-send-email-hechtb@gmail.com> (raw)
In-Reply-To: <1331393478-30850-1-git-send-email-hechtb@gmail.com>
Adds power management code with fine granularity. Every flash control
command is enclosed by runtime_put()/get()s. To make sure that no
overhead is generated by too frequent power state switches, a quality of
service request is issued.
Signed-off-by: Bastian Hecht <hechtb@gmail.com>
---
The QoS request states the following: "Please don't go into a power state, from that you can't wake in less than 100 microseconds." On a sh7372 this could happen if the power domain of the FLCTL is shut down. This hurts performance - we don't want this.
The patch is based on top of the "SH Mobile sh_flctl driver brush up" patch series. The rtpm patch that I've posted a few days ago contains a stupid mix-up, so I'd suggest to drop it and use this more advanced patch directly.
drivers/mtd/nand/sh_flctl.c | 51 ++++++++++++++++++++++++++++++++++-------
include/linux/mtd/sh_flctl.h | 3 ++
2 files changed, 45 insertions(+), 9 deletions(-)
diff --git a/drivers/mtd/nand/sh_flctl.c b/drivers/mtd/nand/sh_flctl.c
index d0f1f3c..6199004 100644
--- a/drivers/mtd/nand/sh_flctl.c
+++ b/drivers/mtd/nand/sh_flctl.c
@@ -26,6 +26,7 @@
#include <linux/delay.h>
#include <linux/io.h>
#include <linux/platform_device.h>
+#include <linux/pm_runtime.h>
#include <linux/slab.h>
#include <linux/mtd/mtd.h>
@@ -515,6 +516,8 @@ static void flctl_cmdfunc(struct mtd_info *mtd, unsigned int command,
struct sh_flctl *flctl = mtd_to_flctl(mtd);
uint32_t read_cmd = 0;
+ pm_runtime_get_sync(&flctl->pdev->dev);
+
flctl->read_bytes = 0;
if (command != NAND_CMD_PAGEPROG)
flctl->index = 0;
@@ -670,7 +673,7 @@ static void flctl_cmdfunc(struct mtd_info *mtd, unsigned int command,
default:
break;
}
- return;
+ goto runtime_exit;
read_normal_exit:
writel(flctl->read_bytes, FLDTCNTR(flctl)); /* set read size */
@@ -678,23 +681,47 @@ read_normal_exit:
start_translation(flctl);
read_fiforeg(flctl, flctl->read_bytes, 0);
wait_completion(flctl);
+runtime_exit:
+ pm_runtime_put_sync(&flctl->pdev->dev);
return;
}
static void flctl_select_chip(struct mtd_info *mtd, int chipnr)
{
struct sh_flctl *flctl = mtd_to_flctl(mtd);
+ int ret;
switch (chipnr) {
case -1:
flctl->flcmncr_base &= ~CE0_ENABLE;
+
+ pm_runtime_get_sync(&flctl->pdev->dev);
writel(flctl->flcmncr_base, FLCMNCR(flctl));
+
+ if (flctl->qos_request) {
+ dev_pm_qos_remove_request(&flctl->pm_qos);
+ flctl->qos_request = 0;
+ }
+
+ pm_runtime_put_sync(&flctl->pdev->dev);
break;
case 0:
flctl->flcmncr_base |= CE0_ENABLE;
- writel(flctl->flcmncr_base, FLCMNCR(flctl));
- if (flctl->holden)
+
+ if (!flctl->qos_request) {
+ ret = dev_pm_qos_add_request(&flctl->pdev->dev,
+ &flctl->pm_qos, 100);
+ if (ret < 0)
+ dev_err(&flctl->pdev->dev,
+ "PM QoS request failed: %d\n", ret);
+ flctl->qos_request = 1;
+ }
+
+ if (flctl->holden) {
+ pm_runtime_get_sync(&flctl->pdev->dev);
writel(HOLDEN, FLHOLDCR(flctl));
+ pm_runtime_put_sync(&flctl->pdev->dev);
+ }
