From: Grant Likely <grant.likely-s3s/WqlpOiPyB63q8FvJNQ@public.gmane.org>
To: Jingoo Han <jg1.han-Sze3O3UU22JBDgjK7y7TUQ@public.gmane.org>
Cc: spi-devel-general-5NWGOfrQmneRv+LV9MX5uipxlwaOVQ5f@public.gmane.org,
'Jingoo Han' <jg1.han-Sze3O3UU22JBDgjK7y7TUQ@public.gmane.org>
Subject: Re: [PATCH] spi: s3c64xx: fix checkpatch warnings and error
Date: Tue, 05 Feb 2013 13:22:05 +0000 [thread overview]
Message-ID: <20130205132206.099D53E0E27@localhost> (raw)
In-Reply-To: <00a701cdff7b$b365dcb0$1a319610$%han-Sze3O3UU22JBDgjK7y7TUQ@public.gmane.org>
On Thu, 31 Jan 2013 15:25:01 +0900, Jingoo Han <jg1.han-Sze3O3UU22JBDgjK7y7TUQ@public.gmane.org> wrote:
> Fix checkpatch warnings and error as below:
> ERROR: "foo * bar" should be "foo *bar"
> WARNING: please, no space before tabs
> WARNING: quoted string split across lines
> WARNING: msleep < 20ms can sleep for up to 20ms; see Documentation/timers/timers-howto.txt
>
> Signed-off-by: Jingoo Han <jg1.han-Sze3O3UU22JBDgjK7y7TUQ@public.gmane.org>
Applied, thanks.
g.
> ---
> drivers/spi/spi-s3c64xx.c | 33 +++++++++++++--------------------
> 1 files changed, 13 insertions(+), 20 deletions(-)
>
> diff --git a/drivers/spi/spi-s3c64xx.c b/drivers/spi/spi-s3c64xx.c
> index 4dd7b7c..ae8ef6d 100644
> --- a/drivers/spi/spi-s3c64xx.c
> +++ b/drivers/spi/spi-s3c64xx.c
> @@ -62,7 +62,7 @@
> #define S3C64XX_SPI_CLKSEL_SRCMSK (3<<9)
> #define S3C64XX_SPI_CLKSEL_SRCSHFT 9
> #define S3C64XX_SPI_ENCLK_ENABLE (1<<8)
> -#define S3C64XX_SPI_PSR_MASK 0xff
> +#define S3C64XX_SPI_PSR_MASK 0xff
>
> #define S3C64XX_SPI_MODE_CH_TSZ_BYTE (0<<29)
> #define S3C64XX_SPI_MODE_CH_TSZ_HALFWORD (1<<29)
> @@ -743,8 +743,7 @@ static int s3c64xx_spi_transfer_one_message(struct spi_master *master,
> sdd->regs + S3C64XX_SPI_SLAVE_SEL);
>
> if (status) {
> - dev_err(&spi->dev, "I/O Error: "
> - "rx-%d tx-%d res:rx-%c tx-%c len-%d\n",
> + dev_err(&spi->dev, "I/O Error: rx-%d tx-%d res:rx-%c tx-%c len-%d\n",
> xfer->rx_buf ? 1 : 0, xfer->tx_buf ? 1 : 0,
> (sdd->state & RXBUSY) ? 'f' : 'p',
> (sdd->state & TXBUSY) ? 'f' : 'p',
> @@ -801,7 +800,7 @@ static int s3c64xx_spi_prepare_transfer(struct spi_master *spi)
>
> /* Acquire DMA channels */
> while (!acquire_dma(sdd))
> - msleep(10);
> + usleep_range(10000, 11000);
>
> pm_runtime_get_sync(&sdd->pdev->dev);
>
> @@ -843,16 +842,14 @@ static struct s3c64xx_spi_csinfo *s3c64xx_get_slave_ctrldata(
>
> cs = kzalloc(sizeof(*cs), GFP_KERNEL);
> if (!cs) {
> - dev_err(&spi->dev, "could not allocate memory for controller"
> - " data\n");
> + dev_err(&spi->dev, "could not allocate memory for controller data\n");
> of_node_put(data_np);
> return ERR_PTR(-ENOMEM);
> }
>
> cs->line = of_get_named_gpio(data_np, "cs-gpio", 0);
> if (!gpio_is_valid(cs->line)) {
> - dev_err(&spi->dev, "chip select gpio is not specified or "
> - "invalid\n");
> + dev_err(&spi->dev, "chip select gpio is not specified or invalid\n");
> kfree(cs);
> of_node_put(data_np);
> return ERR_PTR(-EINVAL);
> @@ -1078,8 +1075,8 @@ static int s3c64xx_spi_get_dmares(
> if (!sdd->pdev->dev.of_node) {
> res = platform_get_resource(pdev, IORESOURCE_DMA, tx ? 0 : 1);
> if (!res) {
