[PATCH 05/16] spi: spi-bfin5xx: Calculate transfer speed unconditionally

[Jarkko Nikula <jarkko.nikula-VuQAYsv1563Yd54FQh9/CA@public.gmane.org>]

SPI core validates the transfer speed and defaults to spi->max_speed_hz in
case the transfer speed is not set so code here won't use the
chip->baud value (which is derived from spi->max_speed_hz).

Please note driver uses chip->baud at the beginning of message transmission
by calling the bfin_spi_restore_state() but then programs per transfer
speed in bfin_spi_pump_transfers(). I'm not familiar with the HW so I don't
know would it be possible to remove chip->baud completely by either using
constant value in bfin_spi_restore_state() or by removing the baud register
write there.

Signed-off-by: Jarkko Nikula <jarkko.nikula-VuQAYsv1563Yd54FQh9/CA@public.gmane.org>
---
 drivers/spi/spi-bfin5xx.c | 6 +-----
 1 file changed, 1 insertion(+), 5 deletions(-)

diff --git a/drivers/spi/spi-bfin5xx.c b/drivers/spi/spi-bfin5xx.c
index a3d65b4f4944..1e91325bf39c 100644
--- a/drivers/spi/spi-bfin5xx.c
+++ b/drivers/spi/spi-bfin5xx.c
@@ -661,11 +661,7 @@ static void bfin_spi_pump_transfers(unsigned long data)
 	message->state = RUNNING_STATE;
 	dma_config = 0;
 
-	/* Speed setup (surely valid because already checked) */
-	if (transfer->speed_hz)
-		bfin_write(&drv_data->regs->baud, hz_to_spi_baud(transfer->speed_hz));
-	else
-		bfin_write(&drv_data->regs->baud, chip->baud);
+	bfin_write(&drv_data->regs->baud, hz_to_spi_baud(transfer->speed_hz));
 
 	bfin_write(&drv_data->regs->stat, BIT_STAT_CLR);
 	bfin_spi_cs_active(drv_data, chip);
-- 
2.5.1

--
To unsubscribe from this list: send the line "unsubscribe linux-spi" in
the body of a message to majordomo-u79uwXL29TY76Z2rM5mHXA@public.gmane.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html