From: Laurent Pinchart <laurent.pinchart@ideasonboard.com>
To: linux-sh@vger.kernel.org
Subject: Re: [PATCH 1/3] DMA: shdma: Fix warnings due to improper casts and printk formats
Date: Wed, 27 Nov 2013 16:03:25 +0000 [thread overview]
Message-ID: <2028164.izn6i5W5EG@avalon> (raw)
In-Reply-To: <1385512192-10303-1-git-send-email-laurent.pinchart+renesas@ideasonboard.com>
Hi Andy,
On Wednesday 27 November 2013 12:27:41 Shevchenko, Andriy wrote:
> On Wed, 2013-11-27 at 01:29 +0100, Laurent Pinchart wrote:
>
> > Use the %zu printk specifier to print size_t variables, and cast
> > pointers to unsigned long instead of unsigned int where applicable. This
> > fixes warnings on platforms where pointers and/or dma_addr_t have a
> > different size than int.
>
> Few comments below.
>
> > diff --git a/drivers/dma/sh/shdma-base.c b/drivers/dma/sh/shdma-base.c
> > index 2e7b394..b37d584 100644
> > --- a/drivers/dma/sh/shdma-base.c
> > +++ b/drivers/dma/sh/shdma-base.c
> > @@ -227,7 +227,7 @@ bool shdma_chan_filter(struct dma_chan *chan, void
> > *arg)
> > struct shdma_chan *schan = to_shdma_chan(chan);
> > struct shdma_dev *sdev = to_shdma_dev(schan->dma_chan.device);
> > const struct shdma_ops *ops = sdev->ops;
> > - int match = (int)arg;
> > + int match = (long)arg;
>
> As far as I understand this will lose data on 64bit platforms.
> Are you aware of it? Otherwise I don't see the advantage of such
> conversion. As far as I understand you may cast void * easily to long
> and back, otherwise you lost data.
That's correct, but shouldn't be an issue here. The match value is a small
integer. The reason why I cast it to long is to avoid compilation warnings
> > int ret;
> >
> > if (match < 0)
> > @@ -491,9 +491,9 @@ static struct shdma_desc *shdma_add_desc(struct
> > shdma_chan *schan,
> > }
> >
> > dev_dbg(schan->dev,
> > - "chaining (%u/%u)@%x -> %x with %p, cookie %d\n",
> > - copy_size, *len, *src, *dst, &new->async_tx,
> > - new->async_tx.cookie);
> > + "chaining (%zu/%zu)@%lx -> %lx with %p, cookie %d\n",
> > + copy_size, *len, (unsigned long)*src, (unsigned long)*dst,
> > + &new->async_tx, new->async_tx.cookie);
>
> Instead of dancing with casting (actually for dma_addr_t it should be
> ULL type), we can extend %pa to do this job for us:
That sounds good to me. Do you plan to submit a patch ? I'd like to get this
series upstream in v3.14.
> diff --git a/lib/vsprintf.c b/lib/vsprintf.c
> index 10909c5..0806bf0 100644
> --- a/lib/vsprintf.c
> +++ b/lib/vsprintf.c
> @@ -1354,10 +1354,17 @@ char *pointer(const char *fmt, char *buf, char
> *end, void *ptr,
> break;
> case 'a':
> spec.flags |= SPECIAL | SMALL | ZEROPAD;
> - spec.field_width = sizeof(phys_addr_t) * 2 + 2;
> spec.base = 16;
> - return number(buf, end,
> - (unsigned long long) *((phys_addr_t *)ptr), spec);
> + switch (fmt[1]) {
> + case 'D':
> + spec.field_width = sizeof(dma_addr_t) * 2 + 2;
> + return number(buf, end,
> + (unsigned long long)*((dma_addr_t *)ptr), spec);
> + default:
> + spec.field_width = sizeof(phys_addr_t) * 2 + 2;
> + return number(buf, end,
> + (unsigned long long)*((phys_addr_t *)ptr), spec);
> + }
> case 'd':
> return dentry_name(buf, end, ptr, spec, fmt);
> case 'D':
>
> Thus, use %paD.
>
>
> > new->mark = DESC_PREPARED;
> > new->async_tx.flags = flags;
> >
> > @@ -555,7 +555,7 @@ static struct dma_async_tx_descriptor
> > *shdma_prep_sg(struct shdma_chan *schan,
> > goto err_get_desc;
> >
> > do {
> > - dev_dbg(schan->dev, "Add SG #%d@%p[%d], dma %llx\n",
> > + dev_dbg(schan->dev, "Add SG #%d@%p[%zu], dma %llx\n",
> > i, sg, len, (unsigned long long)sg_addr);
> >
> > if (direction = DMA_DEV_TO_MEM)
> > diff --git a/drivers/dma/sh/shdma-of.c b/drivers/dma/sh/shdma-of.c
> > index 06473a0..7fdb67b 100644
> > --- a/drivers/dma/sh/shdma-of.c
> > +++ b/drivers/dma/sh/shdma-of.c
> > @@ -33,7 +33,8 @@ static struct dma_chan *shdma_of_xlate(struct
> > of_phandle_args *dma_spec,
> > /* Only slave DMA channels can be allocated via DT */
> > dma_cap_set(DMA_SLAVE, mask);
> >
> > - chan = dma_request_channel(mask, shdma_chan_filter, (void *)id);
> > + chan = dma_request_channel(mask, shdma_chan_filter,
> > + (void *)(unsigned long)id);
> > if (chan)
> > to_shdma_chan(chan)->hw_req = id;
> >
> > diff --git a/drivers/dma/sh/sudmac.c b/drivers/dma/sh/sudmac.c
> > index c7e9cdf..2112ed2 100644
> > --- a/drivers/dma/sh/sudmac.c
> > +++ b/drivers/dma/sh/sudmac.c
> > @@ -178,8 +178,8 @@ static int sudmac_desc_setup(struct shdma_chan
> > *schan,
> > struct sudmac_chan *sc = to_chan(schan);
> > struct sudmac_desc *sd = to_desc(sdesc);
> >
> > - dev_dbg(sc->shdma_chan.dev, "%s: src=%x, dst=%x, len=%d\n",
> > - __func__, src, dst, *len);
> > + dev_dbg(sc->shdma_chan.dev, "%s: src=%lx, dst=%lx, len=%zu\n",
> > + __func__, (unsigned long)src, (unsigned long)dst, *len);
> >
> > if (*len > schan->max_xfer_len)
> > *len = schan->max_xfer_len;
--
Regards,
Laurent Pinchart
next prev parent reply other threads:[~2013-11-27 16:03 UTC|newest]
Thread overview: 5+ messages / expand[flat|nested] mbox.gz Atom feed top
2013-11-27 0:29 [PATCH 1/3] DMA: shdma: Fix warnings due to improper casts and printk formats Laurent Pinchart
2013-11-27 12:27 ` Shevchenko, Andriy
2013-11-27 16:03 ` Laurent Pinchart [this message]
2013-11-27 16:24 ` Laurent Pinchart
2013-11-28 9:25 ` Andy Shevchenko
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=2028164.izn6i5W5EG@avalon \
--to=laurent.pinchart@ideasonboard.com \
--cc=linux-sh@vger.kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).