Re: [PATCH v2 0/8] Use gpio_request_one() in SH Mobile board code

[Simon Horman <horms@verge.net.au>]

On Mon, Jan 28, 2013 at 09:50:58AM +0900, Simon Horman wrote:
> On Fri, Jan 25, 2013 at 11:13:13AM +0100, Guennadi Liakhovetski wrote:
> > Hi Laurent
> > 
> > On Thu, 24 Jan 2013, Laurent Pinchart wrote:
> > 
> > > Hello,
> > > 
> > > Here are the second version of the gpio_request_one() patches for all SH Mobile
> > > board files.
> > > 
> > > Compared to v1 the patches have been rebased on top of "[PATCH v4 00/81] SH pin
> > > control and GPIO rework", as the previous base isn't ready for mainline yet.
> > > The patches are otherwise unchanged.
> > > 
> > > Simon, with the appropriate acks I think this series could go to v3.9. If you
> > > would like a pull request, on which of your branches should I rebase the
> > > patches ? I've tried to rebase them on top of your current next branch and they
> > > apply fine, so picking them up from the mailing list shouldn't be an issue
> > > either.
> > > 
> > > Laurent Pinchart (8):
> > 
> > All look good to me:
> > 
> > Acked-by: Guennadi Liakhovetski <g.liakhovetski@gmx.de>
> 
> Thanks, I'll apply this series.

I have applied them to the boards2 branch, which I plan to send a
pull-request for once the pull-request boards branch, which boards2 is
based on, has been accepted (or rejected!).

I have also merged the changes into the next branch so they should
appear in linux-next in the not too distant future.