Patchwork housekeeping for: spi-devel-general

patchwork-bot+linux-spi
2020-05-22T23:00:18Z

Latest series: [v8] mtd: spi-nor: add xSPI Octal DTR support (2020-05-22T22:40:24)
Superseding: [v7] mtd: spi-nor: add xSPI Octal DTR support (2020-05-22T10:12:43):
[v7,01/20] spi: spi-mem: allow specifying whether an op is DTR or not
[v7,02/20] spi: spi-mem: allow specifying a command's extension
[v7,03/20] spi: atmel-quadspi: reject DTR ops
[v7,04/20] spi: spi-mtk-nor: reject DTR ops
[v7,05/20] spi: mxic: Avoid endianness problems with 2-byte opcodes
[v7,06/20] mtd: spi-nor: add support for DTR protocol
[v7,07/20] mtd: spi-nor: sfdp: default to addr_width of 3 for configurable widths
[v7,08/20] mtd: spi-nor: sfdp: prepare BFPT parsing for JESD216 rev D
[v7,09/20] mtd: spi-nor: sfdp: get command opcode extension type from BFPT
[v7,10/20] mtd: spi-nor: sfdp: parse xSPI Profile 1.0 table
[v7,11/20] mtd: spi-nor: core: use dummy cycle and address width info from SFDP
[v7,12/20] mtd: spi-nor: core: do 2 byte reads for SR and FSR in DTR mode
[v7,13/20] mtd: spi-nor: core: enable octal DTR mode when possible
[v7,14/20] mtd: spi-nor: sfdp: do not make invalid quad enable fatal
[v7,15/20] mtd: spi-nor: sfdp: detect Soft Reset sequence support from BFPT
[v7,16/20] mtd: spi-nor: core: perform a Soft Reset on shutdown
[v7,17/20] mtd: spi-nor: core: disable Octal DTR mode on suspend.
[v7,18/20] mtd: spi-nor: core: expose spi_nor_default_setup() in core.h
[v7,19/20] mtd: spi-nor: spansion: add support for Cypress Semper flash
[v7,20/20] mtd: spi-nor: micron-st: allow using MT35XU512ABA in Octal DTR mode

--
Deet-doot-dot, I am a bot.