Re: [PATCH v5] ALSA: hda/tas2781: Add speaker id check for ASUS projects

[Andy Shevchenko <andriy.shevchenko@linux.intel.com>]

On Mon, Nov 18, 2024 at 11:14:15AM +0200, Andy Shevchenko wrote:
> On Sat, Nov 16, 2024 at 03:50:06PM +0800, Baojun Xu wrote:
> > Add speaker id check by gpio in ACPI for ASUS projects.
> > In other vendors, speaker id was checked by BIOS, and was applied in
> > last bit of subsys id, so we can load corresponding firmware binary file
> > for its speaker by subsys id.
> > But in ASUS project, the firmware binary name will be appended an extra
> > number to tell the speakers from different vendors. And this single digit
> > come from gpio level of speaker id in BIOS.

...

> > +	// Speaker id was needed for ASUS projects.
> > +	if (!strncmp(sub, TAS2781_ASUS_ID, strlen(TAS2781_ASUS_ID))) {
> 
> Better approach is

	u16 vid, did;

> 	ret = sscanf(sub, "%04x%04x", &vid, &did);
> 	if (ret == 2 && vid == ASUS_ID) {
> 		... // matched to ASUS_ID
> 	} else {
> 		... // no match
> 	}
> 
> Alternatively it can be
> 
> 	u32 subid;
> 
> 	ret = kstrtou32(sub, 16, &subid);
> 	if (ret || upper_16_bits(subid) != ASUS_ID) {
> 		... // no match (as in previous 'else')
> 	} else {
> 		... // matched to ASUS_ID
> 	}
> 
> With it it will be clearer to see what's going on here.
> 
> With the above you can get rid of the custom constant and
> use PCI_VENDOR_ID_ASUSTEK directly.

-- 
With Best Regards,
Andy Shevchenko