[PATCH] mmc, sh: use a consistent pr_ prefix

Simon Horman
2010-11-10T10:27:44Z

Use pr_fmt to set the prefix for pr_ messages.
I believe this method is common in other
source files in the kernel tree.

Cc: Yusuke Goda <yusuke.goda.sx@renesas.com>
Signed-off-by: Simon Horman <horms@verge.net.au>
---
drivers/mmc/host/sh_mmcif.c | 52 +++++++++++++++++++++---------------------
1 files changed, 26 insertions(+), 26 deletions(-)

diff --git a/drivers/mmc/host/sh_mmcif.c b/drivers/mmc/host/sh_mmcif.c
index 3f49273..9f37f74 100644
--- a/drivers/mmc/host/sh_mmcif.c
+++ b/drivers/mmc/host/sh_mmcif.c
@@ -16,6 +16,10 @@
*
*/

+#define KMSG_COMPONENT "sh_mmcif"
+#define pr_fmt(fmt) KMSG_COMPONENT ": " fmt
+#define DRIVER_VERSION "2010-04-28"
+
#include <linux/dma-mapping.h>
#include <linux/mmc/host.h>
#include <linux/mmc/card.h>
@@ -27,9 +31,6 @@
#include <linux/clk.h>
#include <linux/mmc/sh_mmcif.h>

-#define DRIVER_NAME "sh_mmcif"
-#define DRIVER_VERSION "2010-04-28"
-
/* CE_CMD_SET */
#define CMD_MASK 0x3f000000
#define CMD_SET_RTYP_NO ((0 << 23) | (0 << 22))
@@ -221,8 +222,8 @@ static int sh_mmcif_error_manage(struct sh_mmcif_host *host)

state1 = sh_mmcif_readl(host->addr, MMCIF_CE_HOST_STS1);
state2 = sh_mmcif_readl(host->addr, MMCIF_CE_HOST_STS2);
- pr_debug("%s: ERR HOST_STS1 = %08x\n", DRIVER_NAME, state1);
- pr_debug("%s: ERR HOST_STS2 = %08x\n", DRIVER_NAME, state2);
+ pr_debug("ERR HOST_STS1 = %08x\n", state1);
+ pr_debug("ERR HOST_STS2 = %08x\n", state2);

if (state1 & STS1_CMDSEQ) {
sh_mmcif_bitset(host, MMCIF_CE_CMD_CTRL, CMD_CTRL_BREAK);
@@ -230,7 +231,7 @@ static int sh_mmcif_error_manage(struct sh_mmcif_host *host)
while (1) {
timeout--;
if (timeout < 0) {
- pr_err(DRIVER_NAME": Forceed end of " \
+ pr_err("Forceed end of " \
"command sequence timeout err\n");
return -EIO;
}
@@ -240,18 +241,18 @@ static int sh_mmcif_error_manage(struct sh_mmcif_host *host)
mdelay(1);
}
sh_mmcif_sync_reset(host);
- pr_debug(DRIVER_NAME": Forced end of command sequence\n");
+ pr_debug("Forced end of command sequence\n");
return -EIO;
}

