Linux version 2.4.19-rc3-ac5x (root@bad-dad) (gcc version 2.96 20000731 (Red Hat Linux 7.1 2.96-98)) #2 Wed Jul 31 18:39:51 MDT 2002 BIOS-provided physical RAM map: BIOS-e820: 0000000000000000 - 000000000009fc00 (usable) BIOS-e820: 000000000009fc00 - 00000000000a0000 (reserved) BIOS-e820: 00000000000f0000 - 0000000000100000 (reserved) BIOS-e820: 0000000000100000 - 0000000010000000 (usable) BIOS-e820: 00000000fec00000 - 00000000fec01000 (reserved) BIOS-e820: 00000000fee00000 - 00000000fee01000 (reserved) BIOS-e820: 00000000ffff0000 - 0000000100000000 (reserved) 256MB LOWMEM available. found SMP MP-table at 000f5420 hm, page 000f5000 reserved twice. hm, page 000f6000 reserved twice. hm, page 000f1000 reserved twice. hm, page 000f2000 reserved twice. On node 0 totalpages: 65536 zone(0): 4096 pages. zone(1): 61440 pages. zone(2): 0 pages. Intel MultiProcessor Specification v1.1 Virtual Wire compatibility mode. OEM ID: OEM00000 Product ID: PROD00000000 APIC at: 0xFEE00000 Processor #0 Pentium(tm) Pro APIC version 17 I/O APIC #2 Version 17 at 0xFEC00000. Enabling APIC mode: Flat. Using 1 I/O APICs Processors: 1 Kernel command line: BOOT_IMAGE=2.4.19-rc3-ac5x ro root=307 mem=nopentium pci=biosirq video=aty128fb:1024x768 s Initializing CPU#0 Detected 1460.482 MHz processor. Console: colour VGA+ 80x25 Calibrating delay loop... 2916.35 BogoMIPS Memory: 256416k/262144k available (990k kernel code, 5340k reserved, 255k data, 256k init, 0k highmem) Checking if this processor honours the WP bit even in supervisor mode... Ok. Dentry cache hash table entries: 32768 (order: 6, 262144 bytes) Inode cache hash table entries: 16384 (order: 5, 131072 bytes) Mount cache hash table entries: 4096 (order: 3, 32768 bytes) ramfs: mounted with options: ramfs: max_pages=32052 max_file_pages=0 max_inodes=0 max_dentries=32052 Buffer cache hash table entries: 16384 (order: 4, 65536 bytes) Page-cache hash table entries: 65536 (order: 6, 262144 bytes) CPU: Before vendor init, caps: 0383fbff c1cbfbff 00000000, vendor = 2 CPU: L1 I Cache: 64K (64 bytes/line), D cache 64K (64 bytes/line) CPU: L2 Cache: 256K (64 bytes/line) CPU: After vendor init, caps: 0383fbff c1cbfbff 00000000 00000000 Intel machine check architecture supported. Intel machine check reporting enabled on CPU#0. CPU: After generic, caps: 0383fbff c1cbfbff 00000000 00000000 CPU: Common caps: 0383fbff c1cbfbff 00000000 00000000 CPU: AMD Athlon(tm) XP 1700+ stepping 02 Enabling fast FPU save and restore... done. Enabling unmasked SIMD FPU exception support... done. Checking 'hlt' instruction... OK. POSIX conformance testing by UNIFIX enabled ExtINT on CPU#0 ESR value before enabling vector: 00000000 ESR value after enabling vector: 00000000 ENABLING IO-APIC IRQs Setting 2 in the phys_id_present_map ...changing IO-APIC physical APIC ID to 2 ... ok. init IO_APIC IRQs IO-APIC (apicid-pin) 2-0, 2-7, 2-10, 2-11, 2-16, 2-17, 2-20, 2-21, 2-22 not connected. ..TIMER: vector=0x31 pin1=2 pin2=0 number of MP IRQ sources: 16. number of IO-APIC #2 registers: 24. testing the IO APIC....................... IO APIC #2...... .... register #00: 02000000 ....... : physical APIC id: 02 .... register #01: 00178000 ....... : max redirection entries: 0017 ....... : PRQ implemented: 1 ....... : IO APIC version: 0000 An unexpected IO-APIC was found. If this kernel release is less than three months old please report this to linux-smp@vger.kernel.org .... IRQ redirection table: NR Log Phy Mask Trig IRR Pol Stat Dest Deli Vect: 00 000 00 1 0 0 0 0 0 0 00 01 001 01 0 0 0 0 0 1 1 39 02 001 01 0 0 0 0 0 1 1 31 03 001 01 0 0 0 0 0 1 1 41 04 001 01 0 0 0 0 0 1 1 49 05 001 01 0 0 0 0 0 1 1 51 06 001 01 0 0 0 0 0 1 1 59 07 000 00 1 0 0 0 0 0 0 00 08 001 01 0 0 0 0 0 1 1 61 09 001 01 0 0 0 0 0 1 1 69 0a 000 00 1 0 0 0 0 0 0 00 0b 000 00 1 0 0 0 0 0 0 00 0c 001 01 0 0 0 0 0 1 1 71 0d 001 01 0 0 0 0 0 1 1 79 0e 001 01 0 0 0 0 0 1 1 81 0f 001 01 0 0 0 0 0 1 1 89 10 000 00 1 0 0 0 0 0 0 00 11 000 00 1 0 0 0 0 0 0 00 12 001 01 1 1 0 1 0 1 1 91 13 001 01 1 1 0 1 0 1 1 99 14 000 00 1 0 0 0 0 0 0 00 15 000 00 1 0 0 0 0 0 0 00 16 000 00 1 0 0 0 0 0 0 