Re: [PATCH v2 0/2] Add support for Intel Thunder Bay SPI

[Serge Semin <fancer.lancer@gmail.com>]

Hello Nandhini

On Tue, Aug 24, 2021 at 04:58:54PM +0800, nandhini.srikandan@intel.com wrote:
> From: Nandhini Srikandan <nandhini.srikandan@intel.com>
> 
> Hi,
> 
> This patch set enables support for Designware SPI on the Intel Thunder Bay SoC.
> 
> Patch 1: SPI DT bindings for Intel Thunder Bay SoC.
> Patch 2: Adds support for Designware SPI on Intel Thunderbay SoC.
> 
> The driver is tested on Keem Bay and Thunder Bay evaluation board
> 
> Changes from v1:
> 1) Designware CR0 specific macros are named in a generic way.
> 2) SPI CAP macros are named in generic way rather than naming project specific.
> 3) SPI KEEM BAY specific macros are replaced by generic macros.
> 4) Resued the existing SPI deassert API instead of adding another reset

Thanks for the update. I'll have a look at the series on the next
week.

Regards,
-Sergey

> 
> Thanks & Regards,
> Nandhini
> 
> Nandhini Srikandan (2):
>   dt-bindings: spi: Add bindings for Intel Thunder Bay SoC
>   spi: dw: Add support for Intel Thunder Bay SPI
> 
>  .../bindings/spi/snps,dw-apb-ssi.yaml         |  2 ++
>  drivers/spi/spi-dw-core.c                     |  7 +++++--
>  drivers/spi/spi-dw-mmio.c                     | 20 ++++++++++++++++++-
>  drivers/spi/spi-dw.h                          | 12 ++++++++---
>  4 files changed, 35 insertions(+), 6 deletions(-)
> 
> -- 
> 2.17.1
>