Re: [PATCH] sh: rsk7203 CONFIG_MTD=n fix

Fabio Giovagnini
2009-10-26T21:12:41Z

Is this the propèer repository where to clone kernel from?
git clone git://git.kernel.org/pub/scm/linux/kernel/git/lethal/sh-2.6.git

Thanks a lot

Alle 14:49, lunedì 26 ottobre 2009, Fabio Giovagnini ha scritto:
> I hacked the previuos MCP data toolchain and I got g++ runnung, so I was
> able to compile and run SDL based applications.
> Now I start from u-boot to manage the board from the reset. Later I'll
> approach the problem of user space applications.
> Coudesourgery toolchian is uClibc based or glibc based?
>
> Thanksa alot
>
> Alle 13:12, lunedì 26 ottobre 2009, Paul Mundt ha scritto:
> > On Mon, Oct 26, 2009 at 12:23:57PM +0100, Fabio Giovagnini wrote:
> > > OK. Thanks a lot.
> > > Did you build any application for rsk7203?
> > > I used MCP data environment, but it is without g++, so I cannot use
> > > libraries as SDL, qt embedded, or more.
> > > I think exculding all the g++ stuff is not strategic.
> >
> > Then talk to MPC about it. This is not an MPC support forum, and
> > obviously we do not recommend using antiquated toolchains.
> >
> > The CodeSourcery toolchain is the only one that is current and supported,
> > although the SH-FDPIC toolchain aimed at SH-2A is not yet publically
> > available. However you can of course take the source and attempt to
> > construct a FLAT toolchain from it in the interim (although this too
> > would result in a currently unsupported configuration).
> > --
> > To unsubscribe from this list: send the line "unsubscribe linux-sh" in
> > the body of a message to majordomo@vger.kernel.org
> > More majordomo info at http://vger.kernel.org/majordomo-info.html