From: Rob Herring <robh@kernel.org>
To: Sergiu Moga <sergiu.moga@microchip.com>
Cc: mturquette@baylibre.com, jirislaby@kernel.org,
richard.genoud@gmail.com, claudiu.beznea@microchip.com,
krzysztof.kozlowski+dt@linaro.org, radu_nicolae.pirea@upb.ro,
linux-arm-kernel@lists.infradead.org, linux-clk@vger.kernel.org,
broonie@kernel.org, kavyasree.kotagiri@microchip.com,
linux-kernel@vger.kernel.org, sboyd@kernel.org,
linux-spi@vger.kernel.org, alexandre.belloni@bootlin.com,
tudor.ambarus@microchip.com, gregkh@linuxfoundation.org,
admin@hifiphile.com, linux-serial@vger.kernel.org,
lee@kernel.org, devicetree@vger.kernel.org, robh+dt@kernel.org,
nicolas.ferre@microchip.com
Subject: Re: [PATCH v2 01/13] spi: dt-bindings: atmel,at91rm9200-spi: Add DMA related properties
Date: Tue, 06 Sep 2022 16:41:00 -0500 [thread overview]
Message-ID: <1662500460.128889.1224960.nullmailer@robh.at.kernel.org> (raw)
In-Reply-To: <20220906135511.144725-2-sergiu.moga@microchip.com>
On Tue, 06 Sep 2022 16:55:00 +0300, Sergiu Moga wrote:
> The DT nodes of the SPI IP's may contain DMA related properties so
> make sure that the binding is able to properly validate those as
> well by making it aware of these optional properties.
>
> Signed-off-by: Sergiu Moga <sergiu.moga@microchip.com>
> ---
>
>
> v1 -> v2:
> - Nothing, this patch was not here before
>
>
> .../devicetree/bindings/spi/atmel,at91rm9200-spi.yaml | 10 ++++++++++
> 1 file changed, 10 insertions(+)
>
Running 'make dtbs_check' with the schema in this patch gives the
following warnings. Consider if they are expected or the schema is
incorrect. These may not be new warnings.
Note that it is not yet a requirement to have 0 warnings for dtbs_check.
This will change in the future.
Full log is available here: https://patchwork.ozlabs.org/patch/
spi@400: dma-names:0: 'tx' was expected
arch/arm/boot/dts/at91-sama7g5ek.dtb
spi@400: dma-names:1: 'rx' was expected
arch/arm/boot/dts/at91-sama7g5ek.dtb
spi@400: Unevaluated properties are not allowed ('dma-names' was unexpected)
arch/arm/boot/dts/at91-sama7g5ek.dtb
next prev parent reply other threads:[~2022-09-06 21:41 UTC|newest]
Thread overview: 46+ messages / expand[flat|nested] mbox.gz Atom feed top
2022-09-06 13:54 [PATCH v2 00/13] Make atmel serial driver aware of GCLK Sergiu Moga
2022-09-06 13:55 ` [PATCH v2 01/13] spi: dt-bindings: atmel,at91rm9200-spi: Add DMA related properties Sergiu Moga
2022-09-06 15:12 ` Mark Brown
2022-09-06 21:41 ` Rob Herring [this message]
2022-09-07 7:54 ` Sergiu.Moga
2022-09-08 12:23 ` Krzysztof Kozlowski
2022-09-06 13:55 ` [PATCH v2 02/13] ARM: dts: at91: sama7g5: Swap rx and tx for spi11 Sergiu Moga
2022-09-06 13:55 ` [PATCH v2 03/13] dt-bindings: mfd: atmel,sama5d2-flexcom: Add SPI child node ref binding Sergiu Moga
2022-09-08 12:23 ` Krzysztof Kozlowski
2022-09-06 13:55 ` [PATCH v2 04/13] ARM: dts: at91: sam9x60ek: Add DBGU compatibles to uart1 Sergiu Moga
