From mboxrd@z Thu Jan 1 00:00:00 1970 From: Marco Iannacone Subject: An unexpected IO-APIC was found Date: Tue, 1 Feb 2005 23:30:19 +0100 Message-ID: <200502012330.20004.ianna@pippo.com> Mime-Version: 1.0 Content-Transfer-Encoding: 7bit Content-Disposition: inline Sender: linux-smp-owner@vger.kernel.org List-Id: Content-Type: text/plain; charset="us-ascii" To: linux-smp@vger.kernel.org Dear Sirs, while reading the outcome of dmesg on my system, I found a message requesting me to report it to you. my kernel is: # uname -a Linux home 2.4.21-273-smp4G #1 SMP Mon Jan 17 13:19:07 UTC 2005 i686 i686 i386 GNU/Linux I'm running SuSE 9.0 on an Asus P4C800 Deluxe motherboard. below you can find the dmesg output containing your e-mail address. if you need additional information, just contact me. regards, Marco IO APIC #2...... .... register #00: 02000000 ....... : physical APIC id: 02 ....... : Delivery Type: 0 ....... : LTS : 0 .... register #01: 00178020 ....... : max redirection entries: 0017 ....... : PRQ implemented: 1 ....... : IO APIC version: 0020 .... register #02: 00178020 ....... : arbitration: 00 An unexpected IO-APIC was found. If this kernel release is less than three months old please report this to linux-smp@vger.kernel.org .... IRQ redirection table: NR Log Phy Mask Trig IRR Pol Stat Dest Deli Vect: 00 000 00 1 0 0 0 0 0 0 00 01 003 03 0 0 0 0 0 1 1 39 02 003 03 0 0 0 0 0 1 1 31 03 003 03 0 0 0 0 0 1 1 41 04 003 03 0 0 0 0 0 1 1 49 05 003 03 0 0 0 0 0 1 1 51 06 003 03 0 0 0 0 0 1 1 59 07 003 03 0 0 0 0 0 1 1 61 08 003 03 0 0 0 0 0 1 1 69 09 003 03 1 1 0 0 0 1 1 71 0a 003 03 0 0 0 0 0 1 1 79 0b 003 03 0 0 0 0 0 1 1 81 0c 003 03 0 0 0 0 0 1 1 89 0d 003 03 0 0 0 0 0 1 1 91 0e 003 03 0 0 0 0 0 1 1 99 0f 003 03 0 0 0 0 0 1 1 A1 10 000 00 1 0 0 0 0 0 0 00 11 000 00 1 0 0 0 0 0 0 00 12 000 00 1 0 0 0 0 0 0 00 13 000 00 1 0 0 0 0 0 0 00 14 000 00 1 0 0 0 0 0 0 00 15 000 00 1 0 0 0 0 0 0 00 16 000 00 1 0 0 0 0 0 0 00 17 000 00 1 0 0 0 0 0 0 00 IRQ to pin mappings: IRQ0 -> 0:2 IRQ1 -> 0:1 IRQ3 -> 0:3 IRQ4 -> 0:4 IRQ5 -> 0:5 IRQ6 -> 0:6 IRQ7 -> 0:7 IRQ8 -> 0:8 IRQ9 -> 0:9 IRQ10 -> 0:10 IRQ11 -> 0:11 IRQ12 -> 0:12 IRQ13 -> 0:13 IRQ14 -> 0:14 IRQ15 -> 0:15 .................................... done. Using local APIC timer interrupts. calibrating APIC timer ... ..... CPU clock speed is 2998.0048 MHz. ..... host bus clock speed is 199.0869 MHz. cpu: 0, clocks: 199869, slice: 66623 CPU0 cpu: 1, clocks: 199869, slice: 66623 CPU1 checking TSC synchronization across CPUs: passed. migration_task 0 on cpu=0 migration_task 1 on cpu=1 ACPI: Subsystem revision 20030619 PCI: PCI BIOS revision 2.10 entry at 0xf0031, last bus=2 PCI: Using configuration type 1 Looking for DSDT in initrd ... not found! IOAPIC[0]: Set PCI routing entry (2-9 -> 0x71 -> IRQ 9) Mode:1 Active:0 ACPI: Interpreter enabled ACPI: Using IOAPIC for interrupt routing ACPI: System [ACPI] (supports S0 S1 S3 S4 S5) ACPI: PCI Root Bridge [PCI0] (00:00) PCI: Probing PCI hardware (bus 00) PCI: Ignoring BAR0-3 of IDE controller 00:1f.2 Transparent bridge - Intel Corp. 82801BA/CA/DB/EB PCI Bridge ACPI: PCI Interrupt Routing Table [\_SB_.PCI0._PRT] ACPI: PCI Interrupt Routing Table [\_SB_.PCI0.P0P4._PRT]