[PATCH 3/9] spi: bcm2835aux: setup gpio-cs to output and correct level during setup

[kernel-TqfNSX0MhmxHKSADF0wUEw@public.gmane.org]

From: Martin Sperl <kernel-TqfNSX0MhmxHKSADF0wUEw@public.gmane.org>

Setup gpio-cs to the correct levels during setup and also make the
gpio definitely an output GPIO.

This is transparently fixing some badly configured DTs in the process
where cs-gpio is set but the gpios are still configured with native cs.

It also makes 100% sure that the initial CS levels are as expected -
especially on systems with devices on a bus with mixed CS_HIGH/CS_LOW
settings.

Fixes: 1ea29b39f4c812ece2f936065a0a3d6fe44a263e
Signed-off-by: Martin Sperl <kernel-TqfNSX0MhmxHKSADF0wUEw@public.gmane.org>
---
 drivers/spi/spi-bcm2835aux.c | 12 +++++++++++-
 1 file changed, 11 insertions(+), 1 deletion(-)

diff --git a/drivers/spi/spi-bcm2835aux.c b/drivers/spi/spi-bcm2835aux.c
index 4b6fdcb2cf4b..922fd798508e 100644
--- a/drivers/spi/spi-bcm2835aux.c
+++ b/drivers/spi/spi-bcm2835aux.c
@@ -449,7 +449,17 @@ static int bcm2835aux_spi_setup(struct spi_device *spi)
 		return -EINVAL;
 	}

-	return 0;
+	/* with gpio-cs set the GPIO to the correct level
+	 * and as output (in case the dt has the gpio not configured
+	 * as output but native cs)
+	 */
+	ret = gpio_direction_output(spi->cs_gpio,
+				    (spi->mode & SPI_CS_HIGH) ? 0 : 1);
+	if (ret)
+		dev_err(&spi->dev, "could not set gpio %i as output: %i\n",
+			spi->cs_gpio, ret);
+
+	return ret;
 }

 static int bcm2835aux_spi_probe(struct platform_device *pdev)
--
2.11.0