Re: [PATCH 3/3 V2] ARM: shmobile: koelsch: Add I2C support

[Valentine <valentine.barshak@cogentembedded.com>]

On 01/06/2014 10:15 AM, Simon Horman wrote:
> On Mon, Jan 06, 2014 at 03:07:36PM +0900, Simon Horman wrote:
>> On Mon, Jan 06, 2014 at 02:35:23PM +0900, Simon Horman wrote:
>>> On Fri, Dec 27, 2013 at 03:27:39PM +0400, Valentine Barshak wrote:
>>>> This adds I2C[1245] busses support to Koelsch board.
>>>> I2C[03] do not have any slave devices connected and
>>>> are not used because of the following:
>>>> * I2C0 pins are multiplexed with LBSC pins;
>>>> * I2C3 pins are multiplexed with EtherMAC and VIN0 pins.
>>>>
>>>> Changes in V2:
>>>> * Capitalized ARM in the subject.
>>>>
>>>> Signed-off-by: Valentine Barshak <valentine.barshak@cogentembedded.com>
>>>
>>> Thanks, I will queue this up.
>
> Bother, I was too hasty, it seems that there is a run-time dependency on
> patch 1 of the series.
>
>> Please send an update to the koelsch defconfig to enable I2C.
>
> Could you please repost this patch, along with a patch to update
> the defconfig once the dependencies are available in an rc release.

OK, thanks!

>
> I will leave patch 2 of the series queued up as it should be harmless enough.
>
> Thanks.
>

Thanks,
Val.