> - dev_err(&pdev->dev, "Unable to get SPI-%s dma "
> - "resource\n", chan_str);
> + dev_err(&pdev->dev, "Unable to get SPI-%s dma resource\n",
> + chan_str);
> return -ENXIO;
> }
> dma_data->dmach = res->start;
> @@ -1135,8 +1132,7 @@ static void s3c64xx_spi_dt_gpio_free(struct s3c64xx_spi_driver_data *sdd)
> gpio_free(sdd->gpios[idx]);
> }
>
> -static struct s3c64xx_spi_info * s3c64xx_spi_parse_dt(
> - struct device *dev)
> +static struct s3c64xx_spi_info *s3c64xx_spi_parse_dt(struct device *dev)
> {
> struct s3c64xx_spi_info *sci;
> u32 temp;
> @@ -1148,16 +1144,14 @@ static struct s3c64xx_spi_info * s3c64xx_spi_parse_dt(
> }
>
> if (of_property_read_u32(dev->of_node, "samsung,spi-src-clk", &temp)) {
> - dev_warn(dev, "spi bus clock parent not specified, using "
> - "clock at index 0 as parent\n");
> + dev_warn(dev, "spi bus clock parent not specified, using clock at index 0 as parent\n");
> sci->src_clk_nr = 0;
> } else {
> sci->src_clk_nr = temp;
> }
>
> if (of_property_read_u32(dev->of_node, "num-cs", &temp)) {
> - dev_warn(dev, "number of chip select lines not specified, "
> - "assuming 1 chip select line\n");
> + dev_warn(dev, "number of chip select lines not specified, assuming 1 chip select line\n");
> sci->num_cs = 1;
> } else {
> sci->num_cs = temp;
> @@ -1247,8 +1241,8 @@ static int __init s3c64xx_spi_probe(struct platform_device *pdev)
> if (pdev->dev.of_node) {
> ret = of_alias_get_id(pdev->dev.of_node, "spi");
> if (ret < 0) {
> - dev_err(&pdev->dev, "failed to get alias id, "
> - "errno %d\n", ret);
> + dev_err(&pdev->dev, "failed to get alias id, errno %d\n",
> + ret);
> goto err0;
> }
> sdd->port_id = ret;
> @@ -1347,8 +1341,7 @@ static int __init s3c64xx_spi_probe(struct platform_device *pdev)
> goto err8;
> }
>
> - dev_dbg(&pdev->dev, "Samsung SoC SPI Driver loaded for Bus SPI-%d "
> - "with %d Slaves attached\n",
> + dev_dbg(&pdev->dev, "Samsung SoC SPI Driver loaded for Bus SPI-%d with %d Slaves attached\n",
> sdd->port_id, master->num_chipselect);
> dev_dbg(&pdev->dev, "\tIOmem=[0x%x-0x%x]\tDMA=[Rx-%d, Tx-%d]\n",
> mem_res->end, mem_res->start,
> --
> 1.7.2.5
>
>
--
Grant Likely, B.Sc, P.Eng.
Secret Lab Technologies, Ltd.
------------------------------------------------------------------------------
Free Next-Gen Firewall Hardware Offer
Buy your Sophos next-gen firewall before the end March 2013
and get the hardware for free! Learn more.
http://p.sf.net/sfu/sophos-d2d-feb
prev parent reply other threads:[~2013-02-05 13:22 UTC|newest]
Thread overview: 2+ messages / expand[flat|nested] mbox.gz Atom feed top
2013-01-31 6:25 [PATCH] spi: s3c64xx: fix checkpatch warnings and error Jingoo Han
[not found] ` <00a701cdff7b$b365dcb0$1a319610$%han-Sze3O3UU22JBDgjK7y7TUQ@public.gmane.org>
2013-02-05 13:22 ` Grant Likely [this message]
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20130205132206.099D53E0E27@localhost \
--to=grant.likely-s3s/wqlpoipyb63q8fvjnq@public.gmane.org \
--cc=jg1.han-Sze3O3UU22JBDgjK7y7TUQ@public.gmane.org \
--cc=spi-devel-general-5NWGOfrQmneRv+LV9MX5uipxlwaOVQ5f@public.gmane.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).