messages from 2015-03-17 12:31:48 to 2015-04-01 15:14:07 UTC [more...]
[PATCH 5/6] spi: bcm2835: add polling mode for transfers below 30us
2015-04-01 15:14 UTC (5+ messages)
[PATCH] spi: imx: read back the RX/TX watermark levels earlier
2015-04-01 8:46 UTC
Using gpio_keys with regmapped gpio?
2015-03-31 21:06 UTC (4+ messages)
[PATCH v5] spi: Add SPI driver for Mikrotik RB4xx series boards
2015-03-31 20:59 UTC
[PATCH] spi: bitbang: only toggle bitchanges
2015-03-31 20:23 UTC (7+ messages)
` [PATCH v2] "
[PATCH v2 0/2] spi: fsl-dspi (vf610) clock fixes
2015-03-31 19:14 UTC (6+ messages)
` [PATCH v2 1/2] spi: fsl-dspi: Fix clock rate scale values
` [PATCH v2 2/2] spi: fsl-dspi: Add ~50ns delay between cs and sck
[PATCH v4] spi: Add SPI driver for Mikrotik RB4xx series boards
2015-03-31 18:41 UTC (3+ messages)
[PATCH v3] spi: Add SPI driver for Mikrotik RB4xx series boards
2015-03-31 15:00 UTC (2+ messages)
[PATCH] SPI: BCM2835: fix all checkpath --strict messages
2015-03-31 14:49 UTC (38+ messages)
` [PATCH V2] SPI: BCM2835: allow arbitrary GPIO to act as SPI-chip_select
` [PATCH V2 - RESEND] "
` [PATCH] SPI: bcm2835: move to the transfer_one driver model
` [PATCH] SPI: BCM2835: clock divider can be a multiple of 2
` [PATCH] SPI: BCM2835: enable support of 3-wire mode
` [PATCH V2] SPI: BCM2835: fix all checkpath --strict messages
[PATCH v2 0/1] spi: Add driver for Routerboard RB4xx boards
2015-03-31 14:22 UTC (5+ messages)
` [PATCH v2 1/1] spi: Add SPI driver for Mikrotik RB4xx series boards
[PATCH v2 1/1] spi: pxa2xx: missing break in pxa2xx_ssp_get_clk_div()
2015-03-31 14:05 UTC (3+ messages)
[PATCH] spi: xilinx: Use standard num-cs binding
2015-03-31 12:24 UTC (10+ messages)
[patch] spi: pxa2xx: missing break in pxa2xx_ssp_get_clk_div()
2015-03-31 8:49 UTC (3+ messages)
spi-altera in mainline
2015-03-31 7:43 UTC
[PATCH/RFC 6/6] spi: bcm2835: set gpio-cs to high state prior to any
2015-03-31 5:56 UTC (5+ messages)
[PATCH 3/6] spi: bcm2835: fill FIFO before enabling interrupts to
2015-03-31 5:51 UTC (5+ messages)
[PATCH v3 0/1] spi: Using Trigger number to transmit/receive data
2015-03-31 5:24 UTC (4+ messages)
` [PATCH v3 1/1] "
[PATCH 4/6] spi: bcm2835: warn about native-chip-selects being used
2015-03-31 3:23 UTC (5+ messages)
[PATCH 1/6] spi: bcm2835: remove dependency on handle_err which is
2015-03-31 3:13 UTC (5+ messages)
[PATCH 2/6] spi: bcm2835: fix code formatting issue
2015-03-29 16:52 UTC (2+ messages)
[PATCH 0/6] spi: bcm2835: collection of driver-optimizations
2015-03-29 14:03 UTC
spi: bcm2835: strange observation with cs_gpios low after reboot
2015-03-28 12:12 UTC
[PATCH 0/2] spi: fsl-dspi (vf610) clock fixes
2015-03-28 2:33 UTC (4+ messages)
` [PATCH 1/2] spi: fsl-dspi: Fix clock rate scale values
` [PATCH 2/2] spi: fsl-dspi: Add ~50ns delay between cs and sck
