Re: Hi All, hot to debug my eth0' hw?

[Fabio Giovagnini <fabio.giovagnini@aurion-tech.com>]

Thanks a lot, but 2 questions.
1)I'm using linux2.6.16-ucinux-7203; with the oscilloscope i can se that after 
chip reset by the driver the irq line is driven low and stays always low. I 
think the is not proper because this means that never the chip irq state flag 
is erased

2) I have a 32 bus connected sh2a D0 do smc9118 D0 and sh2a D31 do smc9118 
D31; do I need a software swap? ( I followed the schematics of rsk+ 7203 eva 
board before to learn that for big endioan processors the designer needs to 
physically swap the bytes).

Best regards and thanks a lot



In data martedì 16 marzo 2010 12:35:45, Magnus Damm ha scritto:
: > On Tue, Mar 16, 2010 at 8:25 PM, Fabio Giovagnini
> 
> <fabio.giovagnini@aurion-tech.com> wrote:
> > Hi all, I build a board with smsc 9118 eth chip; Of course I'm not sure
> > the hw is ok.
> 
> Not sure what is missing in your case, but if you want top optimize
> your performance then this commit may be helpful:
> 
> http://git.kernel.org/?p=linux/kernel/git/torvalds/linux-2.6.git;a=commit;h
> £0c89ad41099f58922e0941e346e7c4371655b9
> 
> / magnus
> 

-- 
Fabio Giovagnini

Aurion s.r.l.
P.I e C.F.
00885711200
Tel. +39.051.594.78.24
Cell. +39.335.83.50.919