break;
default:
BUG();
@@ -835,13 +862,13 @@ static int __devinit flctl_probe(struct platform_device *pdev)
res = platform_get_resource(pdev, IORESOURCE_MEM, 0);
if (!res) {
dev_err(&pdev->dev, "failed to get I/O memory\n");
- goto err;
+ goto err_iomap;
}
flctl->reg = ioremap(res->start, resource_size(res));
if (flctl->reg = NULL) {
dev_err(&pdev->dev, "failed to remap I/O memory\n");
- goto err;
+ goto err_iomap;
}
platform_set_drvdata(pdev, flctl);
@@ -871,23 +898,28 @@ static int __devinit flctl_probe(struct platform_device *pdev)
nand->read_word = flctl_read_word;
}
+ pm_runtime_enable(&pdev->dev);
+ pm_runtime_resume(&pdev->dev);
+
ret = nand_scan_ident(flctl_mtd, 1, NULL);
if (ret)
- goto err;
+ goto err_chip;
ret = flctl_chip_init_tail(flctl_mtd);
if (ret)
- goto err;
+ goto err_chip;
ret = nand_scan_tail(flctl_mtd);
if (ret)
- goto err;
+ goto err_chip;
mtd_device_register(flctl_mtd, pdata->parts, pdata->nr_parts);
return 0;
-err:
+err_chip:
+ pm_runtime_disable(&pdev->dev);
+err_iomap:
kfree(flctl);
return ret;
}
@@ -897,6 +929,7 @@ static int __devexit flctl_remove(struct platform_device *pdev)
struct sh_flctl *flctl = platform_get_drvdata(pdev);
nand_release(&flctl->mtd);
+ pm_runtime_disable(&pdev->dev);
kfree(flctl);
return 0;
diff --git a/include/linux/mtd/sh_flctl.h b/include/linux/mtd/sh_flctl.h
index 8bcf299..a38e1fa 100644
--- a/include/linux/mtd/sh_flctl.h
+++ b/include/linux/mtd/sh_flctl.h
@@ -23,6 +23,7 @@
#include <linux/mtd/mtd.h>
#include <linux/mtd/nand.h>
#include <linux/mtd/partitions.h>
+#include <linux/pm_qos.h>
/* FLCTL registers */
#define FLCMNCR(f) (f->reg + 0x0)
@@ -131,6 +132,7 @@ struct sh_flctl {
struct mtd_info mtd;
struct nand_chip chip;
struct platform_device *pdev;
+ struct dev_pm_qos_request pm_qos;
void __iomem *reg;
uint8_t done_buff[2048 + 64]; /* max size 2048 + 64 */
@@ -149,6 +151,7 @@ struct sh_flctl {
unsigned page_size:1; /* NAND page size (0 = 512, 1 = 2048) */
unsigned hwecc:1; /* Hardware ECC (0 = disabled, 1 = enabled) */
unsigned holden:1; /* Hardware has FLHOLDCR and HOLDEN is set */
+ unsigned qos_request:1; /* QoS request to prevent deep power shutdown */
};
struct sh_flctl_platform_data {
--
1.7.5.4
next prev parent reply other threads:[~2012-03-18 14:13 UTC|newest]
Thread overview: 5+ messages / expand[flat|nested] mbox.gz Atom feed top
2012-03-10 15:31 [PATCH] mtd: sh_flctl: Add power management support Bastian Hecht
2012-03-13 11:15 ` Artem Bityutskiy
2012-03-18 14:13 ` Bastian Hecht
2012-03-18 14:13 ` Bastian Hecht [this message]
2012-03-19 14:13 ` [PATCH] mtd: sh_flctl: Add power management with QoS request Artem Bityutskiy
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=1332080000-21650-1-git-send-email-hechtb@gmail.com \
--to=hechtb@googlemail.com \
--cc=dedekind1@gmail.com \
--cc=laurent.pinchart@ideasonboard.com \
--cc=linux-mtd@lists.infradead.org \
--cc=linux-sh@vger.kernel.org \
--cc=magnus.damm@gmail.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).