Re: emev2: clock driver dt proposal

[Ben Dooks <ben.dooks@codethink.co.uk>]

On 09/07/13 18:24, Ben Dooks wrote:
> To deal with peripheral clocks, I was working on the following idea
> for a clock binding to deal with the gclk and sclks to each peripheral.
>
> The parent control devices:
>
> sclk: clock-controller@e011600 {
> compatible = "renesas,em-sclk";
> reg = <0xe011600 0x100>;
>
>
> #clock-cells = <2>;
> };
>
> This registers a clock-divider for the clock and a clock-mux to control the
> divder's parents.
>
> gclk: clock-controller@e011400 {
> compatible = "renesas,em-gclk";
> reg = <0xe011400 0x200>;
> #clock-cells = <3>;
> }
>
> This driver provides the clock gates for both the bus clock and the sclk.
>
>
> For each peripheral:
>
> shdci0 {
> clocks = <&gclk 0xc8 0x5 0x2>, <&sclk 0x48 &pll3 &pll4 &osc0 &osc1>;
> clock-names = "bus", "sclk";
> }
>
> In this case, the gclk is in the form of:
>
> < &gclk register-offset-from-base bus-control-bitmask
> sclk-control-bitmask >
>
> And the sclk is in the form of:
>
> < &sclk register-offset-from-base
> parent-clock-0 parent-clock-1 parent-clock-2 parent-clock-3 >

Is anyone else working on EMEV2 clock-dt conversion, or should I go
ahead and start?

-- 
Ben Dooks				http://www.codethink.co.uk/
Senior Engineer				Codethink - Providing Genius