From: daniel.lezcano@linaro.org (Daniel Lezcano)
To: linux-snps-arc@lists.infradead.org
Subject: [PATCH V3] clocksource/drivers/arc: Convert init function to return error
Date: Fri, 17 Jun 2016 12:09:27 +0200 [thread overview]
Message-ID: <1466158167-23126-1-git-send-email-daniel.lezcano@linaro.org> (raw)
In-Reply-To: <5763BC00.1030101@synopsys.com>
The init functions do not return any error. They behave as the following:
- panic, thus leading to a kernel crash while another timer may work and
make the system boot up correctly
or
- print an error and let the caller unaware if the state of the system
Change that by converting the init functions to return an error conforming
to the CLOCKSOURCE_OF_RET prototype.
Proper error handling (rollback, errno value) will be changed later case
by case, thus this change just return back an error or success in the init
function.
Signed-off-by: Daniel Lezcano <daniel.lezcano at linaro.org>
---
arch/arc/kernel/time.c | 69 ++++++++++++++++++++++++++++++--------------------
1 file changed, 42 insertions(+), 27 deletions(-)
diff --git a/arch/arc/kernel/time.c b/arch/arc/kernel/time.c
index 4549ab2..b211f80 100644
--- a/arch/arc/kernel/time.c
+++ b/arch/arc/kernel/time.c
@@ -116,21 +116,21 @@ static struct clocksource arc_counter_gfrc = {
.flags = CLOCK_SOURCE_IS_CONTINUOUS,
};
-static void __init arc_cs_setup_gfrc(struct device_node *node)
+static int __init arc_cs_setup_gfrc(struct device_node *node)
{
int exists = cpuinfo_arc700[0].extn.gfrc;
int ret;
if (WARN(!exists, "Global-64-bit-Ctr clocksource not detected"))
- return;
+ return -ENXIO;
ret = arc_get_timer_clk(node);
if (ret)
- return;
+ return ret;
- clocksource_register_hz(&arc_counter_gfrc, arc_timer_freq);
+ return clocksource_register_hz(&arc_counter_gfrc, arc_timer_freq);
}
-CLOCKSOURCE_OF_DECLARE(arc_gfrc, "snps,archs-timer-gfrc", arc_cs_setup_gfrc);
+CLOCKSOURCE_OF_DECLARE_RET(arc_gfrc, "snps,archs-timer-gfrc", arc_cs_setup_gfrc);
#endif
@@ -172,27 +172,27 @@ static struct clocksource arc_counter_rtc = {
.flags = CLOCK_SOURCE_IS_CONTINUOUS,
};
-static void __init arc_cs_setup_rtc(struct device_node *node)
+static int __init arc_cs_setup_rtc(struct device_node *node)
{
int exists = cpuinfo_arc700[smp_processor_id()].extn.rtc;
int ret;
if (WARN(!exists, "Local-64-bit-Ctr clocksource not detected"))
- return;
+ return -ENXIO;
/* Local to CPU hence not usable in SMP */
if (WARN(IS_ENABLED(CONFIG_SMP), "Local-64-bit-Ctr not usable in SMP"))
- return;
+ return -EINVAL;
ret = arc_get_timer_clk(node);
if (ret)
- return;
+ return ret;
write_aux_reg(AUX_RTC_CTRL, 1);
- clocksource_register_hz(&arc_counter_rtc, arc_timer_freq);
+ return clocksource_register_hz(&arc_counter_rtc, arc_timer_freq);
}
-CLOCKSOURCE_OF_DECLARE(arc_rtc, "snps,archs-timer-rtc", arc_cs_setup_rtc);
+CLOCKSOURCE_OF_DECLARE_RET(arc_rtc, "snps,archs-timer-rtc", arc_cs_setup_rtc);
#endif
@@ -213,23 +213,23 @@ static struct clocksource arc_counter_timer1 = {
.flags = CLOCK_SOURCE_IS_CONTINUOUS,
};
-static void __init arc_cs_setup_timer1(struct device_node *node)
+static int __init arc_cs_setup_timer1(struct device_node *node)
{
int ret;
/* Local to CPU hence not usable in SMP */
if (IS_ENABLED(CONFIG_SMP))
- return;
+ return -EINVAL;
ret = arc_get_timer_clk(node);
if (ret)
- return;
+ return ret;
write_aux_reg(ARC_REG_TIMER1_LIMIT, ARC_TIMER_MAX);
write_aux_reg(ARC_REG_TIMER1_CNT, 0);
write_aux_reg(ARC_REG_TIMER1_CTRL, TIMER_CTRL_NH);