2022-09-06 13:55 ` [PATCH v2 05/13] dt-bindings: serial: atmel,at91-usart: convert to json-schema Sergiu Moga
2022-09-08 12:29 ` Krzysztof Kozlowski
2022-09-08 15:06 ` Sergiu.Moga
2022-09-08 15:10 ` Krzysztof Kozlowski
2022-09-08 15:27 ` Sergiu.Moga
2022-09-08 16:05 ` Krzysztof Kozlowski
2022-09-06 13:55 ` [PATCH v2 06/13] dt-bindings: serial: atmel,at91-usart: Add SAM9260 compatibles to SAM9x60 Sergiu Moga
2022-09-08 12:30 ` Krzysztof Kozlowski
2022-09-08 15:15 ` Sergiu.Moga
2022-09-09 1:36 ` Rob Herring
2022-09-12 7:45 ` Sergiu.Moga
2022-09-12 10:44 ` Krzysztof Kozlowski
2022-09-12 13:09 ` Sergiu.Moga
2022-09-13 8:58 ` Krzysztof Kozlowski
2022-09-13 9:19 ` Sergiu.Moga
2022-09-13 9:30 ` Krzysztof Kozlowski
2022-09-13 9:35 ` Sergiu.Moga
2022-09-06 13:55 ` [PATCH v2 07/13] dt-bindings: mfd: atmel,sama5d2-flexcom: Add USART child node ref binding Sergiu Moga
2022-09-08 12:33 ` Krzysztof Kozlowski
2022-09-06 13:55 ` [PATCH v2 08/13] tty: serial: atmel: Define GCLK as USART baudrate source clock Sergiu Moga
2022-09-07 9:21 ` Ilpo Järvinen
2022-09-07 9:37 ` Sergiu.Moga
2022-09-06 13:55 ` [PATCH v2 09/13] tty: serial: atmel: Define BRSRCCK bitmask of UART IP's Mode Register Sergiu Moga
2022-09-07 9:24 ` Ilpo Järvinen
2022-09-06 13:55 ` [PATCH v2 10/13] tty: serial: atmel: Only divide Clock Divisor if the IP is USART Sergiu Moga
2022-09-07 9:23 ` Ilpo Järvinen
2022-09-07 9:34 ` Sergiu.Moga
2022-09-06 13:55 ` [PATCH v2 11/13] clk: at91: sama5d2: Add Generic Clocks for UART/USART Sergiu Moga
2022-09-06 13:55 ` [PATCH v2 12/13] tty: serial: atmel: Make the driver aware of the existence of GCLK Sergiu Moga
2022-09-07 9:36 ` Ilpo Järvinen
2022-09-07 11:11 ` Sergiu.Moga
2022-09-07 11:29 ` Ilpo Järvinen
2022-09-12 8:06 ` Claudiu.Beznea
2022-09-06 13:55 ` [PATCH v2 13/13] dt-bindings: serial: atmel,at91-usart: Add gclk as a possible USART clock Sergiu Moga
2022-09-08 12:35 ` Krzysztof Kozlowski
2022-09-08 15:33 ` Sergiu.Moga
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=1662500460.128889.1224960.nullmailer@robh.at.kernel.org \
--to=robh@kernel.org \
--cc=admin@hifiphile.com \
--cc=alexandre.belloni@bootlin.com \
--cc=broonie@kernel.org \
--cc=claudiu.beznea@microchip.com \
--cc=devicetree@vger.kernel.org \
--cc=gregkh@linuxfoundation.org \
--cc=jirislaby@kernel.org \
--cc=kavyasree.kotagiri@microchip.com \
--cc=krzysztof.kozlowski+dt@linaro.org \
--cc=lee@kernel.org \
--cc=linux-arm-kernel@lists.infradead.org \
--cc=linux-clk@vger.kernel.org \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-serial@vger.kernel.org \
--cc=linux-spi@vger.kernel.org \
--cc=mturquette@baylibre.com \
--cc=nicolas.ferre@microchip.com \
--cc=radu_nicolae.pirea@upb.ro \
--cc=richard.genoud@gmail.com \
--cc=robh+dt@kernel.org \
--cc=sboyd@kernel.org \
--cc=sergiu.moga@microchip.com \
--cc=tudor.ambarus@microchip.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).