if (state2 & STS2_CRC_ERR) {
- pr_debug(DRIVER_NAME": Happened CRC error\n");
+ pr_debug("Happened CRC error\n");
ret = -EIO;
} else if (state2 & STS2_TIMEOUT_ERR) {
- pr_debug(DRIVER_NAME": Happened Timeout error\n");
+ pr_debug("Happened Timeout error\n");
ret = -ETIMEDOUT;
} else {
- pr_debug(DRIVER_NAME": Happened End/Index error\n");
+ pr_debug("Happened End/Index error\n");
ret = -EIO;
}
return ret;
@@ -434,7 +435,7 @@ static u32 sh_mmcif_set_cmd(struct sh_mmcif_host *host,
tmp |= CMD_SET_RTYP_17B;
break;
default:
- pr_err(DRIVER_NAME": Not support type response.\n");
+ pr_err("Not support type response.\n");
break;
}
switch (opc) {
@@ -462,7 +463,7 @@ static u32 sh_mmcif_set_cmd(struct sh_mmcif_host *host,
tmp |= CMD_SET_DATW_8;
break;
default:
- pr_err(DRIVER_NAME": Not support bus width.\n");
+ pr_err("Not support bus width.\n");
break;
}
}
@@ -510,7 +511,7 @@ static u32 sh_mmcif_data_trans(struct sh_mmcif_host *host,
ret = sh_mmcif_single_read(host, mrq);
break;
default:
- pr_err(DRIVER_NAME": NOT SUPPORT CMD = d'%08d\n", opc);
+ pr_err("NOT SUPPORT CMD = d'%08d\n", opc);
ret = -EINVAL;
break;
}
@@ -574,8 +575,7 @@ static void sh_mmcif_start_cmd(struct sh_mmcif_host *host,
cmd->error = -ETIMEDOUT;
break;
default:
- pr_debug("%s: Cmd(d'%d) err\n",
- DRIVER_NAME, cmd->opcode);
+ pr_debug("Cmd(d'%d) err\n", cmd->opcode);
cmd->error = sh_mmcif_error_manage(host);
break;
}
@@ -613,7 +613,7 @@ static void sh_mmcif_stop_cmd(struct sh_mmcif_host *host,
else if (mrq->cmd->opcode = MMC_WRITE_MULTIPLE_BLOCK)
sh_mmcif_bitset(host, MMCIF_CE_INT_MASK, MASK_MCMD12RBE);
else {
- pr_err(DRIVER_NAME": not support stop cmd\n");
+ pr_err("not support stop cmd\n");
cmd->error = sh_mmcif_error_manage(host);
return;
}
@@ -751,14 +751,14 @@ static irqreturn_t sh_mmcif_intr(int irq, void *dev_id)
sh_mmcif_bitclr(host, MMCIF_CE_INT_MASK, state);
err = 1;
} else {
- pr_debug("%s: Not support int\n", DRIVER_NAME);
+ pr_debug("Not support int\n");
sh_mmcif_writel(host->addr, MMCIF_CE_INT, ~state);
sh_mmcif_bitclr(host, MMCIF_CE_INT_MASK, state);
err = 1;
}
if (err) {
host->sd_error = 1;
- pr_debug("%s: int err state = %08x\n", DRIVER_NAME, state);
+ pr_debug("int err state = %08x\n", state);
}
host->wait_int = 1;
wake_up(&host->intr_wait);
@@ -779,7 +779,7 @@ static int __devinit sh_mmcif_probe(struct platform_device *pdev)
irq[0] = platform_get_irq(pdev, 0);
irq[1] = platform_get_irq(pdev, 1);
if (irq[0] < 0 || irq[1] < 0) {
- pr_err(DRIVER_NAME": Get irq error\n");
+ pr_err("Get irq error\n");
return -ENXIO;
}
res = platform_get_resource(pdev, IORESOURCE_MEM, 0);
@@ -847,22 +847,22 @@ static int __devinit sh_mmcif_probe(struct platform_device *pdev)

ret = request_irq(irq[0], sh_mmcif_intr, 0, "sh_mmc:error", host);
if (ret) {
- pr_err(DRIVER_NAME": request_irq error (sh_mmc:error)\n");
+ pr_err("request_irq error (sh_mmc:error)\n");
goto clean_up2;
}
ret = request_irq(irq[1], sh_mmcif_intr, 0, "sh_mmc:int", host);
if (ret) {
free_irq(irq[0], host);
- pr_err(DRIVER_NAME": request_irq error (sh_mmc:int)\n");
+ pr_err("request_irq error (sh_mmc:int)\n");
goto clean_up2;
}

sh_mmcif_writel(host->addr, MMCIF_CE_INT_MASK, MASK_ALL);
sh_mmcif_detect(host->mmc);

- pr_info("%s: driver version %s\n", DRIVER_NAME, DRIVER_VERSION);
- pr_debug("%s: chip ver H'%04x\n", DRIVER_NAME,
- sh_mmcif_readl(host->addr, MMCIF_CE_VERSION) & 0x0000ffff);
+ pr_info("driver version %s\n", DRIVER_VERSION);
+ pr_debug("chip ver H'%04x\n",
+ sh_mmcif_readl(host->addr, MMCIF_CE_VERSION) & 0x0000ffff);
return ret;

clean_up2:
@@ -904,7 +904,7 @@ static struct platform_driver sh_mmcif_driver = {
.probe = sh_mmcif_probe,
.remove = sh_mmcif_remove,
.driver = {
- .name = DRIVER_NAME,
+ .name = KMSG_COMPONENT,
},
};

@@ -924,5 +924,5 @@ module_exit(sh_mmcif_exit);

MODULE_DESCRIPTION("SuperH on-chip MMC/eMMC interface driver");
MODULE_LICENSE("GPL");
-MODULE_ALIAS(DRIVER_NAME);
+MODULE_ALIAS(KMSG_COMPONENT);
MODULE_AUTHOR("Yusuke Goda <yusuke.goda.sx@renesas.com>");
--
1.7.2.3