From: Anton Vorontsov <anton@enomsg.org>
To: Andreas Larsson <andreas@gaisler.com>
Cc: Grant Likely <grant.likely@secretlab.ca>,
Mark Brown <broonie@opensource.wolfsonmicro.com>,
spi-devel-general@lists.sourceforge.net,
Mingkai Hu <Mingkai.hu@freescale.com>,
Joakim Tjernlund <Joakim.Tjernlund@transmode.se>,
Kumar Gala <galak@kernel.crashing.org>,
Peter Korsgaard <jacmet@sunsite.dk>,
linux-kernel@vger.kernel.org, software@gaisler.com
Subject: Re: [PATCH v2 7/7] spi: spi-fsl-spi: Add support for gpio chipselects for GRLIB type cores
Date: Thu, 7 Feb 2013 08:08:21 -0800 [thread overview]
Message-ID: <20130207160821.GA22224@lizard.gateway.2wire.net> (raw)
In-Reply-To: <1360242731-13700-8-git-send-email-andreas@gaisler.com>
On Thu, Feb 07, 2013 at 02:12:11PM +0100, Andreas Larsson wrote:
> This relies upon of_spi_register_master to find out which gpios to use.
>
> Signed-off-by: Andreas Larsson <andreas@gaisler.com>
> ---
> drivers/spi/spi-fsl-lib.h | 1 +
> drivers/spi/spi-fsl-spi.c | 53 +++++++++++++++++++++++++++++++++++++++-----
> 2 files changed, 48 insertions(+), 6 deletions(-)
Just a couple of minor nits...
> diff --git a/drivers/spi/spi-fsl-lib.h b/drivers/spi/spi-fsl-lib.h
> index d5c788b..52db693 100644
> --- a/drivers/spi/spi-fsl-lib.h
> +++ b/drivers/spi/spi-fsl-lib.h
> @@ -71,6 +71,7 @@ struct mpc8xxx_spi {
>
> #ifdef CONFIG_SPI_FSL_SPI
> int type;
> + int native_chipselects;
> u8 max_bits_per_word;
>
> void (*set_shifts)(u32 *rx_shift, u32 *tx_shift,
> diff --git a/drivers/spi/spi-fsl-spi.c b/drivers/spi/spi-fsl-spi.c
> index 55652e6..2befe16 100644
> --- a/drivers/spi/spi-fsl-spi.c
> +++ b/drivers/spi/spi-fsl-spi.c
> @@ -418,7 +418,7 @@ static int fsl_spi_setup(struct spi_device *spi)
> {
> struct mpc8xxx_spi *mpc8xxx_spi;
> struct fsl_spi_reg *reg_base;
> - int retval;
> + int retval, desel;
We don't usually place variable declarations on the same line, unless the
variables are closely related.
> u32 hw_mode;
> struct spi_mpc8xxx_cs *cs = spi->controller_state;
>
> @@ -456,12 +456,45 @@ static int fsl_spi_setup(struct spi_device *spi)
> return retval;
> }
>
> + if (mpc8xxx_spi->type == TYPE_GRLIB) {
> + if (gpio_is_valid(spi->cs_gpio)) {
<- You can place the 'int desel;' here, limiting the visibility for it.
> + retval = gpio_request(spi->cs_gpio,
> + dev_name(&spi->dev));
> + if (retval)
> + return retval;
> +
> + desel = !(spi->mode & SPI_CS_HIGH);
> + desel ^= !!(spi->cs_gpio_flags & OF_GPIO_ACTIVE_LOW);
> + retval = gpio_direction_output(spi->cs_gpio, desel);
> + if (retval) {
> + gpio_free(spi->cs_gpio);
> + return retval;
> + }
Thanks,
Anton
next prev parent reply other threads:[~2013-02-07 16:08 UTC|newest]
Thread overview: 13+ messages / expand[flat|nested] mbox.gz Atom feed top
2013-02-07 13:12 [PATCH v2 0/7] spi: spi-fsl-spi: Make spi-fsl-spi usable in cpu mode outside of FSL SOC environments and add a grlib variant normally running on sparc Andreas Larsson
2013-02-07 13:12 ` [PATCH v2 3/7] spi: spi-fsl-spi: Move setting non-zero tx and rx shifts to a function accessed by a function pointer Andreas Larsson
[not found] ` <1360242731-13700-1-git-send-email-andreas-FkzTOoA/JUlBDgjK7y7TUQ@public.gmane.org>
2013-02-07 13:12 ` [PATCH v2 1/7] spi: spi-fsl-spi: Make driver usable in CPU mode outside of an FSL_SOC environment Andreas Larsson
2013-02-07 13:12 ` [PATCH v2 2/7] spi: spi-fsl-spi: Make sure in spi_fsl_setup that chipselect becomes inactive Andreas Larsson
2013-02-07 13:12 ` [PATCH v2 4/7] spi: spi-fsl-spi: Introduce a type for the driver Andreas Larsson
2013-02-07 13:12 ` [PATCH v2 5/7] spi: spi-fsl-spi: Add support for setting a maximum number of bits per word Andreas Larsson
2013-02-07 13:12 ` [PATCH v2 6/7] spi: spi-fsl-spi: Add support for Aeroflex Gaisler GRLIB cores normally running on SPARC Andreas Larsson
2013-02-07 13:12 ` [PATCH v2 7/7] spi: spi-fsl-spi: Add support for gpio chipselects for GRLIB type cores Andreas Larsson
2013-02-07 16:08 ` Anton Vorontsov [this message]
[not found] ` <20130207160821.GA22224-1CZZkhFgUWNRmOO2HpYVOJIbA5emDH3N@public.gmane.org>
2013-02-08 7:46 ` Andreas Larsson
2013-03-02 21:34 ` Grant Likely
2013-02-07 13:38 ` [PATCH v2 4/7 RESEND] spi: spi-fsl-spi: Introduce a type for the driver Andreas Larsson
2013-02-07 16:08 ` [PATCH v2 0/7] spi: spi-fsl-spi: Make spi-fsl-spi usable in cpu mode outside of FSL SOC environments and add a grlib variant normally running on sparc Anton Vorontsov
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20130207160821.GA22224@lizard.gateway.2wire.net \
--to=anton@enomsg.org \
--cc=Joakim.Tjernlund@transmode.se \
--cc=Mingkai.hu@freescale.com \
--cc=andreas@gaisler.com \
--cc=broonie@opensource.wolfsonmicro.com \
--cc=galak@kernel.crashing.org \
--cc=grant.likely@secretlab.ca \
--cc=jacmet@sunsite.dk \
--cc=linux-kernel@vger.kernel.org \
--cc=software@gaisler.com \
--cc=spi-devel-general@lists.sourceforge.net \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).