[PATCH] spi: spidev: Warn loudly if instantiated from DT as "spidev"
2015-03-27 23:42 UTC
[PATCH 1/2] spi/rockchip: Round up clock rate divisor to err on the safe side
2015-03-27 0:46 UTC (5+ messages)
` [PATCH 2/2] spi/rockchip: Add device tree property to configure Rx Sample Delay
[RFC 4/6] spi: atmel: use atmel_io.h to provide on-chip IO
2015-03-26 16:01 UTC (6+ messages)
[PATCH 0/2] spi: Add driver for Routerboard RB4xx boards
2015-03-25 21:45 UTC (10+ messages)
` [PATCH 1/2] spi: Add SPI driver for Mikrotik RB4xx series boards
` [PATCH 2/2] spi: Add driver for the CPLD chip on Mikrotik RB4xx boards
[RESEND PATCH] spi: of: do explicitly request modules for of-registered devices
2015-03-25 21:36 UTC (2+ messages)
[PATCH 1/1] spi: dw: fix crash on setup stage
2015-03-25 18:54 UTC (2+ messages)
[PATCH v2 1/1] spi: pxa2xx: replace ugly table by approximation
2015-03-25 15:31 UTC (2+ messages)
[PATCH v1 0/2] spi: pxa2xx: allow to set mostly any baudrate for Quark case
2015-03-25 15:28 UTC (11+ messages)
` [PATCH v1 1/2] spi: pxa2xx: shift clk_div in one place
` [PATCH v1 2/2] spi: pxa2xx: replace ugly table by approximation
[GIT PULL] spi fixes for v4.0
2015-03-24 21:07 UTC
[PATCH 2/3] spidev: Add DT binding example
2015-03-24 10:50 UTC
[PATCH] spi: spidev: fix possible arithmetic overflow for multi-transfer message
2015-03-23 21:01 UTC (4+ messages)
[PATCH] spi: bcm2835: fill/drain SPI-fifo as much as possible during interrupt
2015-03-23 18:49 UTC (2+ messages)
[PATCH 1/2] spi: pxa2xx: Remove needless includes
2015-03-23 16:43 UTC (3+ messages)
` [PATCH 2/2] spi: omap-uwire: Remove needless include asm/irq.h
spi: spidev: only use up TX/RX bounce buffer space when needed
2015-03-23 15:53 UTC (2+ messages)
[PATCH 09/13] spi: atmel: use endian agnostic IO
2015-03-22 18:01 UTC (4+ messages)
Patch to parameterize DMA_MIN_BYTES for omap2-mcspi
2015-03-22 16:31 UTC (11+ messages)
[PATCH v2] spi: Ensure that CS line is in non-active state after spi_setup()
2015-03-20 16:17 UTC (3+ messages)
[RESEND_2 PATCH 1/3] ARM: sun4i: spi: Allow transfers larger than FIFO size
2015-03-20 7:11 UTC (2+ messages)
[PATCH] spi: trigger trace event for message-done before mesg->complete
2015-03-19 11:51 UTC (8+ messages)
[PATCH/RFC] spi: sh-msiof: Fix MSIOF address for DMAC
2015-03-19 6:52 UTC (3+ messages)
[PATCH] spi: fsl-spi: use of_iomap() to map parameter ram on CPM1
2015-03-18 12:03 UTC (6+ messages)
[PATCH] spi: sh-msiof: Fix limit maximum word transfer size of FIFO size
2015-03-18 10:51 UTC (6+ messages)
[PATCH v3 0/7] spi: dw: make DMA working
2015-03-17 12:31 UTC (3+ messages)
` [PATCH v3 7/7] dmaengine: intel-mid-dma: remove the driver
page: next (older) | prev (newer) | latest
- recent:[subjects (threaded)|topics (new)|topics (active)]
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).