From mboxrd@z Thu Jan 1 00:00:00 1970 From: Gregory CLEMENT Subject: [PATCH] spi: Fix SPI_CS_HIGH setting when using native and GPIO CS Date: Fri, 18 Oct 2019 17:29:29 +0200 Message-ID: <20191018152929.3287-1-gregory.clement@bootlin.com> Mime-Version: 1.0 Content-Transfer-Encoding: 8bit Cc: Nicolas Ferre , Alexandre Belloni , Ludovic Desroches , linux-arm-kernel@lists.infradead.org, Thomas Petazzoni , Gregory CLEMENT , stable@vger.kernel.org To: Mark Brown , linux-spi@vger.kernel.org, linux-kernel@vger.kernel.org Return-path: Sender: linux-kernel-owner@vger.kernel.org List-Id: linux-spi.vger.kernel.org When improving the CS GPIO support at core level, the SPI_CS_HIGH has been enabled for all the CS lines used for a given SPI controller. However, the SPI framework allows to have on the same controller native CS and GPIO CS. The native CS may not support the SPI_CS_HIGH, so they should not be setup automatically. With this patch the setting is done only for the CS that will use a GPIO as CS Fixes: f3186dd87669 ("spi: Optionally use GPIO descriptors for CS GPIOs") Cc: Signed-off-by: Gregory CLEMENT --- drivers/spi/spi.c | 18 +++++++++--------- 1 file changed, 9 insertions(+), 9 deletions(-) diff --git a/drivers/spi/spi.c b/drivers/spi/spi.c index 5414a10afd65..1b68acc28c8f 100644 --- a/drivers/spi/spi.c +++ b/drivers/spi/spi.c @@ -1880,15 +1880,7 @@ static int of_spi_parse_dt(struct spi_controller *ctlr, struct spi_device *spi, spi->mode |= SPI_3WIRE; if (of_property_read_bool(nc, "spi-lsb-first")) spi->mode |= SPI_LSB_FIRST; - - /* - * For descriptors associated with the device, polarity inversion is - * handled in the gpiolib, so all chip selects are "active high" in - * the logical sense, the gpiolib will invert the line if need be. - */ - if (ctlr->use_gpio_descriptors) - spi->mode |= SPI_CS_HIGH; - else if (of_property_read_bool(nc, "spi-cs-high")) + if (of_property_read_bool(nc, "spi-cs-high")) spi->mode |= SPI_CS_HIGH; /* Device DUAL/QUAD mode */ @@ -1952,6 +1944,14 @@ static int of_spi_parse_dt(struct spi_controller *ctlr, struct spi_device *spi, } spi->chip_select = value; + /* + * For descriptors associated with the device, polarity inversion is + * handled in the gpiolib, so all gpio chip selects are "active high" + * in the logical sense, the gpiolib will invert the line if need be. + */ + if ((ctlr->use_gpio_descriptors) && ctlr->cs_gpiods[spi->chip_select]) + spi->mode |= SPI_CS_HIGH; + /* Device speed */ rc = of_property_read_u32(nc, "spi-max-frequency", &value); if (rc) { -- 2.23.0