Patchwork housekeeping for: spi-devel-general

patchwork-bot+linux-spi
2020-05-25T09:20:20Z

Latest series: [v9] mtd: spi-nor: add xSPI Octal DTR support (2020-05-25T09:15:26)
Superseding: [v8] mtd: spi-nor: add xSPI Octal DTR support (2020-05-22T22:40:24):
[v8,01/19] spi: spi-mem: allow specifying whether an op is DTR or not
[v8,02/19] spi: spi-mem: allow specifying a command's extension
[v8,03/19] spi: atmel-quadspi: reject DTR ops
[v8,04/19] spi: spi-mtk-nor: reject DTR ops
[v8,05/19] mtd: spi-nor: add support for DTR protocol
[v8,06/19] mtd: spi-nor: sfdp: default to addr_width of 3 for configurable widths
[v8,07/19] mtd: spi-nor: sfdp: prepare BFPT parsing for JESD216 rev D
[v8,08/19] mtd: spi-nor: sfdp: get command opcode extension type from BFPT
[v8,09/19] mtd: spi-nor: sfdp: parse xSPI Profile 1.0 table
[v8,10/19] mtd: spi-nor: core: use dummy cycle and address width info from SFDP
[v8,11/19] mtd: spi-nor: core: do 2 byte reads for SR and FSR in DTR mode
[v8,12/19] mtd: spi-nor: core: enable octal DTR mode when possible
[v8,13/19] mtd: spi-nor: sfdp: do not make invalid quad enable fatal
[v8,14/19] mtd: spi-nor: sfdp: detect Soft Reset sequence support from BFPT
[v8,15/19] mtd: spi-nor: core: perform a Soft Reset on shutdown
[v8,16/19] mtd: spi-nor: core: disable Octal DTR mode on suspend.
[v8,17/19] mtd: spi-nor: core: expose spi_nor_default_setup() in core.h
[v8,18/19] mtd: spi-nor: spansion: add support for Cypress Semper flash
[v8,19/19] mtd: spi-nor: micron-st: allow using MT35XU512ABA in Octal DTR mode

--
Deet-doot-dot, I am a bot.