[PATCH 1/6] dt-bindings: spi: Add spi-buses property

[David Lechner <dlechner@baylibre.com>]

Add a spi-buses property to the spi-peripheral-props binding to allow
specifying the SPI data bus or buses that a peripheral is connected to
in cases where the SPI controller has more than one physical SPI data
bus.

Signed-off-by: David Lechner <dlechner@baylibre.com>
---

This patch has been seen before in a different series from Sean [1].

[1]: https://lore.kernel.org/linux-spi/20250616220054.3968946-2-sean.anderson@linux.dev/

Changes:
* Added maxItems. (8 is the most I've seen so far on an ADC)
* Tweaked the description a bit.
---
 .../devicetree/bindings/spi/spi-peripheral-props.yaml         | 11 +++++++++++
 1 file changed, 11 insertions(+)

diff --git a/Documentation/devicetree/bindings/spi/spi-peripheral-props.yaml b/Documentation/devicetree/bindings/spi/spi-peripheral-props.yaml
index 8b6e8fc009dbdc80978f3afef84ddc688ade4348..91c9de3ae10bbad76cd4f57d0789b1161ebc7a18 100644
--- a/Documentation/devicetree/bindings/spi/spi-peripheral-props.yaml
+++ b/Documentation/devicetree/bindings/spi/spi-peripheral-props.yaml
@@ -89,6 +89,17 @@ properties:
     description:
       Delay, in microseconds, after a write transfer.
 
+  spi-buses:
+    description:
+      Array of bus numbers that describes which SPI buses of the controller are
+      connected to the peripheral. This only applies to peripherals connected
+      to specialized SPI controllers that have multiple SPI buses (each with
+      its own serializer) on a single controller.
+    $ref: /schemas/types.yaml#/definitions/uint32-array
+    minItems: 1
+    maxItems: 8
+    default: [0]
+
   stacked-memories:
     description: Several SPI memories can be wired in stacked mode.
       This basically means that either a device features several chip

-- 
2.43.0