00 17 001 01 1 1 0 1 0 1 1 A1 IRQ to pin mappings: IRQ0 -> 0:2 IRQ1 -> 0:1 IRQ3 -> 0:3 IRQ4 -> 0:4 IRQ5 -> 0:5 IRQ6 -> 0:6 IRQ7 -> 0:23 IRQ8 -> 0:8 IRQ9 -> 0:9 IRQ10 -> 0:18 IRQ11 -> 0:19 IRQ12 -> 0:12 IRQ13 -> 0:13 IRQ14 -> 0:14 IRQ15 -> 0:15 .................................... done. Using local APIC timer interrupts. calibrating APIC timer ... ..... CPU clock speed is 1460.4553 MHz. ..... host bus clock speed is 265.5372 MHz. cpu: 0, clocks: 2655372, slice: 1327686 CPU0 mtrr: v1.40 (20010327) Richard Gooch (rgooch@atnf.csiro.au) mtrr: detected mtrr type: Intel PCI: PCI BIOS revision 2.10 entry at 0xfb140, last bus=1 PCI: Using configuration type 1 PCI: Probing PCI hardware PCI: Using IRQ router SIS [1039/0008] at 00:02.0 Linux NET4.0 for Linux 2.4 Based upon Swansea University Computer Society NET3.039 Initializing RT netlink socket apm: BIOS version 1.2 Flags 0x07 (Driver version 1.16) Starting kswapd Journalled Block Device driver loaded PCI: No IRQ known for interrupt pin A of device 01:00.0. Probably buggy MP table. aty128fb: Rage128 BIOS located at segment C00C0000 aty128fb: Rage128 Pro TF (AGP) [chip rev 0x4] 32M 128-bit SDR SGRAM (1:1) Console: switching to colour frame buffer device 128x48 fb0: ATY Rage128 frame buffer device on PCI mtrr: no more MTRRs available aty128fb: Rage128 MTRR set to ON pty: 256 Unix98 ptys configured Serial driver version 5.05c (2001-07-08) with MANY_PORTS SHARE_IRQ SERIAL_PCI enabled ttyS00 at 0x03f8 (irq = 4) is a 16550A ttyS01 at 0x02f8 (irq = 3) is a 16550A Real Time Clock Driver v1.10e block: 496 slots per queue, batch=124 Uniform Multi-Platform E-IDE driver Revision: 6.31 ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx SIS5513: IDE controller on PCI bus 00 dev 15 SIS5513: chipset revision 208 SIS5513: not 100% native mode: will probe irqs later SiS735 ATA 100 controller ide0: BM-DMA at 0x4000-0x4007, BIOS settings: hda:DMA, hdb:pio ide1: BM-DMA at 0x4008-0x400f, BIOS settings: hdc:DMA, hdd:DMA hda: MAXTOR 6L060L3, ATA DISK drive hdc: LITEON DVD-ROM LTD163, ATAPI CD/DVD-ROM drive hdd: PCRW804, ATAPI CD/DVD-ROM drive ide0 at 0x1f0-0x1f7,0x3f6 on irq 14 ide1 at 0x170-0x177,0x376 on irq 15 hda: host protected area => 1 hda: 117266688 sectors (60041 MB) w/1819KiB Cache, CHS=7299/255/63, UDMA(100) Partition check: hda: hda1 hda2 < hda5 hda6 hda7 hda8 hda9 hda10 hda11 hda12 hda13 > RAMDISK driver initialized: 16 RAM disks of 8192K size 1024 blocksize Linux agpgart interface v0.99 (c) Jeff Hartmann agpgart: Maximum main memory to use for agp memory: 204M agpgart: Detected SiS 735 chipset agpgart: AGP aperture is 64M @ 0xe0000000 [drm] AGP 0.99 on SiS @ 0xe0000000 64MB [drm] Initialized r128 2.2.0 20010917 on minor 0 NET4: Linux TCP/IP 1.0 for NET4.0 IP Protocols: ICMP, UDP, TCP IP: routing cache hash table of 2048 buckets, 16Kbytes TCP: Hash tables configured (established 16384 bind 32768) NET4: Unix domain sockets 1.0/SMP for Linux NET4.0. kjournald starting. Commit interval 5 seconds EXT3-fs: mounted filesystem with ordered data mode. VFS: Mounted root (ext3 filesystem) readonly. Freeing unused kernel memory: 256k freed Adding Swap: 497972k swap-space (priority -1) EXT3 FS 2.4-0.9.18, 14 May 2002 on ide0(3,7), internal journal kjournald starting. Commit interval 5 seconds EXT3-fs warning: maximal mount count reached, running e2fsck is recommended EXT3 FS 2.4-0.9.18, 14 May 2002 on ide0(3,5), internal journal EXT3-fs: mounted filesystem with ordered data mode. kjournald starting. Commit interval 5 seconds EXT3 FS 2.4-0.9.18, 14 May 2002 on ide0(3,8), internal journal EXT3-fs: mounted filesystem with ordered data mode. kjournald starting. Commit interval 5 seconds EXT3 FS 2.4-0.9.18, 14 May 2002 on ide0(3,9), internal journal EXT3-fs: mounted filesystem with ordered data mode. kjournald starting. Commit interval 5 seconds EXT3 FS 2.4-0.9.18, 14 May 2002 on ide0(3,10), internal journal EXT3-fs: mounted filesystem with ordered data mode. kjournald starting. Commit interval 5 seconds EXT3 FS 2.4-0.9.18, 14 May 2002 on ide0(3,11), internal journal EXT3-fs: mounted filesystem with ordered data mode.