- clocksource_register_hz(&arc_counter_timer1, arc_timer_freq);
+ return clocksource_register_hz(&arc_counter_timer1, arc_timer_freq);
}
/********** Clock Event Device *********/
@@ -324,20 +324,28 @@ static struct notifier_block arc_timer_cpu_nb = {
/*
* clockevent setup for boot CPU
*/
-static void __init arc_clockevent_setup(struct device_node *node)
+static int __init arc_clockevent_setup(struct device_node *node)
{
struct clock_event_device *evt = this_cpu_ptr(&arc_clockevent_device);
int ret;
- register_cpu_notifier(&arc_timer_cpu_nb);
+ ret = register_cpu_notifier(&arc_timer_cpu_nb);
+ if (ret) {
+ pr_err("Failed to register cpu notifier");
+ return ret;
+ }
arc_timer_irq = irq_of_parse_and_map(node, 0);
- if (arc_timer_irq <= 0)
- panic("clockevent: missing irq");
+ if (arc_timer_irq <= 0) {
+ pr_err("clockevent: missing irq");
+ return -EINVAL;
+ }
ret = arc_get_timer_clk(node);
- if (ret)
- panic("clockevent: missing clk");
+ if (ret) {
+ pr_err("clockevent: missing clk");
+ return ret;
+ }
evt->irq = arc_timer_irq;
evt->cpumask = cpumask_of(smp_processor_id());
@@ -347,24 +355,31 @@ static void __init arc_clockevent_setup(struct device_node *node)
/* Needs apriori irq_set_percpu_devid() done in intc map function */
ret = request_percpu_irq(arc_timer_irq, timer_irq_handler,
"Timer0 (per-cpu-tick)", evt);
- if (ret)
- panic("clockevent: unable to request irq\n");
+ if (ret) {
+ pr_err("clockevent: unable to request irq\n");
+ returnr ret;
+ }
enable_percpu_irq(arc_timer_irq, 0);
+
+ return 0;
}
-static void __init arc_of_timer_init(struct device_node *np)
+static int __init arc_of_timer_init(struct device_node *np)
{
static int init_count = 0;
+ int ret;
if (!init_count) {
init_count = 1;
- arc_clockevent_setup(np);
+ ret = arc_clockevent_setup(np);
} else {
- arc_cs_setup_timer1(np);
+ ret = arc_cs_setup_timer1(np);
}
+
+ return ret;
}
-CLOCKSOURCE_OF_DECLARE(arc_clkevt, "snps,arc-timer", arc_of_timer_init);
+CLOCKSOURCE_OF_DECLARE_RET(arc_clkevt, "snps,arc-timer", arc_of_timer_init);
/*
* Called from start_kernel() - boot CPU only
--
1.9.1
next prev parent reply other threads:[~2016-06-17 10:09 UTC|newest]
Thread overview: 21+ messages / expand[flat|nested] mbox.gz Atom feed top
[not found] <1466112442-31105-1-git-send-email-daniel.lezcano@linaro.org>
2016-06-16 21:27 ` [PATCH V2 61/63] clocksource/drivers/arc: Convert init function to return error Daniel Lezcano
2016-06-17 8:59 ` Vineet Gupta
2016-06-17 10:09 ` Daniel Lezcano [this message]
2016-06-17 14:30 ` [PATCH V3] " Vineet Gupta
2016-06-24 4:06 ` Vineet Gupta
2016-06-24 6:41 ` Daniel Lezcano
2016-06-24 7:52 ` Vineet Gupta
2016-06-24 7:55 ` Daniel Lezcano
2016-06-16 21:27 ` [PATCH V2 63/63] clocksources: Switch back to the clksrc table Daniel Lezcano
2016-06-17 8:36 ` Krzysztof Kozlowski
2016-06-17 16:04 ` Santosh Shilimkar
2016-06-17 16:18 ` Matthias Brugger
2016-06-18 13:48 ` Heiko Stübner
2016-06-20 7:43 ` Patrice Chotard
2016-06-20 9:17 ` Liviu Dudau
2016-06-20 9:19 ` Neil Armstrong
2016-06-20 17:03 ` Sylvain Lemieux
2016-06-21 6:00 ` Ray Jui
2016-06-21 6:45 ` Noam Camus
2016-06-24 7:13 ` Chen-Yu Tsai
2016-06-24 20:12 ` Carlo Caione
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=1466158167-23126-1-git-send-email-daniel.lezcano@linaro.org \
--to=daniel.lezcano@linaro.org \
--cc=linux-snps-arc@lists.infradead.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).