From mboxrd@z Thu Jan 1 00:00:00 1970 From: hcchin@strd.csam.com.my Date: Thu, 13 May 1999 03:48:20 +0000 Subject: SB16 Message-Id: List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: linux-sound@vger.kernel.org Hi all, I am still having problems with configuring my SB16 sound card. I am using Slakware with kernal 2.0.30. I compile the kernal with Sound ? M support for /dev/dsp and /dev/audio ? Y Other I put N. I use the isapnptools_1.17 to configure, I read the manual, readme, and HOW-TO, tring a few times. Still unable to setup my sound card. (One thing good with Windows'95, the driver is really easy to install, linux must improve with these) Nottingham said that my dirver(Sound Driver:3.5.4-960630) is the old one, will this old one work with SB16? Or how could I get the new sound driver? The below that show on my Linux:- % isapnp /etc/isapnp.conf Board 1 has Identity d7 00 00 15 f5 24 00 8c 0e: CTL0024 Serial No 5621 [checksum d7] CTL0024/5621[0]{Audio }: Ports 0x220 0x330 0x388; IRQ5 DMA1 DMA5 --- Enabled OK % insmod sound (I did check sound module was not loaded before this) % lsmod Module: #pages: Used by: sound 10 0 ppp 5 0 slip 2 0 slhc 2 [ppp slip] 0 lp 2 0 BUT % cat /dev/sndstat Sound Driver:3.5.4-960630 (Tue Mar 2 05:22:12 SGT 1999 root, Config options: 0 Installed drivers: Card config: Audio devices: Synth devices: NOT ENABLED IN CONFIG Midi devices: NOT ENABLED IN CONFIG Timers: Mixers: So I can't use the device, what is going wrong?