From mboxrd@z Thu Jan 1 00:00:00 1970 From: Magnus Damm Date: Tue, 01 Oct 2013 10:33:05 +0000 Subject: [PATCH 01/05] ARM: shmobile: Sync KZM9D DTS with KZM9D reference DTS Message-Id: <20131001103305.813.70296.sendpatchset@w520> List-Id: References: <20131001103255.813.65710.sendpatchset@w520> In-Reply-To: <20131001103255.813.65710.sendpatchset@w520> MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: linux-arm-kernel@lists.infradead.org From: Magnus Damm Copy the device nodes from KZM9D reference into the KZM9D device tree file. This will allow us to use a single DTS file regarless of kernel configuration. In case of legacy C board code the device nodes may or may not be used, but in the multiplatform case all the DT device nodes are used. Signed-off-by: Magnus Damm --- arch/arm/boot/dts/emev2-kzm9d.dts | 33 ++++++++++++++++++++++++++++++++- 1 file changed, 32 insertions(+), 1 deletion(-) --- 0001/arch/arm/boot/dts/emev2-kzm9d.dts +++ work/arch/arm/boot/dts/emev2-kzm9d.dts 2013-09-26 19:42:16.000000000 +0900 @@ -1,7 +1,7 @@ /* * Device Tree Source for the KZM9D board * - * Copyright (C) 2012 Renesas Solutions Corp. + * Copyright (C) 2013 Renesas Solutions Corp. * * This file is licensed under the terms of the GNU General Public License * version 2. This program is licensed "as is" without any warranty of any @@ -23,4 +23,35 @@ chosen { bootargs = "console=ttyS1,115200n81 ignore_loglevel root=/dev/nfs ip=dhcp"; }; + + reg_1p8v: regulator@0 { + compatible = "regulator-fixed"; + regulator-name = "fixed-1.8V"; + regulator-min-microvolt = <1800000>; + regulator-max-microvolt = <1800000>; + regulator-always-on; + regulator-boot-on; + }; + + reg_3p3v: regulator@1 { + compatible = "regulator-fixed"; + regulator-name = "fixed-3.3V"; + regulator-min-microvolt = <3300000>; + regulator-max-microvolt = <3300000>; + regulator-always-on; + regulator-boot-on; + }; + + lan9220@20000000 { + compatible = "smsc,lan9220", "smsc,lan9115"; + reg = <0x20000000 0x10000>; + phy-mode = "mii"; + interrupt-parent = <&gpio0>; + interrupts = <1 1>; /* active high */ + reg-io-width = <4>; + smsc,irq-active-high; + smsc,irq-push-pull; + vddvario-supply = <®_1p8v>; + vdd33a-supply = <®_3p3v>; + }; };